强度

The number and intensity of peaks of the thermoluminescent cutves are obviously related to stages of gold mineralization:the curve of the early barren quartz shows nearly Symmetric pattern; that of the major stage auriferous quartz is of multimodal type; the curve of the late quartz, low in gold, is marked by unimodal--bimodal type with rather intense luminescence.

石英热发光曲线的发光峰的数量和强度与金成矿阶段有着明显的关系：早期成矿阶段结晶的基本不含金石英，热发光曲线常为近对称的单峰型，发光强度较大；主成矿阶段形成的含金石英，热发光曲线为多峰型，常具最大的发光强度；晚期成矿阶段生成的含金性较差的右英，热发光曲线呈单峰-双峰型，发光强度亦较大。

Was investigated.The result shows that for thin plates,The strength of the plates decrease and the plasticity increase with anneal temperatare rising,while thick plates is not so sensitive to anneal temperature.The variation of heat-treatment parametar has less effect on the microstructure of TA15 plate.Thin plates have higher strength and lower plasticity longitudinally and transversally, and lower strength ...

结果表明，对于薄板而言提高退火温度材料强度降低、塑性提高，而对厚板这种现象不明显；热处理参数的变化对TA15合金板材的显微组织影响不大；薄板沿纵向和横向强度值较高，塑性值偏低，而45°方向强度值偏低，塑性较好；厚板横向强度值较纵向、45°方向的要高。

The results showed that the adhesion between rubber and steel cord increased under unaged,hot air aging or brine aging conditions as the level of cobalt ...

结果表明，随着钴盐用量的增大，在未老化、热空气老化及盐水老化条件下，胶料与钢丝的粘合强度有所提高；在湿热老化条件下，粘合强度由于热量和湿气的交互作用而发生较大幅度的下降，但钴盐用量在10份时粘合强度的下降为最小。综合胶料初始和老化后的应力应变性能和粘合强度，以10份钴盐用量为最佳。

Thirdly, with the modified Gurson model of the MARC finite element method soft, the damage behave of the welded joint was simulated. It was found that in the undermatched welded joint, the damage mainly happened in the soft weld line and with the decrease of the weld line抯 width, the damage抯 development was faster. As for the overmatched welded joint, the results showed that the damage mainly happened in the soft base metal and with the increase of the weld line抯 width, the damage抯 development was faster. While the width of the weld line was narrower than three millimeters, the high strength weld line could improve the anti-damage capability of the overmatched welded joint.

通过计算发现在低匹配的焊接接头中，损伤主要发生在低强度的焊缝中，并且焊缝宽度越小，焊接接头的损伤就越严重；而在高匹配的焊接接头中，损伤主要发生在紧临焊缝的强度较低的母材上，随高强度焊缝宽度的增加，焊接接头的损伤发展程度加剧，当焊缝宽度小于3mm时，高强度焊缝的加入对焊接接头能起一个强化的作用，提高了焊接接头的抗损伤能力。

In the design, we should note two things: It is a wine of surface material and the adhesive strength between the inner layer material is lower than the label adhesive strength; second label wine of the tear strength is higher than the surface material The tear strength, its purpose is to easy to damage when in open box Diaobao Cartoning.

在设计时，我们应注意两点：是一酒盒表层材料与内层材料之间的粘合强度要低于标签的粘合强度；二是标签的抗撕裂强度要高于酒盒表层材料的抗撕裂强度，其目的是为了易于在开盒时破坏掉包装盒。

The residual stress σ〓 in the weld center is always as high as the yield strength σ〓 for both the strength undermatching and overmatching when the yield strengthσ〓 is lower.

母材屈服强度σ〓较低时，如低碳钢，低强匹配（焊缝屈服强度σ〓＜母材屈服强度σ〓）和高强匹配时焊缝中心纵向残余应力σ〓均能达到焊缝屈服强度σ〓。

The result shows that the equalmatching characteristic of 10Ni5CrMoV steel welded joint is prominent.The probability of equalmatching is 48.11%,as well as,that of undermatching and overmatching are 47.55% and 4.34%,respectively.The mean-value of strength matching coefficient is nearly higher than its lower ...

计算结果表明，10N i5CrMoV钢焊接接头的等强匹配特征明显，等强匹配概率为48.11%，低强失配和超强失配概率分别为47.55%和4.34%；强度匹配系数均值偏下限，为0.955；由于母材强度数据的标准差比焊缝要大，约为1.54倍，从而使得强度匹配系数离散度较大；此外，焊接接头强度匹配系数小于0.86的概率为2.96%，可能会导致焊接接头产生冷裂纹。

The influence of recessing in adh es ive layer with high elastic modulus on the peak stress of joint is not evident so that it would improve the actual strength of joint markedly based on the load bearing ability not being affected evidenly . On the other hand , the recessing in the joint with low elastic modulus adh es ive caus es the peak stress es increase evidently that may decrease the nominal and actual strength of the joint markedly .

对胶层和被粘物中应力分布的数值分析结果表明：胶层中的间隙对接头端部的应力分布无明显影响，但对间隙附近的应力峰值影响较大；随着胶粘剂弹性模量的增大，间隙附近的应力峰值有所降低；对于高弹性模量胶粘剂接头，胶层中的间隙对接头的应力峰值无明显影响，在不降低接头名义强度的同时可使得接头的实际强度显著提高；而对于低弹性模量胶粘剂接头，间隙使得接头上的应力峰值明显上升，可能导致接头的名义强度和实际强度显著降低。

The Somali jet is rapidly enhanced two pentads prior to the onset of SCSSM, thus accelerating the eastward extension of the westerly over the Bay of Bengal and leading to the eastward retreat of the western Pacific subtropical high . At the same time, the rapid enhancement of SCS CEF can also result in the northward march of WPSH and the onset of SCSSM. The earlier establishment and stronger southerlies correspond to the earlier onset time of SCSSM, and vice versa. Both composite and correlation analyses show that the 150hPa Asia-Australia CEF in boreal spring has important influences on EASM.

相关分析和合成分析的结果还显示，春季150hPa亚澳越赤道气流对东亚夏季风有重要影响：当春季该气流偏弱时，北半球夏季西太平洋副高强度偏强，位置偏南偏西，南亚高压强度也偏强，这样的环流背景使江淮流域6—7月降水偏多，华南华北降水偏少；反之，当春季该气流偏强时，夏季西太副高强度偏弱，位置偏北偏东，南亚高压强度也偏弱，江淮流域夏季降水偏少，华南华北降水偏多。

Through comprehensive comparison,during the growth from 1 age-degree bamboo to 2 age-degree bamboo,density, mechanical strength(except maximum tensile strength etc.),fraction of bundle sheath,cell wall ratio,crystallinity,cellulose content and lignin content increase rate are the greatest.3age-degree bamboo has higher strength,strength and gravity ratio andcrystallinity are the biggest,fraction of parenchyma is small and insect-resistant.2 degree bamboo has the greatest mechanical strength,but its strength andgravity ratio is not the highest and its crystallinity is lower than 3 age-degreebamboo due to its greatest fraction of parenchyma,loss tangent value is thebiggest.Its creep character is not good and is easily eaten by moth.

通过综合比较，竹材从1度竹到2度竹生长过程中，密度、力学强度、纤维束比量、胞壁率、结晶度、纤维素含量、木质素含量等指标增加幅度是最大的。3度竹强度较高，强重比、结晶度最高，薄壁组织含量较小，相对抗虫蛀，材质最好，适合材用。4度竹结晶度下降引起强度的下降，但薄壁组织组织比量最小，相对最抗虫蛀。2度竹力学强度最大，但是强重比并不是最大，结晶度比3度竹低，由于薄壁组织组织比量最大，内耗值最大，蠕变性能较差，同时相对易遭虫蛀。

Cynanchum Lingtai apricot production in the average weight 65 grams, the brightly-colored fruit, juicy rich, sweet-sour taste, sweet from the nucleolus, when the late Qing Dynasty famous Shaanxi, Gansu provinces, the Qing imperial court Tongzhi tribute for years.

灵台生产的牛心杏平均单果重65克，果实色泽鲜艳，汁多味浓，甜酸适口，离核仁甜，清末时就驰名陕、甘两省，清同治年间曾为朝廷贡品。

Chenopodium album,Solanum nigrum, and Amaranthus retroflexus were very susceptible to the herbicides. Polygonum persicaria and Abutilon theophrasti were relatively less susceptible to the herbicides, and Lycopersicon esculentum was not susceptible to it. The relationship between reduction rates of weed biomass and PPM values of weed leaves 2,4, and 6 days after treatment was established.

供试的6种杂草对该混剂的敏感性存在显著差异：红心藜Chenopodium album、龙葵Solanum nigrum和反枝苋Amaranthus retroflexus对该混剂最敏感，ED90值分别为47.65、71.67和29.17g/hm2；春蓼Polygonum persicaria和苘麻Abutilon theophrasti敏感，ED90值分别为96.91、114.20g/hm2；而番茄不敏感。