查询词典 hard by

The results show that the microstructures of these three kinds of coating are different from those of the matrix (20 steel). The wear resistance of the flame spray coating is 4. 9 times that of the matrix. This is caused by the existance of hard noncrystal microparticals. The wear resistance of the coating by flame spray welding is 6. 3 times that of the matrix. The reason is that the fine crystal grains can be formed and the solution strengthening, dispersion hardening can be induced by these alloy elements. The resistance of the laser remelt coating is 8. 8 times that of the matrix. This is due to the solution strengthening, dispersion hardening and the existence of very hard dendritic crystal, eutectic and martensite in the microstructure.

作者指出，喷涂层由于层内有一定数量高硬度的合金非晶质点存在，其耐磨性是钢基体的4.9倍；喷熔层内合金晶化产生的晶粒细小，合金元素能起固溶强化作用，也能生成化合物产生弥散硬化作用，故此耐磨性是钢基体的6.3倍；激光涂敷层除所含合金元素产生的固溶强化和弥散硬化作用外，表层组织为高硬度的枝晶+共晶和马氏体，故其耐磨性是钢基体的8.8倍。

Results demonstrate that climate fluctuations recorded by the two boreholes correspond to the marine oxygen isotope stages. Thick layer of coarser grained fluvial deposits and the third layer of "hard mud" were deposited in the study area during MIS 6, reflecting a cold climate. The sediments became fine-grained and indicate a coastal marsh depositional environment during MIS 5. The second layer of "hard mud" was deposited during MIS 4. Fine-grained coastal marsh deposits dominated in the study area during early MIS 3, while lagoon-beach ridges prevailed during middle and late MIS 3, forming a layer of silt and fine sand in the coastal plain. The MIS 2 strata are composed of a typical sedimentary sequence with coarse grain in the lower section and fine grain in the upper section, i. e. yellowish grey or brownish yellow silt and brownish yellow or dark green "hard mud", respectively.

研究结果显示，两孔记录的古气候波动可与深海氧同位素曲线进行对比：对应于深海氧同位素曲线第6阶段(MIS6)，堆积厚层的河道相粗颗粒沉积及第3硬土层，反映当时气候寒冷；第5阶段(MIS5)，为滨海湖沼沉积，沉积物的颗粒显著变细；第4阶段(MIS4)，本区形成第2硬土层；第3阶段(MIS3)的早期，本区也发育滨海湖沼沉积，中晚期则形成潟湖—砂坝体系，在滨海平原区普遍发育粉、细砂层；第2阶段(MIS2)，地层由下粗上细的沉积序列构成，下部为黄灰、棕黄色粉砂，上部则为棕黄色或暗绿色硬粘土。

By mixing the model of life cycle law and the fast prototype law in the course of systematic development, the system has been fully benefited by I-DEAS variable size driving. The passenger train (hard seat car, hard sleeping car, soft sleeping car, soft carriage) of common use was mutually designed by incorporating the parameter and computer graphics, the three-dimensional, level and section pictures were assigned automatically, the scheme design with parameter and automation was realized.

在系统的开发过程中采用了生命周期法和快速原型法的混合开发模型，充分利用了I—DEAS软件的变量化尺寸驱动特性，集参数化和计算机绘图于一体，通过对通用客车(硬座车、硬卧车、软卧车、软座车)进行交互设计，自动生成三维效果图和平面、断面布置图，实现了铁路客车方案设计的参数化设计与自动化设计。

By using the transfer matrix method of multibody system, the hard problem of computation of the vibration characteristics of LRMLRS coupled with rigid bodies and elastic bodies is solved which is very difficult to the ordinary dynamic methods, and the vibration characteristics of LRMLRS which is varied when the number of rockets in the launch device is varied, is obtained conveniently. By developing augmented eigenvectors of the LRMLRS and its orthogonality conditions, the nonorthogonality problem of the multibody system including rigid bodies and elastic bodies is solved and the exact analysis of the dynamics response of the LRMLRS including rigid bodies and elastic bodies is realized. By using the random integer programming method, the hard optimization problem which contains continuous variables, discrete variables and random variables at the same time is solved. This method provides a technology for optimum design with random variables and discrete variables. The dynamic optimum design is realized to decrease the number of rockets consumption in the LRMLRS test. The simulation system of dispersion of fire is established by using the maximum entropy method to estimate dispersion of fire.

通过应用多体系统传递矩阵法，解决了刚弹耦合远程多管火箭多体系统振动特性这一通常力学方法不便于解决的计算难题，方便地获得了远程多管火箭振动特性及其随发射架上火箭弹个数变化而变化的情况；通过构造增广特征矢量及其正交性条件，解决了刚弹耦合多体系统特征矢量不具有通常意义下的正交性的难题，实现了对刚弹耦合远程多管火箭动力响应的精确分析；应用随机整数规划法，解决了同时考虑连续、离散和随机变量等多种设计变量的优化设计难题，为含随机和离散变量的优化设计提供了手段，实现了减少远程多管火箭试验用弹量的动态优化设计；建立了应用最大熵法估计的密集度仿真系统，优化射序和射击间隔，实现了提高远程多管火箭射击密集度的动态优化。

TEM shows that drying by direct heating might result in hard aggregation of the tourmaline powder, while hard aggregation might be avoided by azeotropic distillation. Raman spectroscopy reveals that there are O_H and C_H on the surfaces of the tourmaline powder obtained by azeotropic distillation, which indicates that butoxy is chemically adsorbed on the surfaces of tourmaline particles, but not adsorbed on those formed by direct drying. X_ray powder diffraction shows that the intensity of diffraction peaks decreases after grinding. There is no damage to the tourmaline crystal lattice in the process of direct heating, azeotropic distillation, or ultrafine grinding.

透射电镜分析结果表明，直接加热脱去水或正丁醇会使电气石超细颗粒发生硬团聚，而共沸蒸馏法则可有效防止硬团聚的产生；拉曼光谱结果表明，共沸蒸馏法制备的电气石粉末表面存在O—H和C—H键，说明正丁醇在颗粒表面为化学吸附，而直接干燥法得到的电气石粉末表面则没有；X射线粉晶衍射结果表明，研磨过程降低了粉末衍射峰的强度，但直接加热干燥和共沸蒸馏干燥均未破坏电气石的晶格结构。

The synthesized PCU was then characterized by infrared spectroscopy, differential scanning calorimetry, thermogravimetric analysis, small-angle X-ray scattering, and tensile strength measurement. The IR showed that the polymer synthesized by the above two methods both have the polycarbonate-urethane structure and the tensile measurement showed good mechanical performance of the polymer. The DSC and TGA data showed that there is an obvious soft-hard glass transition area, which indicated the existence of the micro-phase separation structure. The extent of the phase separation was affected by the ratio of starting materials, the molecular weight of PCD, and the polymerization method. The decomposition upon heating was observed in two steps. SAXS result showed that the radius (r_2), the distance between domains (d_2), and gyral radius (R_2) of hard segment micro-domain were fairly affected by the starting materials ratio and soft segment content.

IR结果表明两种方法合成的聚合产物均具有聚碳酸酯聚氨酯的结构；拉伸实验表明聚合产物具有良好的力学性能；DSC、TG结果表明，聚合物呈现出较为明显的软硬段玻璃化转变区，表明存在微相分离的结构，相分离的程度受原料配比、软段分子量、聚合方法的影响，其热分解分为明显的两个阶段； SAXS结果表明，聚合物原料配比、软段含量的变化对硬段微区回旋半径R_2，微区间距d_2，微区半径r_2影响不大其值分别为9.5(A|°、29、7.4，但对软段的微区半径及间距影响较大，随着软段含量的增大，软段微区的半径r1和间距d1都增大。

The study about the flux and index of gamma-ray loud blazars show:(1)there is significant correlation between the luminosities in gamma-ray and VLBI radio energy band;(2)there are strong anticorrelarions among the observed indices of soft X-ray, hard X-ray and gamma-ray. For the FSRQs, the whole X-ray emission was contributed by synchrotron self-Compton emission, for the HBLs, the X-ray emission was dominated by synchrotron emission while the soft X-ray emission is dominated by synchrotron emission and the SSC emission dominate the hard X-ray energy band for LBLs;(3) there are strong radio-radio and radio-optical flux correlations for the quasar 3C 273. The higher frequency emission leads those in lower frequency. The multi-band complex indices strongly correlated with the high frequency flux which implies that the object is becoming bright when the energy spectrum is harden.

通过对γ噪Blazar天体的谱指数、流量的相关研究，发现（1）51个样本blazar的γ射线光度与VLBI光度之间存在显著相关；（2）软X、硬X以及γ波段的观测谱指数之间存在较强的反相关，对FSRQs，无论是硬X射线还是软X射线的辐射都是逆康普顿辐射的贡献，而对于HBLs来说，则是同步辐射的贡献，对LBLs，在软X射线波段以同步辐射贡献为主，在硬X射线能区以逆康普顿贡献为主；（3）3C 273的射电各个波段以及光学之间存在强相关，高频辐射一直领先低频辐射，3C 273的多波段复合谱指数和高频流量之间存在强的反相关，意味着当能谱变硬时对象变亮。

Hard disk of the master-slave jumper settings are generally in the hard drive's power cord jack and data jack line between the local, usually from 3-4 group together with jumper jumper cap 1-2 composed of a positive in the hard disk or the opposite is also printed on the main disk, from the disk, as well as by the cable select method of the jumper, as long as the icon of the jumpers in accordance with the method, you can set arbitrary to set the hard disk or from disk-based disk.

硬盘的主从盘跳线一般都设置在硬盘的电源线插孔和数据线插孔之间的地方，通常由三到四组跳线再加上一到两跳线帽组成，在硬盘正面或反面还印有主盘、从盘以及由电缆选择的跳线方法，只要按照图示的跳线方法，就可以随心所欲的设置将硬盘设置为主盘或者从盘。

Hard disk of the master-slave jumper settings are generally in the hard drive's power cord jack and data jack line between the local, usually from 3-4 group together with jumper jumper cap 1-2 composed of a positive in the hard disk or the opposite is also printed on the main disk, from the disk, as well as by the cable select method of the jumper, you may want to set up the hard disk or from the main setup disk.

硬盘的主从盘跳线一般都设置在硬盘的电源线插孔和数据线插孔之间的地方，通常由三到四组跳线再加上一到两跳线帽组成，在硬盘正面或反面还印有主盘、从盘以及由电缆选择的跳线方法，你可以随心所欲的设置将硬盘设置为主盘或者从盘。

This Contract shall be considered legal and binding upon signatures on Fax Copies Upon receipt of the counter signed Copies by Fax, Seller shall send Four (4) Hard Copies by courier Service to the Buyer, who shall sign and return Two (2) Hard Copies thereof duly executed to Seller by courier service.

传真件一旦签署并收到对方签署的传真件，则与本合同一样对双方具有同等法律约束力，卖方用急件应向买方发送 4 份正本合同，买方则应以急件发送 2 份已签署的正本给卖方。

He and Nina moved to California and lived at 2005 Ivar Street, Apt.

他和Nina搬到加州，并在2005年伊瓦尔街，公寓生活。

Droperidol （ potently inhibits transfected HERGchannels and this is the probable mechanism for QT prolongation.

氟哌利多有效地抑制了转染的 HERG 钾通道，可能是 QT 间期延长的机制。