过量的

The result indicated that: the amount of the excess HF formed direct ratio to the yield of phosphorus pentafluoride and the optimum amount of the excess HF used is about 35%; the trickling rate of oleum shouldnt make the temperature of hexafluorophosphoric acid exceed 25 ℃ and the amount of oleum is 110% to 125% that of stoichiometry so that the content of phosphorus pentafluoride can be achieved 90%; the time and temperature of heating hexafluorophosphoric acid influenced both the yield and the content of phosphorus pentafluoride, and the optimum time should be about 30 minutes and the proper temperature was 148 to 153℃; when alcohol used asrefrigerant, the content of phosphorus pentafluoride was 94.03%, and the content can be up to 97.38%, provided that using liquid nitrogen as refrigerant.

通过实验发现，氟化氢用量与五氟化磷的产率成正比，最佳过量百分率宜在35％左右；发烟硫酸的滴加速度不能使中间产物温度大于25℃，发烟硫酸用量大于理论量10％～25％时，得到的五氟化磷纯度高于90％；六氟磷酸的加热温度对五氟化磷的产率和纯度均有影响，宜在148～153℃的范围内，加热时间应在30分钟左右；用工业酒精做冷凝介质得到的五氟化磷纯度最高只能到达94.03％，使用液氮做冷凝介质可以使五氟化磷的纯度达97.38％以上。

In addition, a printing plate edge marked slopes or plate is too thin, or short-run printing of excessive wear lighter, so that the short-run suites and whitespace differences of high and low is too low and too soft pads, resulting in suites blank areaand, electro-chemical layer of aluminum foil, etc, should be made at the edge version slope near 90-degree right-angle (such as seihan with carving techniques that help you make little gradient edge version), according to the characteristics of the short-run suites, with thickness larger plate seihan, and a blank site, using a corrosion deeper stereoplasm lining for short-run; in addition, you should choose thin aluminized layer of anodized, adjust the appropriate business card printing and membership card making and adjusted pressure volume drum uponsize pressuer letoff drum.

此外，印版边沿存在明显的斜坡度或版材太薄，或印版过量烫印磨损变浅，使烫印版面与空白的高低差异太小，衬垫材料过软，造成版面空白部位与电化铝箔层接触等，应将版边沿坡度制成近90 度的直角(如采用雕刻工艺进行制版，可使版边沿几乎没有坡度)，根据烫印版面的特点，采用厚度大一些的版材制版，并将空白部位腐蚀深一点，采用硬质包衬进行烫印；此外，应选择镀铝层较薄的电化铝，调整合适的制卡和会员卡制作压力，并适当调整压卷滚筒压力和收卷滚筒拉力。

In oxygen deficient high temperiture combustion, the amount of volatic material evolved influene the conversion of sulfur in coal, high volatile content restrains the oxidation of pyrite and iron sulfide , which causes compavatively large amount of iron sulfide left in char. At the condition of air coefficient α=0.4, the sulfur conversion is up to 87% for SHONGZHAO anthracite coal, 72% for FORGCHANG bituminous coal, and the conversion is compeleted within 0.5 see.

在高温贫氧状态下燃烧，煤中硫的释出率高于煤的燃烧率，高挥发份将抑制黄铁矿的氧化释放出来，即影响煤中硫的释出率，在过量空气系数为40％时，松澡无烟煤能达到87％的硫的释出率，丰城烟煤达到72％的硫的释出率。

"Although everyday levels of stress are necessary to stimulate normal brain development, excess levels can be harmful," said Carrion, likening the biological effects of increasing amounts of stress to an inverted U. One common treatment for PTSD is to help a sufferer develop a narrative of the traumatic experience.

&虽然每天的各级压力的人要激发正常的大脑发育，过量水平，可以有害的，说：&腐肉，论及生物效应的越来越多的压力，以一个倒美国一个共同的治疗创伤后应激障碍是，以帮助患者制定一种叙述的惨痛经历。

Here, we demonstrated in this work that CsrA performs a negative regulator of the cel expression. cel, encoding lysis protein (LysE7), is located downstream of the colicin E7 structural gene in the ColE7 operon. Lysis protein was essential for colicin release and causes a decline in culture turbidity as well as lethality of the host cell when overproduced. Western blotting analysis of the level of LysE7 in the wild-type and csrA mutant strains was examined.

在本论文中，我们进一步发现到CsrA对於cel 基因的表现具有抑制的现象。cel 基因位在质体ColE7-K317上的E7大肠杆菌操纵子，可以制造出溶菌蛋白质(lysis protein， LysE7)，协助大肠杆菌素及免疫蛋白质的复合体运送至菌体外；但当菌体产生过多的溶菌蛋白质，则会导致宿主细胞的死亡，所以溶菌蛋白质的表现必须受到严密的调控，避免菌体产生过量，而CsrA则是目前第一个被发现到能调控溶菌蛋白质表现的因子。

Be able to explode ignites （3000Till 4000 ℃,This also is living over-dose air and the numeric value when possesing remains waste gas only ,In case according to the ideal air/fuel ratio layout ,There is not waste gas ,The temperature gathering is taller ）Oil30 grams may be cause （90℃ tail gas preheats ）Steamization （Vaporization heat 2282.7J\g ）……At the respect of the pressure swelling ,Even if being in the critical of water （374℃）Condition ,Critical pressure 21.83MPa of water 、Carbon dioxide critical（31.1℃）Pressure 7.38MPa also is some -fold of a rule piston style explosive motor pressure 5--9MPa （Dalton's Law or the Law of Additive pressures）……For emploing the capacity means difference ,Therefore the composition is different as black and white .

一克爆燃（3000至4000摄氏度，这也只是在过量空气和有残余废气时的数值，如果按理想空燃比配置，没有废气，温度会更高）的油可以使30克（90摄氏度尾气预热）的水汽化（汽化热2282.7J\g）……从膨胀压力方面来说，即使处于水的临界（374摄氏度）状态，水的临界压力21.83MPa、二氧化碳的临界（31.1摄氏度）压力7。 38MPa也是常规活塞式内燃机压力5--9MPa的几倍（压力叠加定律，道尔顿定律）……因为用能方式不同，所以结构就截然不同。

In chapter 3, the HCl emission in MSW fluidized bed incineration is studied in laboratory by modeling MSW. The conversion ratio of inorganic and organic chlorine to HCl is investigated by varying bed temperature, fuel moisture content and excess air. The test result is valuable for the design and operation of FBI.

第三章在小型热态流化床上模拟研究了固体废弃物燃烧过程中HCl的排放特性，分别对有机氯和无机氯→氯化氢的转化率随床温、燃料水份及过量空气的变化规律进行了深入的研究，得出的结果对指导流化床焚烧炉的设计与运行是很有实际意义的。

In this study, we have cloned and identified two full-length cDNAs of OsBIMK2 and OsBISERK1, which encoding MAPK and SERK, respectively, and associated with benzothiadiazole induced resistance.

本文克隆和鉴定了水稻中与苯并噻二唑(benzothiadiazole，BTH)诱导抗病性相关的编码MAPK的OsBIMK2基因和编码SERK的OsBISERK1基因全长cDNA；研究了OsBIMK2基因和OsBISERK1基因在水稻—稻瘟病菌亲和与非亲和互作过程中的表达模式；原核表达了OsBIMK2基因，获得重组OsBIMK2蛋白，并研究了重组OsBIMK2蛋白的生化特性；克隆了OsBIMK2基因的启动子序列，并运用农杆菌介导的瞬间表达系统分析鉴定了启动子中参与基因表达调控的可能顺式元件；将水稻OsBIMK2基因导入烟草，获得过量表达OsBIMK2基因的转基因植株，这些转基因植株中防卫反应基因PR-1组成型表达，并提高了抗病性。

It was demonstrated that the actin could be polymerized into discrete filaments of tree-like branch structure, random coil filaments cluster and long filaments with different diameters in F-buffer besides random aggregates. These polymerized filaments clearly exhibited the structural polymorphism and showed obvious difference from those assembled under the regulation by actin binding proteins or phalloidin.

研究发现，actin在体外通过自装配过程除了形成无序的蛋白堆积物之外，还能够聚合形成复杂的离散结构，包括树状分支的纤维丛、无规卷曲的纤维簇以及具有不同直径的长纤维等；这些大尺度纤维复合物明显不同于在ABPs或过量F-actin稳定剂参与下形成的由单根微丝和微丝束构成的聚合结构。

Due to the over-exploitation of groundwater, subsidence occurred which threaten the development of economy and people's life. It's very important to inspect the structure of water-bearing layer, the distribution of strata and the processing of subsidence.

地下水的长期过量开采导致了苏锡常地区的地面沉降，引发了严重的地质灾害，威胁人民的生活安全，影响了该地区经济的发展；因此，查明含水层结构及各地层的分布规律，研究地面沉降的发生发展过程和机理甚为重要。

I'm strongly against the death penalty — it's an eye for an eye.

我不赞成死刑——这是以牙还牙的报复行为。

And to get you the support you need, we're enlisting all elements of our national power: our diplomacy and development, our economic might and our moral suasion, so that you and the rest of our military do not bear the burden of our security alone.

并给你们所须的支援，我们正徵召国家所有各种的力量：我们的外交及发展，我们的经济力量与道德劝说，所以你们与其他军人不须要孤独地负起国家安全的责任。