查询词典 temperature gradient

The characteristic of the dairy cow thermoregulation was base on environment and nutrition administration technology. Study regressions of dairy cow physiology on ambient temperature, effective temperature and temperature-humidity index, the difference between the high and low yield dairy cow of the circadian rhythm about thermoregulatory at hot summer, evaluated the efficiency of half open and open dairy barn preventing heatstroke, evaluated the efficiency of temperature dropdown by sprinkler and air-cooling fan. The thesis was described in the following three sections.

奶牛体温调节特性是环境与营养调控技术的依据，本文从高温季节环境温度、体感温度和温湿指数与奶牛生理反应的关系，温热环境和体温调节特性的昼夜差异，高、低产奶牛体温调节特性，牛舍环境特征及其冷风机和喷淋降温效果等方面揭示荷斯坦奶牛的体温调节特性。

Based on the analysis of the main failures discovered in pavement on steel deck plate and the demanding service condition of the pavement on steel deck,high-temperature rutting test,low-temperature bending test and controlled stress flexural fatigue test are used to study the performance of asphalt mixtures modified by epoxy resin including high-temperature stability,low-temperature cracking-resistance,and fatigue cracking-resistance,which are served to evaluate the modification effect of epoxy resin of different contents.

文摘：在分析钢桥面铺装层主要病害和特殊工作环境的前提下，分别采用高温车辙试验、低温小梁弯曲试验和控制应力小梁弯拉疲劳试验，研究了不同环氧树脂掺量下的环氧树脂改性沥青混合料的高温稳定性、低温抗裂性和抗疲劳性能。

Based on the analysis of the main failures discovered in pavement on steel deck plate and the demanding service condition of the pavement on steel deck,high-temperature rutting test,low-temperature bending test and controlled stress flexural fatigue test are used to study the performance of asphalt mixtures modified by epoxy resin including high-temperature stability,low-temperature cracking-resistance,and fatigue cracking-resistance,which are served to evaluate the modification effect of epoxy resin of different contents.

在分析钢桥面铺装层主要病害和特殊工作环境的前提下，分别采用高温车辙试验、低温小梁弯曲试验和控制应力小梁弯拉疲劳试验，研究了不同环氧树脂掺量下的环氧树脂改性沥青混合料的高温稳定性、低温抗裂性和抗疲劳性能。

Based on them, distribution laws of subgrade temperature field under fluctuant boundary temperature cycle conditions are analyzed, and different ratios of slope for general subgrade and different status when there are or not banquettes are compared by laboratory simulation and numerical analysis; thermal insulation and cooling effect of thermal insulation slab, broken stone and non-power heat pipes is respectively investigated under the trend of elevated temperature by numerical analysis, laws of subgrade deformation are predicted under the trend of elevated temperature and influences of subgrade thaw settlement on pavement stress are studies by numerical computation for observation data of representative road sections selected.

为研究青藏公路冻土病害处治对策，从青藏公路2002年～2004年冻土病害整治工程实际出发，在系统分析研究青藏公路病害及发生机理的基础上，运用室内模拟试验、数值分析方法，依托处治冻土病害路段实际使用的隔热板路基、碎石路基、无动力热棒路基等进行现场试验，分析边界温度周期波动条件下的路基温度场分布规律，同时进行一般路基不同边坡坡率的对比研究及有无护坡道的对比研究；运用数值分析方法，对气温升高趋势下隔热板、碎石、无动力热棒的隔热降温效果进行了研究；选择代表性路段观测资料，运用数值计算的方法，进行升温趋势下的路基变形预测，研究路基融沉变形对路面应力的影响。

Therefore liquid CO_2 avoids gas-solid multiphase flow, and supplies continuous low temperature gas for cryoprobe. Experimental results show that the 2-dimension temperature distribution for the first time, it includes:(1) The cooling velocity and freezing zone increases along the flux up at certain size of the cryoprobe in the same biological tissue.(2) As the diameter of cryoprobe increases, the temperature will descend faster, freezing zone will be broader obviously, and ice ball become larger. Until it arrives heat balance, the temperature keeps invariability.(3) Single freezing-thaw results in biggish mechanical injury already for loosen tissue such as pork liver; Successive freeze-thaw circle could quicken freezing and thaw velocity for compact tissue, and it has proved the more mechanical injury of successive freeze-thaw circle than the single freezing-thaw treatment.

文中首次对生物组织进行了二维温度场分布实验研究，得出：(1)当刀头大小一定，对同一组织冷冻时，流量越大，降温速度越快，降温影响区域越大；(2)随着冷刀直径的增加，降温速度随着增加；温度影响区域明显增大；冰球直径也随着增大，热量平衡后温度几乎不随时间变化；(3)对于结构疏松组织比如猪肺脏，单次冻融对组织已造成较大的机械破损；对于结构较致密组织，多次反复冻融可以使降温和复温速率增加，单次冻融的热应力造成的机械破损较小，多次冻融后造成的机械破损比单次冻融所造成的机械破损大；(4)直喷式刀头比导热式节能约15％。

The temperature measure is a main parameter in modern industry produce process, especially in large enterprises high-voltage bus. Due to bus temperature need be controlled on time, there is not daces which measure bus temperature at present. Adopted artificial measure, measure it every a section of time at interval, cannot reflect the temperature on time. It is very in convenient.

温度测量是现代工业生产过程中的一个主要参数，特别是大型企业的高压母线上的温度测量，由于母线温度需要及时的控制，目前没有合适的测量母线温度的仪器，采用人工测量，每间隔一段时间测量一次，不能反映温度的及时变化，十分不便。

DC to GND DC to BAT BAT, CHG, POK, USB to GND Operating Temperature Range Junction Temperature Range Storage Temperature Range Lead Temperature (soldering, 10s) Continuous Power Dissipation (TA =+70C) 5-Pin Thin SOT23 Derates above +70C 5-Pin Thin SOT23

直流接地直流英美烟草英美烟草，嗜铬粒蛋白2710 8860，USB到GND的工作温度范围结温度范围储存温度范围引线温度（焊接，10秒）连续功率耗散（电讯局长=+70℃）5引脚薄型SOT23封装Derates以上+ 70℃5引脚薄型SOT23封装

Job as follows shall be finished next week:(1) Get right and left side of upper water wall positioned and reinforced;(2) Finish Pre-store nine downcomers;(3) All the wall are positioned and reinforced, and then install right and left side rigid beam;(4) Finish front wall counterpart welding;(5) Hoisting two rare roofs, Middle-temperature RH, four high temperature RH headers, hoist headers of middle-temperature RH and high-temperature RH, it can't install lifting rod.

下周，锅炉以下工作需要完成：（1）上水左右侧找正完，且加固完；（2）下降管9根预存完；（3）包墙全部找正完，加固完，之后安装左右侧刚性梁；（4）前包墙对口焊接完毕；（5）后顶棚吊装2片、中温再热器、高温再热器集箱4个，吊挂中再和高再集箱时，不能安装吊杆。6）2台汽动前置泵找平找正，并验收；（7）电动给水泵组，耦合器和电泵就位；（8）启动锅炉房内设备找平找正，并验收；（9）3台复用水泵就位；（10）综合水泵房内设备找平找正，并验收。

As the key element of the thermostatic valve the temperature sensing element plays the role of temperature sensing and force outputting.By absorbing the heat of the working fluid,the temperature sensing medium produces the capacity expansion which moves the regulating sleeve to control the fluid flow of input to control the temperature.

感温元件作为温控阀的关键元件起着感知温度和输出力的作用，感温介质吸收工作流体的热量产生体积膨胀，推动调节套筒调节进口冷热流体流量从而控制出口温度。

The main results were obtained as follows:(1) The calculation results of temperature field indicate that, 6139T radiator was brazed using the stage-by-stage heating process, while 6204T radiator with a larger size was brazed using the temperature difference heating process. The uniform temperature distributions in faying faces were all obtained. And the temperatures were in the range of brazing temperature. It is proved that the finite element models established are reasonable.

取得的主要结果和结论为：(1)温度场计算结果表明，对于6139T散热器，采用分阶段加热钎焊工艺，而对于具有较大尺寸的6204T散热器，采用温差法加热钎焊工艺时，均获得了均匀的钎焊面温度分布，且在钎焊温度范围之内，证明所建立的有限元分析模型是合理的。

It inculcates justification before God on the ground of human merits.

它说明在上帝灌输在地上人类优点。

TH Leaguer has excellent Quality Control and Management System.

本公司具有完善的品管部门。