查询词典 temperature gradient

This article discusses the influence of urea prilling tower exit temperature on the water percentage of urea,analyses the factors influencing urea prilling tower exit temperature,and puts forowrd suggestions to control the tower exit temperature through replacing the prilling sprayer and adjusting the shutter opening of prilling tower according to atmosphere temperature and humidity.

讨论尿素造粒出塔温度对尿素含水率的影响，对影响尿素造粒出塔温度的因素进行分析，提出通过更换喷头及根据环境温度和空气相对湿度调节百叶窗开度来控制尿素造粒出塔温

The result indicates that there are two negative effect stages of temperature on rice and rice yield before tasseling and after tasseling. And the temperature effect is most obvious on seed-setting rate, secondly on 1000-grain weight and thirdly on yield. The effect of minimum temperature on rice is greater than that of maximum temperature.

结果表明，气温对水稻产量构成和产量在始穗前和始穗后各有一个负影响时段，其影响程度始穗前大于始穗后；对结实率影响最大，其次是千粒重，再次是产量；最低气温的影响大于最高气温。

On the basis of analyzing the concept of charge temperature in the field environment, this paper discusses the unbalances of internal temperature of charge and environment temperature and the serious extents of traditional charge temperature measure error.

该文在澄清野战条件下的药温概念基础上，介绍了野战条件下装药环境温度不均匀性、装药内部温度不均匀性和传统药温测量误差严重性。

The results show that at sea level, coolant flow rate affects the plug pressure, heat flux and temperature; at design operating condition, coolant flow rate has no effect on pressure and heat flux on the plug wall. With the same coolant flow rate, plug temperature at sea level is higher than that at design operating condition; under the same operating condition, ramp temperature is higher than the plug base temperature.

计算结果表明：地面工况下，冷却剂流量的改变对塞锥和塞锥底部壁面的压强、热流密度和温度的影响较大，高空环境下，冷却剂流量的改变对塞锥和塞锥底部壁面的压强、热流密度的影响较小；在冷却剂流量相同的情况下，塞锥和塞锥底部在地面工况下的壁面温度要远高于在高空环境下的温度；在相同工况和相同冷却剂流量的情况下，塞锥壁面上的温度要远高于塞锥底部壁面上的温度。

To determine the relationship between body temperature and ambient temperature of big-headed turtle the seasonal and diel variations in its body surface temperature and ambient temperatures were measured in a field enclosure using miniaturized dataloggers and selected body temperature in the laboratory.

应用微型温度自动记录器，在野外围栏条件下，测定平胸龟体表温度和环境温度的昼夜和季节变化；在实验室条件下，测定其选择体温，旨在揭示平胸龟的体温和环境温度的关系。

In the vegetation of coverage forest and bush, temperature is lower and there is local low temperature center in middle slope. Temperature is relative higher in slope top and slope foot, and the change of temperature grads is little.

在森林和灌丛植被中，坡面中偏上部温度较低，往往出现局部的低温中心；坡顶和底部温度相对较高，且温度的梯度变化小。

This real-time system can accurately detect the vehicle's interior temperature, when the temperature is below detection to set the temperature, the system can automatically open vehicle around the room to the car heater, heated indoor temperature to the default.

此系统能够实时准确地检测出汽车车室内的温度，当检测到温度低于设定温度时，系统能够自动打开汽车车室四周的电加热器向车室内温度加热至预设值。

In considering the bearing and fit with clearance, the material should be noted that at high temperature to become soft and easy to deformation characteristics, as well as many high temperature from ambient temperature to the temperature change caused by the possibility of permanent deformation must.

在考虑轴承的配合过盈量和游隙时，要注意到材料在高温下变得松软而容易变形的特点，以及多次由常温到高温的温度改变引起一定永久变形的可能性。

As can be seen from the literature which I have consulted, universal agreements has been reached as to the mechanism of low-temperature cracking of AC pavement (including contracting cracking cause by one substantial drop in temperature and thermal fatigue cracking). But the research on the low-temperature cracking is still immature up to now, which can justify the absence of related indices of low-temperature cracking of all AC pavement design methods.

但是，从查阅的文献可以看出，对于沥青路面产生低温开裂（包括一次性大幅降温引起的收缩开裂和温度疲劳开裂）的机理，人们的认识是一致的；但是，对于沥青路面低温开裂等问题的研究至今仍不够成熟，世界各国的沥青路面设计方法中均未引入低温开裂的有关指标就说明了这一点。

The steps include selecting a mould, injecting low temperature hot melt materials, drying the low temperature hot melt material mould, taking out the low temperature hot melt material mould, coating with slurry and sand spraying, drying the sand mould, heating for allowing the low temperature hot melt materials to demould, casting and forming, destroying the sand mould, cutting and processing to obtain the finished product.

取一成型模具：该成型模具包括两个对合的半模，于成型模具内设有一螺旋转子的成型模穴及浇铸道；灌注低温热熔材：于浇铸道灌入熔融的液态低温热熔材，液态低温热熔材即填充于对合的两螺旋转子心轴模穴、及两转子螺旋部半模穴；干燥：液态低温热熔材干燥凝固，形成一具有螺旋转子外型的低温热熔材

Bob Eckert has been chairman and chief executive of Mattel for eight years.

美泰董事长兼首席执行官鲍勃·埃克尔特在任已8年。

The outlook for honors and disgraces carries on and surpasses the traditional outlook for honors and disgraces theoretically, and carries on and develops the theory of construction of socialist mora...

社会主义荣辱观的提出在理论上是对传统荣辱观的一次继承和超越，是对社会主义道德建设理论的继承和发展，在实践上有利于形成良好的社会风尚。