查询词典 shear modulus

Implementation of the aforementioned circle shear machine would result in major complications in the handling of the metal sheet, since now the metal sheet must be rotated in the middle of the automated line in order to generate a hole cut-out by the circle shear machine.

实施上述圈剪切机，将导致重大并发症，在处理的金属板，因为现在的金属板，必须在旋转中的自动线，以产生一个洞，割出所圈剪切机。

Based on the results of exploration and in-site test of typical waste dump in southwest mountainous area,the analysis theory and method of waste dump rainfall infiltration are discussed beginning at analysing coal waste's mechanics characteristic and seepage theoty. Fllowed estimating method of waste dump stability is discussed influenced by rainfall. At last a typical engineering example of coal waste dump landslide influenced by rainfall is researched, acquiring research fruit hereinafter.①Particular exploration of typical waste dump in chongqing area and analysis estimate to its area engineering geology are done. Granule gradation、water content、nature density、dry densit etc parameter of waste granular media are tested. The mechanics characteristic of waste are researched by in-site shear experimentation、compressibility experimentation and infiltration experimentation.②The coal waste dumping is different from other consecutive solid material as incompact granule structure. Its shear strength and transforming characteristic also have itself characteristic.

本文针对山区矸石山，结合踏勘和现场试验，从分析矸石散体的力学特性以及渗流理论出发，研究了矸石山降雨入渗的分析理论与方法，在此基础上提出了矸石山体降雨作用下的稳定性评价方法，最后进行了降雨作用下典型矸石山滑坡工程实例研究，取得了以下研究成果：①对重庆山区中梁山、万盛、荣昌、天府、綦江等矿区代表性的矸石山进行详细踏勘，对矸石山的堆放形态及其区域的工程水文地质情况进行调查；针对重庆山区矸石山，测试矸石散体的颗粒级配、含水量、天然密度、干密度等参数、并在此基础上，通过现场剪切、压缩、渗透试验等研究矸石散体的力学特征。

On the basis of shear resisting behavior experiments of the column, the formula model for calculating the shear strength of the column is presented, and the undetermined coefficient in the formula is regressed using the experimental data.

进行了钢管高强混凝土核心轴压短柱的轴心受压试验，研究了其破坏特征、延性和钢混共同工作特性等力学性能，给出了其极限承载力的计算公式。

Lastly, this paper discusses the possibility to monitor the coming of the larger earthquake using shear-wave splitting observation, suggests that the continuous observation on temporal change of shear-wave splitting could be adopted to monitor the occurrence of larger earthquakes, this observation could recognize whether the crust rock has enter the fracture critical state or not, forecast the possible coming earthquake, i.e.

最后，本文对利用剪切波分裂观测对较大地震进行监控作了讨论，认为对剪切波分裂的时间变化作持续的观测，可以进行地震监测，识别地壳岩石是否已经进入了破裂临界状态，对可能到来的地震作出相应的预测。

According to the stress characteristics of coal floor with faults, corresponding simplified mechanical model is built to obtain the equations of shear stress and normal stress on the fault, as well as the influential rules of fault dip on shear stress, normal stress and fault activation.

针对含断层缺陷底板的受力特征，建立相应的简化力学模型，分析得到断层面上的剪切应力和法向应力表达式，并研究断层倾角对断层面上剪切应力、法向应力及断层活化的影响规律。

With development of the industrial control system,programmable logic controller is widely used in dividing shear of Baosteel Heavy Plate Mill,especially in the fields of the main motor control of dividing shear ,collection and analysis of PDA data,control of pinch rolls, adjustment control of knife gaps,shearing process control,etc.

随着工业控制系统的不断发展，可编程控制器在宝钢分公司厚板厂定尺剪系统中得到了全新的应用，尤其在定尺剪的主电机控制、PDA数据采集和分析、夹送辊控制、剪刃间隙调整控制、剪切过程控制等方面得到了应用。

The method divides block along the intersection edge of joint faces and neglects the vertical shear force between dividing-blocks i.e. takes horizontal normal force and shear force into account; as to an assumed sliding direction, by satisfying vertical force equilibrium of every dividing-block and whole force equilibrium in the sliding direction, the factor of stability can be solved.

基于此，提出分块极限平衡分析法，该方法沿非临空面交棱将块体进行分块，在忽略分块间的垂向剪力（即可考虑分块间的水平法向力和剪切力）前提下，通过满足各分块的垂向力平衡和滑动方向上的总体力平衡，求解特定滑动方向的稳定系数。

In this modified model, the effect of the stress concentration on the end stress in the fiber end region is considered, the average matrix strain is used to substitute for the so-called far field strain in the previous shear lag model. The change of the deformation states from elasticity to plasticity is considered and the interfacial shear stress and fiber axial stress are derived.

修正的模型合理考虑了纤维根区域应力集中对根应力的影响；用基体平均应变代替了经典剪切滞后模型中的远场应变；考虑了基体变形状态从弹性到塑性的变化，给出了塑性区上的表面剪切应力和纤维轴向应力的表达式。

After the result of cohesion-friction model is compared with Coulomb Criterion, it is found that when the results of shearing strength are many and adjacent the strength parameters can not be regressed by least square method, instead the results should be divided into some beelines at that time according to the cohesion-friction model.(4) Discuss the characters of hard structural plane and weak structural plane: The adhesive friction theory is applied to research the changing course of shear area of hard structural plane and its influence on shear stress.

3介绍了岩石强度理论中的粘接摩擦模型，运用此模型分析依附型滑动面的演化过程，并将其推广到边坡岩土体抗剪强度的选取，讨论了不同法向应力下峰值强度和残余强度随法向应力的变化规律，在此基础上给出抗剪强度的选取模式，讨论了对实际取值结果的影响，并与传统的Coulomb准则进行了比较分析，指出直剪试验的法向应力在小应力区的点较多且抗剪强度结果差异不大时，不宜直接运用最小二乘法回归抗剪强度参数，此时应结合粘接摩擦模型对结果进行线性分段。

Introduce the cohesion-friction model of rock strength theory, and extend the model to select the strength of sliding plane, discuss the variation rules of peak strength and residual strength under different normal stress, and then present the selection model of shearing strength. After the result of cohesion-friction model is compared with Coulomb Criterion, it is found that when the results of shearing strength are many and adjacent the strength parameters can not be regressed by least square method, instead the results should be divided into some beelines at that time according to the cohesion-friction model.(4) Discuss the characters of hard structural plane and weak structural plane: The adhesive friction theory is applied to research the changing course of shear area of hard structural plane and its influence on shear stress.

3介绍了岩石强度理论中的粘接摩擦模型，运用此模型分析依附型滑动面的演化过程，并将其推广到边坡岩土体抗剪强度的选取，讨论了不同法向应力下峰值强度和残余强度随法向应力的变化规律，在此基础上给出抗剪强度的选取模式，讨论了对实际取值结果的影响，并与传统的Coulomb准则进行了比较分析，指出直剪试验的法向应力在小应力区的点较多且抗剪强度结果差异不大时，不宜直接运用最小二乘法回归抗剪强度参数，此时应结合粘接摩擦模型对结果进行线性分段。

The father that if work,mad father, love annoys, disposition is too indrawn the be short ofing that the father of Mu Ne, resign oneself to adversity causes father easily to love is broken; Communicate time effectively between father and son, Mu Zizhi to be less than a hour on average to wait a moment every week, it is the cause that causes the child to become addiction.

如工作狂的父亲、爱愤怒的父亲、性格过于内向木讷、逆来顺受的父亲都易造成父爱的缺失；父子、母子之间的有效沟通时间每周平均小于一小时等等，都是造成孩子成瘾的原因。

These are vandal proof and they come with a locking mechanism.

这是野蛮的证据，他们来到了锁机制。