查询词典 feedback amplifier

S1 is then changed to position 1. The voltage stored on C1 is inserted between the output and inverting input of the amplifier and the output of the amplifier changes by VIN to maintain the amplifier input at the input offset voltage. The output then changes from (VOS + IbiasR2) to (VIN + IbiasR2) as S1 is changed from position 2 to position 1. Amplifier bias current is supplied through R2 from the output of the amplifier or from C2 when S1 is in position 2 and position 1 respectively. R3 serves to reduce the offset at the amplifier output if the amplifier must have maximum linear range or if it is desired to DC couple the amplifier.

接着 S1 拨到位置 1，使 C1 的电压加在放大器的输出端和反相输入端之间，(由于电容端电压不能突变，所以)输出端的电压将产生大小等于 VIN 的变化，使放大器输入端维持输入失调电压，即当开关 S1 从位置 2 拨到位置 1 时，输出端电压将从(VOS + IbiasR2)变为(VIN + IbiasR2)。S1 处于位置 2 时，放大器的偏置电流是由输出端经电阻 R2 提供的，当 S1 转向位置 1 时则由 C2 提供。R3 的作用是降低输出失调电压，如果要求放大器具有最大的线性范围，或者采用直流耦合，就应该使用该电容。

The invention discloses a DC/DC circuit, comprising a PWM controller, a current amplifier, a peak current comparator, an error amplifier, a main switch, a synchronous switch and also an operational amplifier. The non inverting input end of the operational amplifier is used for coupling with input voltage or voltage reference, or used for coupling with the input voltage and the voltage reference; the inverting input end of the operational amplifier is used for coupling with the voltage reference or ground, and the output end thereof is connected with the non inverting input end of the error amplifier.

本发明公开了一种DC/DC电路，包括PWM控制器、电流放大器、峰值电流比较器、误差放大器、主开关和同步开关；还增设运算放大器，其同相输入端用于与输入电压或基准电压耦合，或用于同时与输入电压和基准电压耦合；其反相输入端用于与基准电压或地耦合，其输出端与所述误差放大器的同相输入端连接。

Voltage Source and Current Source, Thevenin Theory, Trouble Shooting, Characteristic Curve of Diode, Diode Models, Rectifier Circuits, Input Filtering Capacitor, Voltage Multiplier Circuits, Limiter and Clipper Circuits, DC Clampers and Peak-to-peak Detectors, Zener Diode, Zener Diode Rectifier, Photoelectric Devices, Collector-Emitter Junction, Transistor Characteristics of common-emitter, Base Bias, LED Dirver, Establishing a Stable Q-point, PNP Transistor Biasing, Transistor Biasing, Coupling and By-Pass Capacitors, AC Emitter Resistance, Common-Emitter Amplifier, Other Common-Emitter Amplifiers, Cascaded Common-Emitter Amplifiers, AC Load Line, Emitter Follower, Class B Push-pull Amplifiers, JFET Characteristic Curve, JFET Biasing, JFET Amplifier, VMOS Circuit, Differential Amplifier, Operational Amplifier, Non-inverting Feedback, Negative Feedback.

电子学实验( S0704)(1，1)/应用电子学实验( S0472)(1，1)电压源和电流源、戴维宁定理、故障排除、二极体特性曲线、二极体近似模型、整流电路、电容-输入型滤波器、倍压电路、限制器电路和峰值检测电路、直流定位器与峰对峰检测器、齐纳二极体、齐纳二极体整流器、光电元件、集射极接面、集极特性曲线、基极偏压、LED驱动器、建立一个稳定的工作点 Q 、 PNP 电晶体偏压、电晶体偏压、耦合及旁路电容、交流射极电阻、共射极放大器、其他 CE 放大器、串接共射极放大器、交流负载线、射极随耦器、 B 类推挽式放大器、 JFET 特性曲线、 JFET 偏压、 JFET 放大器、 VMOS 电路、差动放大器、运算放大器、非反向电压回授、负回授。

This kind of technology can flex the application of optical amplifier so that a same adaptive amplifier can be used as a pre-amplifier, a boost amplifier as well as a line amplifier.

在光标记交换系统中，可满足由于路由切换导致的光功率损耗大范围动态变化的应用需求。

Later, it makes some comparison with four kinds of modulation technique, and finally, it implements the three-level PWM switching power amplifier with the PWM technique. The power of the amplifier is 2kVA, and the frequency bandwidth is 10～3kHz. In the thesis, the author designs and makes the hardwares of the switching power amplifier. The hardwares contain power inverter rank circuit, control system circuit based on DSP, drive and isolation circuit, and protective circuit. The thesis also analyses the potential safety problems and put forward some solutions for the problems. Furthermore, the thesis accomplishes the software design of the control system, and successfully debugs it. The methods of designing higher power ampilfier are also discussed in the thesis. It analyses the feasibility of the methods, outlines the way of how to design higher power switching power amplifier, and does some experiments with the method of switches-parallelling.

根据电动振动试验系统对开关功放的要求，提出了以电感电流瞬时值控制技术为基础的三电平脉宽调制开关功放的设计方案，并通过系统仿真进行了原理性论证；然后设计并制作了开关功放的硬件，包括功率转换电路，基于DSP的控制电路，驱动、隔离电路以及保护电路；针对开关功放数学模型不易得出的特点，细致分析了模糊自适应PID控制方法，在此基础上编写了控制程序；研制出一台功率为2kVA，通频带为10～3kHz的三电平脉宽调制开关功放；论文中还探讨了实现大功率开关功放的方法，分析了各种方法的可行性，给出了实现大功率开关功放的思路，并进行了并联开关管实现大功率开关功放的实验。

For weak nonlinear distortion, the expressions of total harmonic distortion, the second order intermodulation distortion(IM2 ), the third order intermodulation distortion(IM 3) and intercept point(IP 3) are deduced. With the aid of software Multisim, we simulate transistor common emitter amplifier, transistor common emitter amplifier with resistor in emitter, differential amplifier and differential amplifier with resistor between emitters. The simulational results and theoretical analyses are almost the same.

针对弱非线性失真，推导了总谐波人、二阶互调失真( IM2 )、三阶互调失真( IM3)和截点( IP3)的表达式，借助于 Multisim软件，对晶体管共发放大器、发射极带反馈电阻的失发放大器、差分放大器和发射极间带反馈电阻的差分放大器进行了仿真，并与理论结果作了比较，结果令人满意。

The circuit topology is a voltage feedback amplifier with the slewing characteristics of a current feedback amplifier.

该电路拓扑结构是一个具有电流反馈放大器的电压反馈放大器的回转特性。

In the end, the main content of this dissertation is addressed.In chapter 2, based on the analysis of present vibrators principle and structure, two kinds of transfer functions and frequency response curves of the vibrator, driven by voltage feedback power amplifier and current feedback amplifier, are given separately. And turnover frequencies between different frequency rangs are also given.

第二章分析了标准振动台的工作原理和结构，在此基础上，建立了标准振动台的机械和电气方程，给出了恒压源和恒流源功放激励下的振动台传递函数及幅频、相频特性曲线，列出了不同频段间的转折频率。

When the amplifier output is in either the positive or negative saturated state, the positive feedback network provides a voltage at the non-inverting input which is determined by the attenuation of the feedback loop and the saturation voltage of the amplifier.

不论放大器输出是正是负，只要OP达到输出饱和状态，OP正反馈路径就会在OP同相输入端加上一个电压，该电压的大小由OP正反馈路径的衰减和OP输出饱和时的电压共同决定。

The producer that application LabIEW has carried on fictitiously the signal and fictitious oscilloscope design ,Moreoer deepen to comprehend the negatie feedback toto the action that the improement amplifier performance respect is taked by means of the test ,Research tension series negatie feedback along with the negatie feedback electric circuit performance index quiz means .

运用LabIEW进行了虚拟信号发生器和虚拟示波器的设计，并且通过实验加深理解负反馈对改善放大器性能方面所起的作用，研究电压串联负反馈以及负反馈电路性能指标的测试方法。

Bob Eckert has been chairman and chief executive of Mattel for eight years.

美泰董事长兼首席执行官鲍勃·埃克尔特在任已8年。

The outlook for honors and disgraces carries on and surpasses the traditional outlook for honors and disgraces theoretically, and carries on and develops the theory of construction of socialist mora...

社会主义荣辱观的提出在理论上是对传统荣辱观的一次继承和超越，是对社会主义道德建设理论的继承和发展，在实践上有利于形成良好的社会风尚。