查询词典 compass error

Error than 3 percent in absolute terms the scope, but also an agreement passed the construction area error than the must also be controlled within 3% of absolute value, one of the absolute value of more than 3% of the buyers are entitled to check-out; At the same time, in determining the total building area, the need will be assessed for each site listed 11, which also space-sharing provisions of the property shall not exceed 6 ‰, conducted by the Survey and Mapping Department

错误超过百分之三的绝对值的范围，而且还一致通过了建设面积误差比也必须控制在3 ％的绝对价值，其中的绝对值超过3 ％的买家都有权退房；与此同时，在确定总建筑面积，需要将待分摊的每个网站列出的11个，其中还空间共享规定的财产不得超过6‰，进行测绘部

Compared with GDQR and FEM, the error of displacement was 2.4 percent and the error of force was 4.2 percent in the solutions.

介绍了广义微分求积法的一般原则，对比了用传统DQ法与GDQR在处理截面突变问题中的优劣，研究了用DQ法试解静水压力作用下变截面环向加箍贮液罐圆筒问题，由于变截面处的奇异性问题，所得到的结果不收敛，而采用GDQR重解该问题则得到收敛解。

A simulation model was set up. Simulation outcome shows that compensating torque can be rapidly regulated according to demands of dynamic loading.Stable-state error is less than one percent,and dynamic error is much more less than that of traditional PID.In the

建立了仿真实验模型，运行结果表明：补偿转矩能够根据动态加载的要求进行快速调整；稳态运行速度误差小于1%，动态误差远远小于传统PID控制。

The relative standard deviation,the percent standard error of prediction samples and the percent standard error of calibration samples were used for evaluating the ability of the neural network.

选择红外谱图严重重叠的五种大气有机毒物作为多组分体系。相对标准误差、百分标准预测误差和百分标准校准误差被用于衡量神经网络的性能。

Two errors have been defined in this dissertation, which is mean absolute percentage error (E2) and mean percentage error (E3). The application of the two errors has brought great convenience in building and application of RBFNN model.

在研究过程中还提出了两种误差的概念，即平均绝对百分比误差(E2)和平均百分比误差(E3)，这两种误差的灵活应用，在模型的建立和应用过程中发挥了很大的作用。

This existence of a glimmer of sexual behavior, plus a step to only have into the electrical engineering periodic of error margin but have no accumulation error margin etc.

这一线性关系的存在，加上步进电机只有周期性的误差而无累积误差等特点。

There were many schemes that have been applied to these system to minimize the contouring error, but the effects of these scheme are usually undesire. A repetitive control algorithm was applied here to improve the precision of the system. Experimental results indicated that the periodic error decreased 90% by using the repetitive control method.

另外我们也针对系统的最重要指标—精度—的控制，比较传统伺服控制与往覆式控制理论，在整体系统的要求下整合的可行性并进行相关的实验，而由实验验证往覆式控制理论针对周期性误差信号所具有的特殊补偿现象，并由此得到往覆式控制器的基本特性。

There are many ways to calculate GPS satellite azimuth and elevation, but the precision is low. A new method to decide GPS satellite position using the broadcast ephemeris is presented, the way to checkup the precision is also given, and some research are made to analysis the error feature of the position which is calculated by the broadcast ephemeris as well, the results show the error is periodic.

GPS卫星高度角、方位角计算方法众多，但精度低；针对这点，提出了一种利用广播星历计算卫星高度角、方位角的方法，对该方法能够达到的精度提出了鉴定的途径，并分析了利用广播星历计算卫星高度角以及方位角的误差特点，结果表明利用广播星历计算的卫星高度角、方位角呈现出周期性变化的规律。

A new method to decide GPS satellite position using the broadcast ephemeris is presented, the way to checkup the precision is also given, and some research are made to analysis the error feature of the position which is calculated hy the broadcast ephemeris as well, the results show the error is periodic.

GPS卫星高度角、方位角计算方法众多，但精度低；针对这点，提出了一种利用广播星历计算卫星高度角、方位角的方法，对该方法能够达到的精度提出了鉴定的途径，并分析了利用广播星历计算卫星高度角以及方位角的误差特点，结果表明利用广播星历计算的卫星高度角、方位角呈现出周期性变化的规律。

By measuring missile movement inertia with torsion pendulum, the influences of periodic measurement error, systemic damp, period of swing object and corporative period of t he measured object and swinging object were analyzed. The relation among measurement error of movement inertia, measureme nt period, the period of swing object,corporaˉ tive period of tested object and swing object was proved. The maxi mal ratio between movement inertia for swinging obˉ ject and the measured object under conditions of different errors w as given under typical measurement precision.

通过扭摆测量导弹转动惯量的方法，分析了周期测量误差、系统阻尼、摆动体周期以及被测件和摆动体共摆周期对转动惯量测量精度的影响，得出转动惯量测量误差和周期测量误差、摆动体摆动周期、被测件和摆动体共摆周期之间的关系，给出了在典型的测量精度要求，不同的周期测量误差情况下，摆动体转动惯量和被测件转动惯量之间的最大比值。

When this condition occurs, inbound replication with the source partner is stopped on the destination domain controller and event ID 2042 is logged in the Directory Services event log.

计算机密码学是研究计算机信息加密、解密及其变换的科学，是数学和计算机的交义学科，也是一门新兴的学科。

Instructions: click on the thumbnails to see a larger image, then use the left-right arrow keys to scroll through the slideshow.

使用说明：滑鼠点在小图上即可放大观赏。开启后键盘左右键可用来换照片。