glancing incidence

glancing incidence的基本解释

-

切线[擦地]入射, 掠入射

与glancing incidence相关的网络例句 [注：此内容来源于网络，仅供参考]

Ifσ: I→C is an incidence coloring of G and |C|=k, k is a positive integer, then we say that G is k- incidence colorable andσis a k - incidence coloring of G; The minimum value of k such that G is k -incidence colorable is called the incidence chromatic number of G, and is denoted byχ_i, namelyχ_i = min {|C||σ: I→C is an incidence coloring of G}.

若σ：I(G→C是G的一个关联着色且|C|=k，k是一个正整数，则称G是k-可关联着色的，σ是G的一个k-关联着色；使得G是k-可关联着色的最小的k值称为G的关联色数，记为X_i，即X_i=min{|C||σ：I→C是G的关联着色}。

For stress measurement in films less than 2-3μm thick, the glancing angle method should be used to reach high intensity and low penetration depth. The two commonly used glancing methods are Seemann-Bohlin method and Glancing-tilt method.

SB法应力测试曲线在低ψ角时的数据分散主要由晶体弹性各向异性引起，用弹性常数各向异性理论进行归一化修正后，其线性可得到明显的改善。

Results show that amplitude of displacement excited by vertical incidence wave is larger than that excited by inclined incidence wave and not influenced greatly by the incidence angle. In vertical incidence, amplitudes of displacement of two points at the same altitude along each cavern are basically identical and maximum relative displacement occurs between top and bottom point of the cavern. While in the case of inclined incidence, displacement amplitude on sides meeting the wave is larger than that on leed sides, and maximum relative displacement occurs on left skewback and bottom of the cavern.

结果表明，位移幅值受入射角度的影响不敏感，竖直入射比斜入射情况要大；竖直入射时，各洞室两侧同一高程处的位移幅值基本相同，相对位移差最大部位为洞顶与洞底，而斜入射时迎波面比背波面一侧位移大，且相对位移差最大部位为洞室迎波面的左拱座与洞底。

与glancing incidence相关的网络解释 [注：此内容来源于网络，仅供参考]

glancing incidence：掠入射

正入射 normal incidence | 掠入射 glancing incidence | 掠射角 glancing angle

glancing incidence：掠入角

glancing angle 掠射角 | glancing incidence 掠入角 | gland nut 压紧螺母

glancing angle：掠射角

射出中子 given-off neutron | 掠射角 glancing angle | 掠射碰撞 glancing collision