查询词典 study under a work-study programme

The Study in Basic Principles (1) the study of the basic characteristics about mill design;(2) the study of the general decision—making program in mill design;(3) the study of the structure principle of mill design expert system;(4) the study of the disintegrating mode and solving methods for complex problems;(5) the study of the formalization expression system for layout picture;(6) the study of the design principle for layout design intelligent CAD system.

本文以破碎厂房设计专家系统的研究为突破口，进行了下述开拓性的研究工作。 1。基本原理方面的研究（1）选矿厂设计基本特征的研究；（2）选矿厂设计一般决策程序的研究；（3）选矿厂设计专家系统的结构原理的研究；（4）复杂问题的分解模式和求解方法的研究；（5）配置图的形式化表达体系的研究；（6）配置设计智能CAD系统的设计原理的研究。

Firstly, the paper carried out test study base on the pseudo-static test under horizontal loads on four two-spanned model members of FSMRCSS, including three 1/2-scaled two-storeyed models and one 1/3-scaled three-storeyed model. By the test study, the paper analyzed the test results, including analysis on mechanical property of the constructure under vertical loads, and failure mode, deformation capacity, aseismic performance under horizontal loads and constant vertical loads. The paper also compared LFSWSUMS with FSMRCSS on aseismatic property.

本文首先对三个两跨两层和一个两跨三层的底部大空间框支密肋复合墙结构的1／2和1／3比例模型进行伪静力试验研究，通过对底部大空间框支密肋复合墙结构在竖向荷载及与水平低周反复荷载共同作用下的受力性能的试验研究，探讨了结构的变形性能、滞回耗能和破坏形态，并与框支砌体结构进行对比分析。

The rubber seal issue under operating system has been studied by the theory of dynamic sealing. The deformation and stress distribution of rubber material were calculated under the well in-pressure and sealing out-pressure using then-linear finite element. Through the experimental study of the rubber strength and fatigue, the intensity limit and the fatigue life were obtained. According to the study results, a new type of sealing equipment was designed by adding the reinforcing steel bar into rubber core to reduce the maximum shear stress, so as to solve the problems of dynamic seal under hyperbaric pressure.

采用动态密封理论，针对带压作业系统中的橡胶密封胶芯问题，利用非线性有限元计算了在井压和密封外压作用下的变形和应力分布特征，并通过对密封胶芯材料进行了强度和疲劳实验研究，获得了胶芯材料破坏的原因，进而根据计算和实验研究结果，进一步提出了在胶芯内增加钢筋以减小最大剪切力的改进意见，同时进行了理论校核，并以此为基础设计了新型的密封胶芯，从而解决了带压作业装置高压动密封的难题。

The main research contents are as follows:1. Through massive calculation, analysis and comparison, sum up the similarities and differences between the special-shaped cross sections and rectangular cross sections in mechanical features, between reinforced concrete special-shaped columns and rectangular columns in load-bearing capacity, ductility performance and provide necessary basic concepts and data for further understanding the characteristics of the special-shaped columns;2. Through massive elastic calculations and elasto-plastic analysis, under the preconditions of satisfying the code's requirements for axial compression ratio, limit value of lateral displacement and load-bearing capacity of normal section,oblique section and beam-column joint, under circumstances of different intensity of earthquake, structure dead weight, sort of site and column grid bay dimension, the variation regularity of maximum suitable height of structure, and thus sum up the maximum suitable height of structure for code for the purpose of macro-control while deciding the design scheme;3. Make a preliminary study on the stress feature of reinforced concrete special-shaped column and Z-shaped column of which the ratio of limb length to limb thickness is between 4~5 ,and the preliminary design method is suggested;4. Through elato-plastic time history dynamic analysis of typical projects, check up the weak storey of the special-shaped column structure and yielding, breaking and collapse mechanism to satisfy the earthquake resistant requirement to buildings of remaining stand under strong earthquake;5. Derive for project use simplified calculation formula of vibration period, suitable vibration period, suitable rigidity of special-shaped column structure through theoretical analysis, and provide an easy and practical method for deciding the structure scheme economically, safely and reasonably;6. Based on the study achievements in theory and massive analysis and calculations of this paper, sum up the regularities of inner force, deformation of special-shaped column structure and seismic conceptual design, and thus the suggection of seismic design of special-shaped column structures is presented.

本文研究的主要内容如下：通过大量的计算、分析和对比，总结出异形截面与矩形截面在力学特性、钢筋混凝土异形截面柱与矩形截面柱在承载能力、延性性能等方面的异同，为深入了解异形截面柱的特点提供必要的基本概念和数据；通过大量的弹性及弹塑性计算分析，在满足规程对轴压比、侧移限值及正截面、斜截面、节点承载力抗震验算要求的前提下，在不同抗震设防烈度、结构自重、场地类别及柱网开间尺寸情况下最大适宜高度的变化规律，并在此基础上总结归纳出异形柱结构的最大适用高度规定，可用于规程，以便于在确定方案时起到宏观控制的作用；对肢长与肢厚比在4～5的钢筋混凝土异形截面柱及Z形柱的受力特点进行初步探讨，提出初步的设计方法；通过对典型工程的弹塑性动力时程分析，检验异形柱结构的薄弱层及屈服、破坏、倒塌机制，以达到建筑物大震不倒的抗震设防要求；通过理论分析，推导出异形柱结构自振周期，以及适宜自振周期、适宜刚度的工程实用简化计算公式，为经济、安全、合理地确定结构方案提供简便实用的方法；在本文理论分析、计算以及大量的研究成果基础上，总结归纳出异形柱结构内力、变形的规律及抗震概念设计内容，并在此基础上提出异形柱结构的抗震设计建议。

This thesis introduces the research history of sonoluminescence, the properties and equipments of single-bubble sonoluminescence and the factors affecting the amount of light emission. Based on the experimental realization of SBSL, the experiment in this thesis is to confirm the coherence between the emitting frequency and the driving cycle of SL. Under this feature ,we established the programme of the experiment that measure the angular correlations in SBSL , built the experimental devices and conducted initial measurements .Then we got the conclusion that there is a presence of non-spherical symmetry in the process of SBSL .

本文介绍了声致发光的发展历史，对单泡发光的特性和实现声致发光的设备进行了描述，对影响发光强度的要素做了概述；并在实现单泡声致发光的基础上通过实验验证了单泡声致发光的发光频率与驱动超声频率具有一致性的特点，根据这一特点确立了声致发光角分布测量的实验方案，建立了实验装置，并进行了初步测量，得到在声致发光的过程中存在着非球形对称状态的结论。

In the meantime, the Secretary-General has suggested that the secretariat prepare a programme budget for the biennium 2010–2011 that includes two options: the first would be to upgrade the post of Executive Secretary to the level of Under-Secretary-General and the post of Deputy Executive Secretary to the level the Assistant-Secretary-General.

与此同时，秘书长还提议，秘书处在编制2010-2011两年期方案预算时应包括两项备选方案：第一项备选方案是，将执行秘书的职位提升到副秘书长一级，将副执行秘书的职位提升到助理秘书长一级。

However you do have the ability to ask the HSMP casework team to review an adverse decision in respect of eligibility under the Highly Skilled Migrant Programme.

然而你有能力要求HSMP调查组按高技术的移民程序考察一个不利的决定。最多有两次复查的机会。申请人要求复查必须完成HSMP表格。

The Chinese government has set a Rmb2,000 retail price ceiling for TV sets under the programme.

中国政府为家电下乡计划中的电视机设置了2000元人民币的零售价格上限。

PLC is one kind on the basis of technology of digital computer, electronic control device designed to use under the environment of industry specially, adopt it by memory that can programme, it is last user order not to used for,through figure or introductions of simulation /export, finish such functions confirmed as a series of logic , order , timing , counting , operation ,etc., to control all kinds of integrated equipment of electromechanics and production process.

PLC是一种基于数字计算机技术、专为在工业环境下应用而设计的电子控制装置，它采用可编程序的存储器，用来存储用户指令，通过数字或模拟的输入/输出，完成一系列逻辑、顺序、定时、记数、运算等确定的功能，来控制各种类型的机电一体化设备和生产过程。

Under the new quota, the permanent skilled migration programme will bar entry to bricklayers, plumbers, carpenters and electricians.

根据新的名额规定，永久性高技能移民计划将不包括砖匠、水管工、木工和电工。

Chimborazo and Cotopaxi, took me by the hand.

越过琴博腊索山和科托帕克西山。

This car is in a good condition.

这辆车的状况很好。