查询词典 shear angle

The instructive conclusion was: 1 under the vertical loading, the shear-lag effect was produced badly, more severer under concentrated loading than under uniform loading .2 the longitudinal bending deformation of the beam flange was true of the imitating plane assumption of deformation . 3 the width length ratio was confirmed as the first factor working on the shear-lag effect among all the geometric parameters;4 the shear-lag coefficient of simple-supported box-girder was severer than the continuous box-girder, the shear-lag effect in the inner supported section of continuous beam was much more severer, we need paying more attention for it in designing. 5 the non-liner characteristics of material deformation have littlie influence on shear-lag effect in BGCW. 6 the experiential calculating formulation and calculating diagram for the effective flange width was raised with the only factor of the width-span ratio., but the primary location of axis of bending moments should not be changed while calculating the inertial moment .

研究认为：1室内模型试验和空间有限元分析结果均表明波形钢腹板组合箱梁在竖向荷载作用下，翼板出现了典型的纵向应力剪滞效应。2在竖向荷载作用下，截面高度上各点纵向正应变分布认为可符合"拟平截面假定"，以此作为波形钢腹板组合箱梁抗弯计算的基本假定。3箱梁宽跨比是影响波形钢腹板组合箱梁翼板剪滞效应的主要因素。4连续波形钢腹板组合箱梁的翼板剪滞系数大于简支梁，且连续箱梁内支点截面翼板剪滞效应相当严重，对此需十分重视。5当混凝土翼板受力由弹性阶段进入弹塑性阶段时，材料的非线性特性对翼板的剪滞效应影响甚微。6提出了根据组合箱梁的宽跨比参数来计算翼板有效宽度比的经验公式和计算图表，但箱梁截面抗弯惯性矩的计算不应改变原先的截面中和轴位置。

Yet for thickness shear actuators, due to the shear deformation dominates the plate deflection for shear actuation mechanism, the higher order shear theory can provide more accurate evaluation of the shear strain energy of the plate than the first-order o

但对于厚度剪切型激励器而言，由于激励器主要是引起板的剪切变形，而高阶剪切变形理论比一阶剪切变形理论能更好地反映结构的剪切应变能，因此高阶剪切变形理论可以提供板变形的更为精确的解。

At the same time, under the condition of small strain, firstly, the secant shear modulus was always larger than the tangent shear modulus. Secondly, when the logarithmic coordinates were applied to describe shear strain, the decrease of shear modulus with shear strain could be expressed by reversed S shape curve with two inflexion points, and through analyzing and validating, the deduced equation could perfectly reflect this characteristic. Finally, different stress paths and strain areas would lead to different attenuation trends.

而且，在小应变范围内，割线剪切模量总是大于切线剪切模量；当剪切应变采用对数坐标表示时，剪切模量随着剪切应变的增加而衰减，且衰减的规律都可以表示为带有两个拐点的反S型曲线，经分析验证本文所得公式3可以对此特性进行很好地反映；但应力路径、应变范围不同其衰减幅度不同。

The experimental results show that the impeller with high ratio of circulation to shear is suit to be used in circulation control process, the impeller with low ratio of circulation to shear is suit to be used in shear control process, and the impeller with medium ratio of circulation and shear is suit to be used in circulation and shear co-control process.

实验结果表明，循环与剪切配比高的桨叶适用于循环控制的混合过程，循环与剪切配比低的桨叶适用于剪切控制的混合过程，而循环与剪切配比适中的桨叶适用于循环与剪切共同控制的混合过程。

Park shear, the tree branch shear, walnut and pipe, chain a pipe, two and three claws pull the horse, break the line, every kind of high, the beautiful type, in file in inside type sheet iron shear, the clothing shear, public shear.

4D76 园林剪、树枝剪、核桃钳及管子钳、链条管子钳，二、三爪拉马、断线钳、各种高、中档美式、英式铁皮剪、服装剪、民用剪。

The main influence factors to shear strength test result was systenatically studied by the contrast test,including test machine,shear clamp,distance between shear blade edge,clearance fit between test sample and shear hole,shear rate,effect of machining on sample's outer surface.

通过对比试验，全面系统地研究了剪切强度的主要影响因素：试验设备、剪切夹具、刀口间隙、试样与剪切孔间隙、剪切速度以及试样的表面机加工对钛合金丝材剪切强度的定量影响。

This study uses plate shear instrument that can produce a plate shear and record both torsion and settlement simultaneously. Radius of specimen ring is 10 cm. Height of the specimen is 10.5 cm. The plate shear tests were carried out with initial relative densities 30%. Fine contents 5%~35% of Mai-Liao sand , fine contents 0%、20% of Vietnam-sand, fine content 0%、18% of Ottawa-sand. Reversal and one-way shear, normal stresses 7 kPa~100kPa.To measure settlement and try to get a relative density and to measure cone resistance value after plate shear.

本研究系利用可施加盘转剪力并同时记录扭力与沉陷的圆盘剪力仪进行实验，土样环半径为10 cm，土样高度为10.5 cm，初始相对密为度为30%、细料含量为5%~35%之麦寮砂、0%及20%之越南砂、0%及18%之标准砂，进行单向及往复式盘转剪力试验，载重为7 kPa~100 kPa，试验后量取沉陷量，求得盘剪后之相对密度，并量测盘剪后之圆锥贯入阻抗值。

The safety factor q, one of the important parameters in tokamaks, has directly and accurately been measured in TFTR, DIII-D, JT-60U, and Tore Supra, etc The reversed shear configuration, which has negative magnetic shear in the inner region and positive magnetic shear in the outer region, has been proposed as an advanced tokamak operation Improved confinement and the formation of an internal transport barrier in the negative shear region have been observed One is tending to research physical subjects in the reversed shear tokamaks.

详细近年来，一种新的先进的托卡马克磁场位形—反磁剪切位形已经逐步被人们所认识，在托卡马克装置上普遍观察到了负磁剪切区等离子体约束的显著改善，人们越来越多地关注在反磁剪切位形下托卡马克的物理问题。

Research also provides a finite element method for the study of masonry walls seismic behavior. Firstly, through the stone-dust mortar compressive experiment, pressure experiment, blocks bending experiment, water blocks experiment, 3 slabs shear experiment, diagonal loading experiment and the compression experiment, the values of compressive strength, bending strength, average water weight are obtained. Then the shear breakage of the masonry, behavior of shear stressτvaring withσ, load-displacement curves, ladder-shaped slit shear strength, shear strength of links linking, compressive strength and elastic modulus are also presented.

首先通过石头粉砂浆抗压试验、砖块压力试验、砖块抗折试验、三砖抗剪试验、对角加载试验、短柱的承压试验等测得了石头粉砂浆的抗压强度，砖块的抗压强度，砖块的抗弯强度，以及砌体剪切破坏形态、剪应力τ随正应力σ的变化规律、砌体对角压墙片的载荷-位移关系曲线、阶梯形缝抗剪强度及通缝抗剪强度和弹性模量。

According to dispersion relations, The relations of the incident angle, reflection angle and refraction angle equations with bicrystal parameters and wave vector are obtained respectively. The variation of the reflection angle and refraction angle with the incident angle for certain bicrystal parameters is presented by angle quations.

根据晶体的色散关系解出了入射角、反射角和折射角关于晶体参量及波矢的方程，并根据角度方程给出了在一定参量下反射角和折射角关于入射角变化的关系图，以图示的方法显示了光束在界面处的异常性质。

There had been a moment during the breakfast meeting, though, after the backslapping and the small talk and when all of us were seated, with Vice President Cheney eating his eggs Benedict impassively and Karl Rove at the far end of the table discreetly checking his BlackBerry, that I witnessed a different side of the man.

那次早餐会期间，在表示过关心和寒暄以后，我们所有人坐了下来，我注意观察了一下，副总统切尼面无表情地吃着班尼迪克蛋（Eggs benedict，源自美国，以英式松饼、火腿、水煮蛋以及荷兰酱组合而成），卡尔。罗夫在餐桌的远端谨慎地经常查看他的黑莓手机，我目睹了他所不为人知的一面。

Talk Undelete failed; someone else may have undeleted the page first.

Talk 无法删除选定的页面或图像（它可能已经被其他人删除了）。