查询词典 segment length

Namely, the first, the beginning, end and length of growing season of every type of vegetation is estimated with threshold method and moving average method, and the beginning end and length of growing season of vegetation from 1982 to 1999 is fitted linearly, finally, linear trend of the beginning end and length of growing season of vegetation is analyzed. The second, phenological phase in different years and zones is estimated based on greatest changes of slope method and EOF analysis method, and the result monitored by the two methods is compared, as a result, trend of growing season change from 1982 to 1999 in different latitude zones is better acquired. The third, phenological phase of vegetation in different spatial location from 1982 to 1999 is fitted based on curve. Then, spatial difference rules of growing season of every year and average of multi-year is discussed in article. In the end, lag correlation and linear regress are used to study relation between phenological phase of different types of vegetation, different latitude zones, different spatial places and climate changes.

利用阈值法和滑动平均法逐年估测了每种植被类型的生长季的开始、结束日期及长度；对18年中植被生长季的开始、结束时间和长度进行一次线性拟合，分析了植被生长季的开始、结束日期和长度的线性变化趋势；基于最大变化斜率法和EOF分析法估计了不同年份、不同区域内植被生长季的开始、结束时间及其长度，并对这两种方法的监测结果作了比较，从而得到了较好的不同纬度区域1982～1999年植被生长季的变化趋势；基于曲线拟合了1982～1999年的不同空间位置的植被物候期，然后讨论了每年和多年平均的植被生长季的空间分异规律；最后利用时滞相关分析和线性回归研究了不同类型植被的物候期与气候变化的相互关系，不同纬度带的植被物候期与气候变化的相互关系，植被物候期与气候变化空间相互关系。

So the main study contents of this thesis are as follows: the load distribution pattern along the length beam and the cross beam in the place of node、 the appropriate matching rigidity of the length and cross beams in the action of same anchorage force and the affection pattern discuss on sloping surfaces dip angle、 beam rigidity 、 anchor-rope angle as well as the position of load which affect the load distribution ratio on length and cross beams. In the end it brings forward lattice beam internal force calculated method on the basis of double parameter groundsill model.

鉴于此，本文主要的研究内容是格构梁节点处荷载沿纵横梁的分配规律、同一锚固力作用下纵横梁合理的匹配刚度以及对格构梁纵横梁荷载分配比值可能存在影响的坡面倾角、梁刚度、锚索夹角、加载位置等因素的影响规律探讨，最后提出基于双参数地基模型的格构梁内力计算方法。

While leafstalk length and node length were two important constituent characters of fruit length.

而叶柄长、节间长为果长的重要构成性状。

Firstly, the connection matrices are strongly connected Boolean matrix, it is shown that the maximum length of limit cycles for FBAM is the period index of the product of the connection matrices. Thus, the maximum limit cycle is reachable. Secondly, two strongly connected components are connected by walks, it is proved that the maximum length of limit cycles for FBAM is the max. of the period index of the two strongly connected components if they are prime, otherwise, it is the least common multiple of the two period index. Finally, n strongly connected component are connected in succession, the method for computing the maximum length is described. By different patterns are presented to the networks, diminishing the number of the strongly connected components until only two components.

第一，连接权矩阵为强连通布尔矩阵，此时模糊双向联想记忆网络的最大极限环长度为连接权矩阵乘积的周期指数，从而极限环具有可达性；第二，两个强连通分支有路径连接，此时如果两个强连通分支的周期指数互素，那么网络的最大极限环长度为其最大者，否则，网络的最大极限环长度就等于二者的最小公倍数；第三，n个相邻强连通分支有路径连接，给出了计算最大极限环长度的方法，通过激发模式的变化，逐渐减少强连通分支的个数，直到只有两个分支。

Due to the fact that test application time is proportional to the length of the overlapped vector, except that the length of the overlapped vector is far less than the sum of the length of the original individual test vectors, minimal test application time can be obtained.

由于测试应用时间与重叠向量的长度成正比，而重叠向量的长度要远小于原始测试向量的长度总和，从而减少了测试时间。

The paper is firstly presented that the vector modulus length of no less one inclusion of one polished sample surface,in stead of the max length,can be represented of the max length of multi-inclusions.

本文根据 ASTM E2283-03的原理，提出采用矢量模的方法解决同一检测面中出现多个夹杂物的最大长度问题。

Its decompression architecture requires only a finite state machine and a cyclical scan register whose length is the same as that of the data block. Compared to the length of the cyclical scan register required in Golomb and FDR codes, which is equal to the length of the test vector, hardware cost in the proposed method is less than that in Golomb and FDR codes.

测试源划分技术是解决这一问题的主要方法，它是将ATE中的部分测试功能转移到被测试的芯片上，芯片之外主要建立一个经过变换的测试数据存储源，以减少测试数据的传输，同时在芯片上又不需要花费太多的硬件执行数据变换，实现测试模式的生成。

Methods: To treat freckles and lentigo with Q-Switched Alexandrite laser in different wave length and energy. Wave length 755nm,energy density 5~10J/cm2,frequency:5~10Hz,spot diameter 2~3mm,Wave length 532nm,energy 5~10J/cm2,frequency: 5~10Hz,spot diameter 2~3mm.128 cases of freckle were treated 2 times,32 cases of lentigo were treated 1~3 times,the interval is 3 months.

采用Q开关755nm激光，能量密度为5~10J/cm2；频率5~10Hz；2~3mm光斑直径；Q开关532nm，能量密度2~4J/cm2；频率5~10Hz，2~3mm光斑直径激光对雀斑及雀斑样痣进行治疗，其中雀斑128例，经两次治疗，雀斑样痣32例经1~3次治疗，治疗间隔为3个月，结束治疗后随访24个月。

The present invention relates to a textured yarn with different shrinkage and excellent suede effect, wherein at least one or two kinds of two-component composite yarn having a monofilament fineness of 0.001 to 0.3 denier after dividing or extracting an extraction component are twined around a thermoplastic multifilament yarn, 2 to 350 loops per meter of the two-component composite yarn of at least 1.0 mm in length are formed on the surface of the textured yarn, and more than 95% of the two-component composite yarn loops of at least 1.0 mm in length has a length of 1.0 to 2.5 mm.

本发明涉及具有不同缩率和出色麂装饰效应的变形纱，该变形纱中，在可提取组分分离或提取之后具有单丝细度为0.001至0.3旦尼尔的至少一种或两种双组分复合纱缠绕在热塑性复丝纱周围；每米双组分复合纱2至350个长度至少为1.0mm的弧圈在变形纱的表面上形成，且95％以上的长度至少为1.0mm的双组分复合纱弧圈具有1.0至2.5mm的长度。

Compared with absolute length, relative length has smaller difference, which showed the average relative length of pachytene chromosomes

但14个细胞相同序号染色体的相对长度比较接近，最高标准差为0.435，最低仅为0.136，相对绝对长度而言，差异更小。

If you were not , and OS X just booted normally, have no fear.

如果你没有，和OS X刚刚启动通常，没有恐惧。

I only want to preserve our all .

我只想保存好我们的一切