查询词典 lag angle

Because of this, it is usual to specify the lead angle on the worm, which is the complement of the worm helix angle, and the helix angle on the gear; the two angles are equal for a 90-deg. Shaft angle.

正因为如此，它通常指定牵头角度对蠕虫，它是相辅相成的蠕虫螺旋角，螺旋角对齿轮；两个角度来看都是平等的，为90摄氏度。

The precision of electronic angle gauge is 1Π 7 000 and the total error of Bitterlich angle gauge is 1Π 32. S o the precision of the electronic angle gauge is 200 times as high as general angle gauge and its velocity is higher.

经过分析，电子角规测树精度为1/7 000，而比特利希角规测树精度总误差达1/32，电子角规的测树精度比普通角规高出200倍以上，其速度也较快。

When measuring, based on the segmented contour line of thread, we used the compiled measurement program to calculate and measure the geometrical parameters of the internal taper thread as pitch, half of thread angle and taper angle. Precisions of pitch, half of thread angle and taper angle reached ±0.012mm,±0.17° and ±0.018°. The results satisfied with the technique requirement of production. The reason of error was analyzed.

在测量尺寸时，使用自编程序计算测量内螺纹的螺距、牙型半形及锥角，测量精度分别达到±0.012mm、±0.17°和±0.018°，满足产品的技术要求，并分析了误差产生的原因。

a system of along-track mode sar based on the gps is established.by seeing the gps signal as a chirp,chirp scaling algorithm of this mode with large squint angle is investigated.chirp scaling algorithm is considered more efficient and widely applicable when the bistatic sar system is in side-look or small squint angle mode,but in large squint angle case,the errors caused by taylor expansion are so large that the algorithm could lose its precision.in such a case,an equivalent mono-static sar range mode which has fewer errors than taylor expansion with large squint angle is proposed to substitute the range history of bistatic sar.then bistatic sar images with large squint angles are gotten by common nonlinear cs algorithm.the effectivity of the method is verified by matlab simulation.

摘 要：建立了基于gps的顺轨sar系统模型，通过将gps信号等效为chirp信号，研究了在该模式下的大斜视角chirp scaling算法。在正侧视或小斜视情况下，cs算法具有较好的聚焦性能和广泛的适用性，但在斜视角较大的情况下，该算法将散焦而不能成像，因而提出了用等效的单基地距离模型来代替双基地距离历史的方法，解决了大斜视角情况下距离模型二阶近似误差较大的问题，并结合单基地非线性cs算法，实现了在大斜视角情况下的基于gps反射信号的双基地sar高精度成像，最后通过matlab仿真进行了验证。

At the peak point of backward swing, the vertical height from the center of the ball to the ground was 1.34 ±0.01 meters, the angle of the shoulder was 82 ± 2.5 degrees and the angle of the elbow was 161.35 degrees. During release, the vertical height was 0.13 ±0.01 meters, the angle of the shoulder was 48.00 ± 3.64 degrees and the angle of the elbow was 160.71 degrees.

所得具体结果如下：在后摆最高点时，球体中心点距地面之垂直高度平均为1.34 ±0.01公尺，肩关节角度为82 ± 2.5度，肘关节角度为161.35度；而在出手瞬间球体中心点距地面之垂直高度平均为0.13 ±0.01公尺，肩关节角度为48.00 ± 3.64度，肘关节角度为160.71度。

The theoretical and experimental investigations of discus flight indicate the following useful conclusions:the optimum combination of throw angle and discus inclination angle is 35°/26°at zero wind,while 45°is not the best release angle due to the aerodynamic force;different combinations of throw angle and inclination angl...

由于气动力的作用，45°并非铁饼的最佳投掷角度，实验和理论研究表明：无风时35°/26°的投掷角/倾角组合最佳；顺风和逆风投掷必须采用不同的投掷角/倾角组合才能获得当地条件下的最好成绩；铁饼出手时25r/s的自转速度已经可以满足稳定性的要求。

According to the functional requirements of adaptive front-lighting system, the relationships between the yaw angle and pitch angle of light axis in AFS and vehicle parameters, including speed, steering wheel angle and pitch angle of vehicle body are derived, thus a kinematics model for AFS is set up.

根据自适应前照灯系统的功能要求，推导了车辆参数（车速、转向盘转角和车身仰俯角）与车灯光轴沿水平和垂直两个方向的偏转角度之间的关系，建立了自适应前照灯系统的运动学模型。

In view of the feature of ball end milling process, the model of accurate cutting area is presented which considers the advance angle of cutting in and the lag angle of cutting off.

针对球头铣刀的切削特点，给出了考虑切入提前角和切出滞后角的精确切削区间模型。

The optimized exhaust lag angle and intake advance angle of the EQ6100 engine are calculated by means of alternated one dimension searching method vary with engine operating conditions.

采用轮流一维搜索法，计算出随EQ6 10 0发动机工况变化的优化的排气门延迟关闭角和进气门提前开启角。

Results show:(1) coupling of elastic deflections with rigid motions is distinctive;(2) computations of two methods are in good agreement with test data, when rotation angle is small;(3) when rotation angle is large, couplings increase distinctly and the differences between the results of the two computational methods increase;(4) the bending stiffness has evident effect on the coupling, and the coupling will increase with the decrease of bending stiffness;(5) in case of the blade is relatively soft, the calculated values of phase lag and amplitude augment based on infinitesimal rotation will exist.

计算分析表明：(1)弹性桨叶存在较明显的刚性运动和弹性变形耦合；2）挥舞角较小时，两种处理方法计算结果一致，均与试验数据吻合较好；(3挥舞角较大时，刚柔耦合增强，两种处理方法的计算值差别较为明显；(4)桨叶弯曲刚度对桨叶刚柔耦合特性有较明显影响，刚度越小，耦合越强；(5)桨叶如果比较柔软，小转角处理方法计算值相对有限转角处理方法，相位滞后、幅值增加均较为明显，计算桨叶动响应时需引起注意。

For every one of my New Year resolutions, I have been a backslider for years.

说到我的新年决心，我每年都做

With empathy and focus on a feeling level, we can all relate to the common ground of mutuality of emotions.

有了同情心和感觉上一级的重点，我们都可以涉及到相互的情感共同点。