查询词典 experimental error

On a grating type gear integrated error measuring equipm ent, this technique employs the three-point method error separation technique fo r separation of the systematic error of the measuring chain of equipment spindle system including measuring worm error, grating transducer error, bearing rota ry error etc.

在一台光栅式齿轮整体误差测量仪上，它用三点法误差分离技术能分离开仪器轴系测量链的系统误差(包括测量蜗杆误差、光栅传感器误差、轴承回转误差等)和被测齿轮的全谐波误差。

The comparison error rate of LSD and Duncan is equal toα, but their experimental error rate is large toα. The comparison error rate of SNK, Scheffe, Bonferroni, Sidak are smeller toα, as well as experimental error rate. The power of test of SNK, Scheffe, Bonferroni, Sidak are smeller to LSD and Duncans. When unbalance design with small sample size, the power of SNK, Scheffe, Bonferroni, Sidak are little small.

LSD检验、Duncan检验的比较错误率接近检验水准，但二者的实验错误率远远大于检验水准；SNK检验、Scheffe检验、Bonferroni检验、Sidak检验的比较错误率和实验错误率均小于检验水准，但这三种方法对均数的敏感度不及LSD检验和Duncan检验；正态分布方差齐各组不均衡且为小样本时，Scheffe检验、Sidak检验、Bonferroni检验的β_2，值均较大。

Experiments were carried out to verify the static model. Experimental results show that the experimental curve matched well with the simulated curve, and there was certain error between them (maximal static error is 0.035 rad). The error cause was analyzed. Then the experiments were carried out to measure the dynamic performances of the side-sway joint. Experimental results show that the step response time of the joint was about 2 s steady value's tolerance zone ?

完成了侧摆关节静态特性试验，试验结果与仿真曲线基本吻合，验证了静态模型的正确性，但存在一定误差（最大静态误差为0.035 rad），分析了误差原因；对侧摆关节进行了动态特性试验，试验结果表明对于不同的期望值角度阶跃信号，侧摆关节开环阶跃响应时间大约是2 s

All the indexes were tested in 2 -. 4 .. 6 weeks of operative intervals respectively. Results:(1) The general observation in the experimental group ,such as spirit, hair, body weight and activity ,was superior to that in the control group.(2) The recovery rate of sciatic nerve functional index (SF1) was statistically significantly higher in the experimental group than in the control group .(3) electrophysciological indexes: m the experimental group ,the tardy rate of induced motorius action potential ,recovery rates of the amplitude of compound muscle action potential and twitch tension and tetanic tension of triceps surae muscle ,were significantly higher than in the control group.(4) Compared with the control group ,the triceps surae muscle wet weight was significantly greater in the experimental group.(5) histomorphological indexes: the count of myelinated nerve fibers ,diameter of regenerated axon, thickness of nerve myelin sheath and area of capillary were much more in the experimental group than in the control group.(6) observation of ultrastructure with the transmission election microscope: more abundant organell a and maturer myelin sheath lay in the injured peripheral nerve of the experimental group, while not lay in the control group.

分别在木后第2、4、6周时进行各项指标的检测，结果发现：（1）实验组SD大鼠在整个实验过程中，其精神、毛发、体重，运动灵活性等一般情况优于对照组；（2）实验组的坐骨神经功能指数恢复率显著优于对照组，P＜0.01；（3）神经电生理指标：实验组运动神经诱发电位潜伏期的延迟率显著优于对照组，P＜0.05；复合肌肉动作电位振幅的恢复率显著高于对照组，两组比较第2周时P＜0.01，第4、6周时，P＜0.05；小腿三头肌单收缩力和强直收缩力的恢复率实验组显著高于对照组，P＜0.01；（4）小腿三头肌湿重的恢复率，第2、4周时实验组高于对照组，差异非常显著，P＜0.01；第6周时，差异仍显著，P＜0.05；（5）组织形态学指标：有髓种经轴突计数、再生轴突直径的恢复率，毛细血管面积，实验组均显著大于对照组，P＜0.01、P＜0.05、P＜0.001；实验组髓鞘厚度的恢复率也显著高于对照组，第2周时P＜0.01，第4、6周时，P＜0.05；（6）透射电镜超微结构观察：实验组再生轴突中细胞器丰富，髓鞘结构成熟，神经再生情况优于对照纽。

The common method, that all strong-correlation terms of the model are eliminated, can bring the loss in the engineering application, so the new method is proposed that the identified model reserves some correlation. The augmented matrix A is constructed by the outputΔW and the matrix S. The"determinating order based on ratio of determinant"is brought out to screen the strong-correlation terms in the structure identification. The latent root estimation is improved in screening the eigenvalues and eigenvectors. Thus the estimation precision is improved greatly.The consistence check of guidance instrument error coefficients of flight test and ground test is the purpose of flight experiment. The causes of inconsistency of the two models are analyzed. The hypothesis test of linear regression model based on F statistics is proposed to check the consistence.Finally, the instability of error coefficients is probably caused by the change of the flight environments, therefore, the relation between the error coefficients and flight environment is analyzed. The approach is presented to identify SINS guidance instrument error models and compensate the error in the segmented sections corresponding to the change of vertical acceleration of aircraft.

在结构辨识中，常用的方法由于将模型中的强相关项全部剔除而给工程应用带来损失，因此，本文提出了新的有益思想，即在保留一定相关性的基础上进行辨识：将输出向量ΔW与环境函数矩阵S构成增广矩阵A，然后采用"比定阶行列式"来剔除相关向量的方法，这样既可以尽可能多地保留了对落点影响大的强相关参数，又可以对落点影响小的强相关参数给予剔除；在参数估计中，改进了特征根估计中特征根和特征向量的筛选方法，提出"近零"准则，从而大大提高了参数估计的精度；再者，鉴于天地模型"一致性"检验是飞行试验和SINS制导工具误差系数分离的主要目的，因此，本文又深入分析了造成天地模型不一致的原因，提出了采用基于F统计的线性回归模型假设检验方法来进行捷联制导工具误差模型的天地"一致性"检验；最后，鉴于飞行环境剧烈变化可能会对惯性仪表误差系数稳定性带来一定的影响，因此本文深入地分析了SINS制导工具误差系数与外界环境的关系，提出了基于过载变化大小的分段辨识和分段实时补偿的算法。

The details as follow: 1.Based on rules about form error in GB, mathematical models of form error are established including straightness error on the base of minimizing zone method、least-squares method and two dots linked method ; flatness error based on minimizing zone method、lease-squares method、diagonal line and three dots method; circularity and cylindricity error based on minimizing zone method、lease-squares method、minimum circumscribed circle and maximum inscribed circle.

具体内容如下：根据国标中形状误差的相关规定建立了各种要素评定方法的数学模型包括：直线度的最小区域法、最小二乘法、两端点连线法；平面度的最小二乘法、最小区域法、对角线法、三远点法；圆度和圆柱度的最小区域法、最小二乘法、最小外接圆法、最大内切圆法。

The adaptive program is calculated by T-B stress recovery scheme and z-z error estimation, the error is estimated by energy norm of difference of recovery stress and meshless stress. If the local relative error exceeds the limit relative error, then new nodes will be generated at the high error area.

本研究的自适应方法采用TB应力平滑技术和Z-Z误差估计，利用平滑应力和无网格法所得应力解差值的能量范数来估算误差，如果局部相对误差超过了允许误差，则在高误差域插入新的离散点进行加密。

Besides, we have studied deeply error of two kinds which appeared frequently in the hypothesis testing (error of the first kind and error of the second kind), including the relations to error of two kinds and its effect to the result of hypothesis testing and the effective control of error of two kinds so as to be satisfying and etc.

另外，对假设检验中经常出现的两类错误（第一类错误和第二类错误）也作了深入的探讨，其中涉及到了两类错误之间的关系，两类错误对假设检验结果的影响以及如何有效的控制两类错误使之达到令人满意的程度等。

In this paper the effects of scanning truncation error, scanning position error, random amplitude and phase error, and multiple-reflection error in near-field antenna measurement are analyzed; error equations and the uncertainty of measurement are obtained through computer simulation; compensated techniques for reducing the effects of measurement errors in near-field antenna measurement are presented and the formula and arithmetic of phaseless near-field techniques are derived.

本文从解析法和数值仿真两个角度深入分析口面天线近场测量中扫描面截断误差、扫描面位置误差、随机幅相误差、多次反射误差等误差源对天线远场特性测量精度的影响，一方面从理论上给出相应的误差方程，另一方面建立误差分析模型，通过计算机模拟，得到不同误差条件下测量结果的不确定度，并介绍了减小这些误差的修正方法，推导无相位近场测量的公式和算法。

The computation implies that the influence of truncation error of up/downwards continuation is about 0.001 m2·s-2, the maximum error is only 0.11 m2·s-2, which can be ignored in CHAMP gravity field recovery. The influence of the reference gravity field error of up/downwards continuation is less than 0.1 m2·s-2 in general, but the maximum error can reach 1.3 m2·s-2. To reduce this error, a high-precision gravity field model should be used in the up/downwards continuation.

计算表明：延拓误差中的截断误差部分影响量级约0.001 m2·s-2，最大误差仅为0.11 m2·s-2，可完全忽略；延拓误差中的参考重力场模型误差影响随参考场选取的不同而有所差异，整体而言小于0.1 m2·s-2，但最大误差可达1.3 m2·s-2，采用高精度的参考重力场模型能大大减小延拓误差影响。

Chinese traditional virtue is humility and wariness,the compliment and praise to the others should be declination

中国人的传统美德是谦虚谨慎，对别人的恭维和夸奖应是推辞。如

We bought this house on the never-never.

我们以分期付款的方式买下这座房子。