查询词典 dropping liquid

The distribution of the liquid film was got, and the effects of helix angle, geometry of the channel, liquid mixing and liquid properties on the liquid film was also studied.

考虑表面张力和重力的作用，利用流体力学的基本方程建立单组分流体在水平螺旋槽管的管壁形成液膜的拟线性模型 3。

Why do people have the inspiration to make liquid seals ? First of all, no matter how tight you press the solid seals , they can't fill in those uneven places on the joint face, so gap always exists. But liquid seals can fill in the dent and present good sealing function. Meanwhile liquid seals have stickiness so they have adhesive force to metal adjoining planes, which is helpful to seal. Besides the stickiness of liquid seals is high so they will not move easily, which can ensure the leak tightness.

人们之所以会有液体密封件的灵感，首先是考虑到固体密封件无论怎样压紧，也不能完全填满接合面上的凹凸不平，在界面上总会存有间隙，而液态密封件却能将全部凹陷填平，呈现出良好的密封效果；同时，液态密封件具有一定的粘性，对金属接合面具有一定的粘附力，有利于密封，而且液态密封件的粘度是很高的，很难发生流动，从而进一步保证了密封性。

Its products cover: vehicle lubricant (Gasoline Engine Oil, Diesel Engine Oil, General-Purpose Oil for Gasoline and Diesel Engines and Vehicle Gear Oil), auxiliary vehicle product (brake liquid, auto-transmission liquid, lubricating grease, anti-freezing liquid, steering gear oil, shock absorber oil, water tank coolant and glass cleaning liquid), motorcycle lubricant( mobile oils for four-stroke and two-stroke motorcycles, gear oil and disc brake oil), industrial lubricating oil (hydraulic oil series, air compressor oil series, industrial gear oil series, bearing oil scries, textile industrial oil series, heat treatment oil series, metalworking oil and special anti-corrosion oil).

产品系列涵盖：车用润滑油（汽机油、柴机油、汽柴通用机油和车辆齿轮油）；车用辅助产品（刹车液、自动传动液、润滑脂、防冻液、方向机油、减震器油、水箱宝和玻璃清洗液）；摩托车润滑油（四冲程、二冲程摩托车机油、齿轮油和碟刹油）；工业润滑油（液压油系列、压缩机油系列、工业齿轮油系列、轴承油系列、纺织系列用油、热处理用油、金属加工油及特殊防锈油）。

This method can be applied to any thermodynamic model, including activity coefficient model and EOS model, and this work extends phase analysis from liquid-liquid phase splitting to liquid-liquid-vapor phase splitting.

经多个实例的测试表明，LCPSO适用面广，既可用于超额自由能、状态方程等各类热力学模型，又能克服混合模型一阶不连续的困难，应用范围从液液相分裂拓展到汽液液相分裂。

When gas superficial velocity was about equal to liquid superficial velocity, the probability density function of liquid holdup had a twin-peaked, when liquid superficial velocity was constant, one of the peaks would fade out and disappear with the in crease of gas superficial velocity. Through using the characteristics, the relative size of gas and liquid superficial velocity can be set initially.

在段塞流动中，当气相折算速度和液相折算速度相差不大时，持液率概率密度函数呈双峰分布；当液相折算速度不变时，随着气相折算速度的增大，持液率概率密度函数第2峰值逐渐减小，直至消失而变为单峰分布；利用这一特征可初步确定段塞流动中气、液相流量相对大小。

A series of erosion-corrosion test has been done to J55 steel under the influence of current of gas-liquid phase by indoor self-made devices, and the corrosion mechanism of current of gas-liquid phase to oil pipe's inner surface has been got. The results show that oil pipe's inner surface will be corroded fleetly by liquid medium and corrosion products will form on it. But at the same time, the corrosion products or protective layer will be removed from the inner surface of steel pipes under the alternate impact of high speed gas and liquid flow, and on this bare steel surface corrosion film will form again and be removed again. Thus, by these ways the corrosion is exacerbated. Surface erosion-corrosion failure comes into being with the circulation of this process going on.

本文主要在气液两相流作用条件下，通过室内自制装置，对管材钢J55做了系列冲刷-腐蚀试验，结果表明，气液两相流对钢管内表面冲刷－腐蚀的机理是钢管内表面会受到液体介质的快速腐蚀，生成腐蚀产物，同时钢管金属表面不断被具有高流速的气液相交替地冲击，不断地从金属表面脱去保护膜或腐蚀产物，裸露的钢表面又会被介质快速腐蚀形成腐蚀膜后，再被两相流冲掉，如此反复，造成管内金属表面膜的连续破坏，使腐蚀加剧，最终导致钢铁表面的冲刷腐蚀失效。

Third, the physical indicators: transparent liquid or slightly yellow liquid, density (g/cm3): 1.0 ± 0.02, PH = 9.0 ± 0.02 d, the scope of application: optical glass, diamond, mobile glass, liquid crystal display, liquid crystal glass, optical lenses , optical lenses, glass instrument, P3 wash Lilongwe, silicon and so on.

三、物理指标：透明液体或微黄色液体，密度（g/cm3）：1.0±0.02，PH=9.0±0.02 四、适用范围：光学玻璃、水钻、手机玻璃、液晶显示屏、液晶玻璃、光学镜片、光学透镜、仪表玻璃、P3洗利隆、硅片等。

Aimed at ultra-deep and viscous oil reservoir′s feature in the Tahe Oil-Field, combining blending light dropping viscosity evaluation, utilizing polyphone pipe flow calculation, on the basis of the study of high viscosity oil characteristic and deep well lifting technique, deep well high-viscosity oil blending light dropping viscosity optimum design model is ana.

针对塔河油田超深层稠油油藏的特点，在对稠油特性及深井举升工艺研究基础上，结合室内掺稀降粘评价，利用多相管流计算方法分析深井稠油掺稀降粘优化设计模型，对掺稀降粘工艺在塔河油田的应用在理论上进行了深入分析和评价。

The molecular sieve is prepared in the steps: at the room temperature, hexadecyl trimethyl ammonium bromide is mixed and dissolved with the sodium hydroxide, and is added with TEOS in dropping way, and simultaneously added with Me metal salt water solution and lanthanum nitrate solution in dropping way; the pH value of the mixed solution is adjusted by acetic acid to be 10 to 11, and is mixed for 1 to 2 hours after being stabilized; the sol is moved into a polyfluortetraethylene bottle to be heated and crystallized for 2 days in the oven at the temperature of 100 DEG C; after filtering, washing and drying for nights, and being calcined in a muffle at the temperature of 550 DEG C for 3 to 7 hours, the dual-metal-atom improved MCM-41 mesoporous molecular sieve is obtained.

该分子筛的制备为室温下，将十六烷基三甲基溴化铵和氢氧化钠混合溶解，搅拌并滴加入TEOS，同时滴加入Me金属盐水溶液和硝酸镧溶液并搅拌，用乙酸调节pH值至10～11，稳定后搅拌1～2小时，溶胶转入聚四氟乙烯瓶中在100℃下烘箱水热晶化2天，经过滤、洗涤、干燥过夜，马弗炉550℃焙烧3-7h，得双金属原子改性MCM-41介孔分子筛产品。

The action of anti-dropping by adding line phenolic-formaldehyde resin into PE-IFR was studied. Configuration and structure of intumescent char was observed with SEM and the mechanism of anti-dropping was discussed.

考查了线型酚醛树脂对聚乙烯膨胀阻燃体系的防熔滴作用，并通过扫描电镜观察膨胀炭层的形态和结构，对线型酚醛树脂的防熔滴机理进行了探讨。

It has to be computed by the host for the actual clock rate.

主控制器可以用来计算实际的时钟速率。

Let's see what you got.

让我看看你的东西