查询词典 dropping liquid

USE - Separation of gold from cyanogen group gold-containing liquid, such as metal-plating exfoliation liquid, for carrying out quantitative analysis of gold in cyanogen group gold-containing liquid.

该方法的使用性在于：从氰类含金液中分离金，并在此溶液中进行金的定量分析。

The complexes of disk - like crown ether liquid crystal with Eu have theproperties of liquid crystals and havn't the properties of fluorescence. The complexes of disk -like crown ether liquid crystal with Eu and β-diketone have the properties of fluorescence and electroluminescence.

盘状冠醚液晶Eu配合物具有液晶性质而无荧光特性；盘状冠醚液晶与EuⅢ）和β-二酮形成的配合物具有荧光特性，和电致发光性质。

The capacity is large, which can reach above 75% space of the drum. Only 1:1 liquid percentage would meet the technical requirement, the water consumption is small. The liquid in the drum can reach 3/4 level of drum. Therefore the fall of the skins is only 0.7 meter at maximum. The liquid moves as the pattern "8" in the drum, which can reduce skin defects such as grain cracking, loosing and so on.

装皮量大：装载率可达到75%以上，耗水极少，一般液比在1：1以上即可满足工艺要求，机械作用适中，鼓内液面可达鼓径3/4以上，因此皮张最大落差只有0.7m左右，且皮液在鼓体转动时呈∞字型作副运动，可减少裂面、松面、黑漆不掉等质量缺陷。

The liquid level of separator at gathering station uses dual－figure control and continuouly detecting the liquid level of the separator by differential liquid level transducer.

气体在集气站内的初脱水及排水计量是由高效分离器完成的，因此有效地控制分离器内的液面是个关键问题。

Coolant liquid after throttle valve expenditure of relief after a low-temperature low-voltage gas liquid mixed fluid, after separation into ammonia liquid separation devices for invalid after steam vaporizer, to evaporation endotherm.

制冷剂液体经过节流阀节流降压后成为低温低压的汽液混合流体，经过氨液分离器分离掉无效的蒸汽后供往蒸发器中蒸发吸热。

Coolant liquid after throttle valve expenditure of reliefafter a low-temperature low-voltage gas liquid mixed fluid, after separation into ammonia liquid separation devices for invalid after steam vaporizer, to evaporation endotherm.

制冷剂液体经过节流阀节流降压后成为低温低压的汽液混合流体，经过氨液分离器分离掉无效的蒸汽后供往蒸发器中蒸发吸热。

Person who compress refrigeration according to refrigeration principle the compressor , condenser , choke valve and evaporimeter, and for make refrigeration to be efficiency even more high and operating still more safer assisting equipment Such as the oil separator, person who store liquid,, angry liquid separator , circulation store liquid barrel , collect oil device , person who drop a hint , valve piece , instrument ,etc.

压缩式制冷是根据制冷原理将压缩机、冷凝器、节流阀和蒸发器，以及为了使制冷效能更高、运行更安全的辅助设备（如油分离器、贮液器、气液分离器、循环储液桶、集油器、放空气器、阀件、仪表等）用管道连接组成的一个闭合制冷循环。

To avoid individual influence, liquid surface tension is measured by detecting angles of incidence at cylindrical liquid menisci instead of detecting climb height of liquid on flashboard.

通过测量激光束两边沿在液体表面的入射角来求得表面张力系数，解决了插板法测液体表面张力系数的液面上升高度和接触角检测难题，避免了人为因素的影响。

This thesis demonstrates the pre-polymers in a polymer-dispersed cholesteric liquid crystals can be polymerized into a polymer film, which can eliminate the aligning capability of the homogeneous alignment layer. Thereafter, the textures of the cholesteric liquid crystals in UV-cured region can be changed from reflective planar texture to the scattered focal conic one. Additionally, the clearing temperature of the liquid crystals can be reduced by doping with chiral dopant or monomers. The cause is the increase of the impurity concentration in LCs. In other words, if the monomers are polymerized, the clearing temperature of LCs in that region should increase due to the decrease of the impurity concentration. Therefore, impurities associated with doping with monomeric and chiral dopants cause the clearing temperature of LCs in cured region to differ from that in uncured region.

本文中，我们提出在高分子聚合物薄膜之胆固醇液晶(polymer-dispersed cholesteric liquid crystals，简称PDCLCs)中，利用紫外光使PDCLC中的单体聚合成薄膜，此即为光引致聚合反应，而该薄膜将原本在表面所作的配向膜覆盖且破坏其配向能力，使胆固醇液晶由原本反射的planar结构转换成散射的focal conic结构；另外，有关液晶材料的相变温度会由於掺杂手性分子或单体而降低，此因液晶材料内『杂质』浓度增加，而造成的液晶材料之不纯度增加，最终导致相变温度降低，若搭配上述光引致聚合反应，则由於光照区之单体聚合，使该区域单体占总材料之比例下降，即不纯度降低，进而使液晶材料之相变温度上升，该区域之相变温度与未照光区有所不同。

Electrostatic forces are employed to manipulate the shape of liquid polymer lens. Surface profile distortions of the liquid lens result in its focus variability. UV light is employed to cure the liquid lens when its surface profile and focal spot are appropriate. Therefore, aspherical micro-lens with nice optical imaging and focusing abilities can be fabricated.

在实时进行光学检测的条件下，选择光固化材料，利用电场作用操控液滴透镜的面形实现变焦，在检测到较好的透镜面形和聚焦状态时，采用紫外光固化技术使液滴透镜固化，可制作具有良好光学成像和聚焦性能的非球面微透镜。

Panorama Many people are dancing in a large sitting room.

在一个大客厅里，许多人在跳舞。

We fully understand how a microwave oven cooks food, it is first necessary to talk ...

我们充分理解一个微波炉煮的食物，这是首先要谈。。。