查询词典 additive compound

In 2002,Bandi Group Lubricant department co-worked with several international research institutes and got excellent achievement in Lubricant, and had researched the fifth generation ofadditive---Bandi iron additive,produced by Bandi iron additive.

2002年，邦迪集团润滑油事业部与国际多家科研机构合作，取得突破性进展，共同研制出划时代意义的第五代添加剂——邦迪离子添加剂。

A total of 75 significant digenic interactions were detected, most of them were non-QTL × non-QTL interaction; most of the interaction types were additive × dominance interaction and dominance × additive interaction.

共检测到75对互作位点，大多数互作属于非QTL位点与非QTL位点之间的互作，互作类型以加性显性互作和显性加性互作为主。

A worked example was used to illuminate the application of analyzing additive by additive epistatic variation.

通过估算实际水稻种子性状数据，说明在经典数量遗传研究中，加加上位变异分析是可行的。

The effect of hydrophobic additive on the seed precipitation from sodium aluminate solution was studied by adding fatty acid and heneicosane at different proportions. The results show that when the mass fraction of fatty acid is in the range of 32%-49% and the additive concentration in sodium aluminate solution is 150×10-6 g/L, the rate of precipitation increases, but the particle size of Al3 and Al2O3 reduces.

摘 要：研究了疏水性添加剂脂肪酸类阴离子表面活性剂与21-碳烷不同配比对铝酸钠溶液分解产生氢氧化铝和氧化铝的粒度、强度及分解率的影响，考察了产物Al3和Al2O3的强度和粒度之间的关系，探讨了添加剂影响铝酸钠溶液晶种分解的相关机理。

The experimental results showed that SiC ultrafine powder was synthesized at 1500℃for 120 minutes by used rare earth lanthanum as additive. Its primary particle size was about 100nm and aggregated particle size was about 360nm and the particle shape was regulation, non-aggregation and well dispersibility. While the rare earth ceria used as the additive, SiC ultrafine powder was synthesized at 1500℃for 150 minutes but the particle shape was irregulation and seriously agglomerated and had numerous crystal whiskers.

实验结果表明：以稀土镧为添加剂时，在1500℃×120min合成工艺下，可以合成出一次粒径为100nm左右，二次粒径为360nm的SiC细粉，且SiC粉体颗粒形状规则，无团聚，分散性好；以稀土铈为添加剂时，在1500℃×150min合成工艺下，也可以得到单相的SiC，但SiC粉体颗粒形状不规则，有大量晶须存在，且团聚严重。

The stabilities of the extract from sanguisorba under different pH, light, heat, ultraviolet ray, oxidant, reducing agent and additive agents were studied. It was indicated the products could widely used in the condition of weak acid or neutral, while they were not stable to heat and light, so they should be used without light and at low temperature. The products had a strong ability to withstand ultraviolet ray. They could easily be oxidized and degraded by oxidant while they were not easily affected by reducing agent and were almost not affected by additive agents. The extract from the stem of sanguisorba was analyzed by UV and FTIR, showing that the structures of the active components were not changed during ultrasonic wave extracting.

研究了pH值、光、热、紫外线、氧化剂、还原剂以及添加剂对地榆提取物稳定性的影响，结果表明地榆提取物适合弱酸或中性条件下使用，使用范围比较广；但对光热稳定性较差，适合在避光低温的环境；具有很强的抗紫外线能力；氧化剂对地榆提取物稳定性影响较大，会加速其降解，还原剂对地榆提取物影响不大；其他添加剂对其稳定性几乎没有影响；并通过UV和FTIR光谱分析，超声波浸提没有对地榆根茎中有效成分的结构发生改变。

Effect of additive ZFS on SiO2 content in the coating was studied, and the action mechanism of additive ZFS during composite electrodepositing was analyzed.

结果表明：ZFS共沉积促进剂可以明显提高SiO2微粒在镀层中的沉积量，并且无需对SiO2微粒进行镀前特殊处理。

The estimation of additive and dominance effects through QTL analysis by onedimensional search while ignoring epistases showed similar accuracy to that by two-dimensional search by including epistases. Existence of epistases could decrease the precision for the estimation of additive and dominance effects. The estimation of genetic main effects would be biased if ignoring the interaction effects of QTL×environment . Joint analysis of multiple environments including QE interaction effects could increase the precision for the estimation of genetic main effects.

忽略上位性效应的一维搜索QTL分析对加性效应和显性效应的估计精度与包括上位性的两维搜索QTL分析对这两种效应的估计精度相差不大，上位性的存在可能会降低对这两种效应估计的精度；忽略QTL×环境互作效应会导致对遗传主效应的有偏估计，而包括QE互作效应的多环境联合分析能够提高对遗传主效应的估计精度。

Fly ash used as the main raw materials, incorporated with sintering expansion additive and fluxing additive in different ratio, were sintered high-strength lightweight aggregates of fly ash in the laboratory-controlled electric furnace.

采用粉煤灰为主要原材料，掺入不同比例的助胀剂和助熔剂，在实验室利用可控式电热炉，进行了高强粉煤灰烧胀陶粒的试验研究。

Through the calculation and analysis for additive stress of main reducing gear's fast speed shaft in three high mill of Jisteel medium plate plant,expounds that the additive stress produced in the pro cess of working of parts for rolling mill, shearer and blanking press with balance wheel to the influence of shaft's strength is not to be ignored.

通过对济钢中板厂三辊轧机主减速机高速轴的附加力的计算与分析，阐明轧机，剪切机，冲压机械等带飞轮的部件在工作过程中所产生的附加应力对轴强度的影响是不应忽视的，在设计，维护和修理时要加以注意。

The Master of Science degree program in Economics features a curriculum that is flexibl...

在经济学理学硕士学位的课程计划的特点是灵活而全面的方法，在理论和应用课程培训工作。

This module is used for constructing and visualizing 3D models.

该模块是用于建设和可视化的三维模型。