查询词典 adder amplifier

One is auto-zero and the other is chopping. The chopping amplifier with its many parts of modulation switches, pre-amplifier, band-pass selective amplifier, and voltage follower and demodulation switches is designed. The circuit is simulated with HSPICE to optimize. The residual offset of microvolt and the equivalent input noise PSD of 70 nV /Hz were obtained.

zero和斩波Chopping 对失调和噪声的影响，具体针对传感器的信号要求进行了斩波放大电路的调制，预放，带通选择放大器，电压跟随和解调等各个部分的设计，电路使用Hspice进行了仿真优化，达到了微伏量级的残余失调和70 nV /Hz输入等效噪声PSD。

The company has leading products: 1 W, 10W, 40W broadband microwave power amplifiers ,2-18 GHz microwave broadband hybrid integrated amplifier, 6-18GHz microwave broadband hybrid integrated amplifier, broadband low-noise amplifier, millimeter-wave power amplifiers, high-speed high-power microwave switch , Multi-channel switch filters, multi-channel receiver components, microwave, millimeter wave components RT ,1-18 GHz broadband limiter, broadband, such as ultra-wideband microwave antennas, of which 1 W has established mass production of microwave power amplifiers, 40 W microwave power Amplifiers ,2-18 GHz broadband hybrid integrated microwave power amplifiers, and other domestic fill the gaps, for the military plant, provided by the various military microwave devices and micro-electronic devices, for the modernization of national defense have made contributions to the building, the company also created a good Economic and social benefits.

公司的主导产品已有：1W、10W、40W宽带微波功率放大器、2-18GHz微波宽带混合集成放大器、 6-18GHz微波宽带混合集成放大器、宽带低噪声放大器、毫米波功率放大器、高速大功率微波开关、多通道开关滤波器、多通道接收组件、微波、毫米波R-T组件、1-18GHz宽带限幅器、宽带、超宽带微波天线等，其中1W微波功率放大器已定型批量生产，40W微波功率放大器、2-18GHz宽带混合集成微波功率放大器等填补了国内空白，为军工厂、所提供了各种军用微波器件和微电子器件，为国防现代化建设做出了贡献，也为公司创造了良好的经济效益和社会效益。

The ways of parallel resonant DC link and three-level control strategy were used in this power amplifier circuit. Output current ripple of power amplifier can be reduced as three-level power amplifier, all of power switches work on and off under the zero voltage switching or zero current switching, loss of switching and current ripple interference effectively reduced.

该电路在功率放大器三电平控制策略的基础上应用了并联谐振直流环节，保持了三电平功率放大器输出电流纹波小的优点，同时功率器件均工作在零电压或零电流条件下，开关损耗、电流纹波干扰有效地减小。

The Difference Amplifier 差分放大器: The difference amplifier is the complement of the summing amplifier and allows the subtraction of two voltages or, as a special case, the cancellation of a signal common to the two inputs.

电路见图5，这种电路在运算电路中相当有用，比如差分对单端的转换，抑制共模信号。

The relation between quiescent point and voltage gain,input resistance,output resistance, maximum nondistortion output voltage ,dynamics parameter in amplifier is discussed by commom-emitter fixed-bias amplifier,the effective methods to improve voltage gain are deduced,and how to set reasonale quiescent point′s position based on amplifier′ different is also presented finally.

以共射固定偏置放大电路为例讨论放大电路中静态工作点与电压放大倍数、输入电阻、输出电阻、最大不失真输出电压等动态参数的关系，得出提高电压放大倍数的有效方法。

The switching power amplifier is optimized based on the achievement of electromagnetic force, and the circuit structure of tristate power amplifier with soft-switching is designed. This circuit owns the advantages of reducing the dissipationpower on the power component and improving the speed of system dynamic response, enhancing the stability of the electromagnetic force in the final state, and the nice result is presented by the simulation. The small-signal model of the power amplifier is also established.

在实现支撑所需的电磁力基础上，对开关功率放大器电路进行了优化设计，采用三电平软开关的电路结构，以降低主功率器件的功耗、提高系统的动态响应速度、提高稳态电磁力的平稳性；仿真分析表明可以达到预期的效果；最后还建立了功率放大器的小信号模型，为控制系统的调节器设计提供了依据。

Based on these theories, this paper discusses the method of the design of the low noise amplifier integrated active microstrip patch antenna, which considers the low noise amplifier and the microstrip antenna and takes both mutual matching into account. The size of the active integrated antenna and the circuit configuration of the low noise amplifier are obtained at the specified operation frequency.

根据这些理论，把低噪声放大器和微带天线结合起来，并考虑两者之间的匹配，讨论了一种集成低噪声放大器的有源微带贴片天线的设计，得到了在给定工作频率下的有源集成天线尺寸和低噪声放大器的电路结构。

Those provide a practical and valid method for designing a feedforwardpower amplifier. Utilizing these and for TD-SCDMA we research and develop thedivider, coupler, bridge and power amplifier at 2.35GHz. Finally I accomplished asimple and minimal structured feedforward power amplifier. Its measured third-orderintermodulation distortion is -50dBc, which is 40dB greater than there is nolinearization technique.

根据分析结论，针对中国自主开发的TD-SCDMA 标准，设计实现了2.35GHz 的功分器、功率合成器、耦合器以及矢量调制器和功率放大器，最终实现了结构简单、体积小巧的前馈功放系统，完成了对放大器的线性化，三阶交调系数优于-50dBc 比线性化之前三阶交调系数改善了40dB。

At final calibration the amplifier is precision set for low distortion (typical 0.0025% THD) and then given a listening test to verify amplifier performance. Because all parts which wear out have been replaced and the amplifier is brought to the latest standards, EKSC Eagle provides a two year transferable warranty on every "Double Cap" unit.

在最后的校准精度的放大器是为低失真（典型值0.0025％THD）的设置，然后给他们一听测试，以验证放大器的性能，因为所有的磨损已被替换的放大器带来的最新标准的一部分。，EKSC鹰提供两年转让的保修每一个&双章&单位。

The 5mV of the audio signal which comes from the microphone to linear amplificated by the audio signals amplifier,then mixes with music signals from other sound sources(eg:the tape 、CD) by the hybird amplifier . By the control of the digital volume controller the mixed signal ,then amplificated again by the preamplifier,when integrated power amplifier for idling time realizes the signal enlargement factor respectively is 10、100、1000 times;moreover is capable of delivering 3V of output to a 600%26Omega; load. the amplificate signal makes the loudhailer work at last.

该音频信号放大器能够将来自话筒5mV的音频信号进行线性放大，然后和来自其他音源的音乐信号通过混合放大器来混合，混合后的信号经数字音量控制器对高低频的增益进行提升与衰减，再通过前置放大器放大，当集成功率放大器为空载的时候实现信号的放大倍数分别为10、100、1000倍；另外再实现当负载为600%26Omega；的时候，输出幅度为3V，最后经扬声器发出悦耳的声音。

I hope that this success is just the first in a long series.

我希望这只是成功的开始。

Three dimensional stresses on the interface of tire and soil, tire deflection and soil sinkage are measured.

测试轮胎——沙土界面上的三向应力、轮胎变形和沙土沉陷；建立考虑剪切应力对沙土承载特性产生影响的车轮牵引性能预测模型；分析车轮作用下土壤的纵向稳定性。