气动的

In order to improve penetrativity of hypersonic missile and enable air-launched hypersonic cruise missile to penetrate with skip trajectory, a new approach of generating positive angle of attack during reentry phase of trajectory was proposed. Some key parameters of realizing skip trajectory were found out, and the effects of these parameters on ballistic performance were discussed.

为提高高超声速导弹的突防能力，使常规布局空中发射的高超声速巡航弹能采用跳跃式弹道突防，采用了在导弹再入段附加相应的正攻角产生气动升力的方法，找出了实现弹道起跳的关键参数，讨论了这些参数对弹道性能的影响。

The flowfield and performance of a centrifugal compressor was predicted and analysed, which was composed of a Krain's impeller and two types of vaneless diffuser specially: one was constant area vaneless diffuser and the other was the straight-wall. The results show that the efficiency of the straight-wall vaneless diffuser is obviously lower than that of the constant area, and a separate flow occurs nearby the exit of the centrifugal impeller with the straight-wall diffuser. However, the type of vaneless diffuser has little influence on the aerodynamics performance of the centrifugal impeller. Finally, it is suggested that the constant-area vaneless diffuser should be selected as the downstream extended area of the centrifugal impeller during the prediction for the centrifugal impeller.

对Krain叶轮后带等面积与直壁两种形式的无叶扩压器离心压缩机内部流场进行了计算与分析，结果表明：直壁型无叶扩压器离心压缩机的效率低于等面积无叶扩压器离心压缩机的效率；直壁型无叶扩压器使得叶轮出口的流动出现分离；扩压器的形式对离心叶轮的整体气动性能影响并不大；在进行离心叶轮数值研究时，叶轮后的延伸区最好采用等面积无叶扩压器，以尽量减小无叶扩压器所引起的计算误差。

Rna - Rns, see "Partitioning of net radiation", for multiple plants the fraction of radiation to each plant is calculated in the radiation section, see "Partitioning of radiation between plants", es is the vapour pressure at saturation, ea is the actual vapour pressure,ρa is air density, cp is the specific heat of air at constant pressure, Lν is the latent heat of vaporisation,Δ is the slope of saturated vapour pressure versus temperature curve,γ is the psychrometer "constant", rs is an "effective" surface resistance and ra is the aerodynamic resistance.

潜在蒸腾量 Etp 根据Monteith(1965)给出的彭曼联合方程形式计算：式中： Rn 为对于蒸腾的有效净辐射量(也就是 Rna - Rns ，见&净辐射划分&-Partitioning of net radiation，对于多重植被，每一株植物的辐射比率的计算见辐射一节的&植物间的辐射划分&Partitioning of radiation between plants)； es 为饱和水气压；ea 为实际水气压；ρa 为空气密度； cp 为常压下的空气比热；Lν为汽化潜热；Δ为与温度曲线饱和水气压关系曲线斜率；γ为干湿球湿度计&常数&；rs 为&有效&表面阻力；ra 为气动阻力。

Has a large network of customers, and with large cash storage and store; users of new products and the improvement of old products and imported equipment and production lines rolling by the much-needed products, pneumatic components, electronic products supporting, equipment Maintenance of spare parts can be quickly supply.

拥有一张庞大的客户网络，并备有大型的现货仓库及门市；用户在新产品和老产品的的改进，以及引进设备和生产线所急需的滚动产品，气动元件，电子产品的配套，设备维修保养的备品备件都可以得到快速的供应。

Data generated from a variety of cold-flow aerospike tests revealed that the base thrust is a fixed percentage of the thrust generated by the discarded portion of the spike.

产生的数据来自不同的冷流气动试验显示，该基地的主旨是一个固定百分比的推力所产生的被丢弃的部分穗。

"Hydraulic safety valve" is widely used in hydraulic power systems and hydraulic equipment of safety devices, pressure devices can be limited, is a special valve, which is different from the conventional valve, the traditional use of mechanical valves metal spring as a driving force, can only be limited to low pressure, encountered more BALANCING VALVES than 10Mpa pressure limit pressure can do to increase the volume of pressurized design, the traditional role of the high-pressure valves and high pressure hydraulic power systems and hydraulic equipment The limit pressure of necessity is bulky and complicated structure, difficult to manufacture large, high production costs; in the course of the fatigue of metal spring parameters change fluctuating pressure limiting Ambassador to regular revision to ensure the normal use.

&气动液压安全阀&是目前广泛应用于液压动力系统和液压设备中的安全装置，也可以作限压装置，是一种特殊的阀门，它不同于传统的阀门，传统阀门用机械金属弹簧为动力，只能限中低压力，遇到超过10Mpa以上的压力限压，闸阀只能做加大体积的增压设计，因此传统阀门作用于高压和超高压的液压动力系统和液压设备的限压时必然体积笨重，结构复杂，制造难度大，产品成本高；在使用过程中金属弹簧的疲劳变化大使限压参数波动大，要经常调整才能保证正常使用。

"Hydraulic safety valve" is now widely used in hydraulic power systems and hydraulic equipment in the safety device could also serve as limited pressure device, is a special valve, unlike conventional valves, conventional valves with mechanical metal spring as a driving force, can only be limited to low pressure, the pressure encountered over more than 10Mpa limit pressure can do to increase the volume of the Safety Overflow Valve booster design, the traditional role of the high-pressure valves and high pressure hydraulic power systems and hydraulic equipment The limit pressure of necessity is bulky and complicated structure, difficult to manufacture large, high production costs; in the course of the fatigue of metal spring parameters change fluctuating pressure limiting Ambassador to regular revision to ensure the normal use.

&气动液压安全阀&是目前广泛应用于液压动力系统和液压设备中的安全装置，也可以作限压装置，是一种特殊的阀门，它不同于传统的阀门，传统阀门用机械金属弹簧为动力，只能限中低压力，遇到超过10Mpa以上的压力限压，只能做加大体积的增压设计，因此传统阀门作用于高压和超高压的液压动力系统和液压设备的限压时必然体积笨重，结构复杂，制造难度大，产品成本高；在使用过程中金属弹簧的疲劳变化大使限压参数波动大，要经常调整才能保证正常使用。

Providing the specific problems which enterprises encounter in their actual production processes, the problems in the development of enterprises are effectively resolved. Therefore it is essential to introduce latest technologies. The turning fixture and the feeding device of the pump rod joint can be used to realize the automatic discharging. With engine lathes transformed into computerized numerical control and pneumatic tailstocks coordinating revolving centers to use, partial automation production of pump rod joints can be realized.

为了切实解决企业发展中遇到的问题，可利用抽油杆接箍车削上料装置实现自动出料，通过普通车床的数控化改造和气动尾座的配合活顶尖的使用，可以实现抽油杆接箍的半自动化生产，以解决企业在生产过程中遇到的问题。

Today, PCL's products are a familiar sight in garage forecourts, tyreshops and engineering shops throughout the world, and PCL continues to expand globally, providing first-class, reliable and cost effective products for tyre inflation and pneumatics, with localised service in any location.

今天， PCL的产品在世界各地的修车厂前庭、轮胎店和机械车间随处可见，并且PCL继续拓展全球市场，为轮胎充气和气动工程提供一流的，可靠的和具有成本效益的产品以及在任何地方本地化的服务。

The invention concerns a device for damping the yawing motions between a motor road vehicle and its trailer consisting of a damping curvilinear track (4) whereon acts a friction device (17) for example a pneumatic device mounted at the end of the towbar (2), the track (4) being for example articulated to a fixed part at the rear of the truck or sufficiently flexible to absorb roll and pitch.

本发明涉及在机动车和它的拖车之间的左右摆动缓冲装置，该装置包括一个曲面形缓冲道(4)，一个装在连杆(2)的端部的气动摩擦装置(17)作用在该缓冲道上，以铰接的方式将缓冲道(4)连接到卡车后面的固定部位上，缓冲道也可以足够柔软，以便消除侧滚或俯仰运动。

He and Nina moved to California and lived at 2005 Ivar Street, Apt.

他和Nina搬到加州，并在2005年伊瓦尔街，公寓生活。

Droperidol （ potently inhibits transfected HERGchannels and this is the probable mechanism for QT prolongation.

氟哌利多有效地抑制了转染的 HERG 钾通道，可能是 QT 间期延长的机制。