模拟通道

The comparison of numerical results based on different resolution shows that the bathymetry has significant influence on the circulation in strait.

不同分辨率模式模拟结果的对比表明，海底地形对海峡通道中的流动有着十分重要的影响。

The fluid flows and heat coupled calculation method is used. The standards two equations turbulence models, velocity and pressure coupled arithmetic are used.According to the results of numerical simulation analysis the local coefficient distribution changes along the pin fins.Study the effection that its height and shape of the pin fins have on the average Nu and the average number of pressure loss coefficient Eu.The circle-shaped and elliptic-shaped pin fins have different circumcolumnar regional,therefore the mixed conditions are effected.

数值计算中采用标准双方程湍流模型，速度压力耦合算法；根据数值模拟的结果分析沿扰流元的局部换热系数分布变化，研究其扰流柱高度及形状对扰流柱通道平均努赛尔特数Nu和平均压力损失系数Eu的影响，圆形和椭圆形扰流柱的绕流尾涡影响的区域的不同对扰流柱群内流体混合状况的影响。

It is also found that the electroosmotic flow is in the opposite direction to that predicted by the classical continuum theory.

模拟结果表明，在双电层的某个区域内，同号离子的浓度超过了对离子的浓度，出现了电荷倒置现象；约占整个通道的三分之二内的区域内，溶液朝着与连续性理论预测的相反方向流动，出现了反转电渗流。

The influence mechanism of triangle surface roughness on electroosmotic flow in microchannels with circular cross-section is studied by the finite element simulation.

采用有限元模拟研究了壁面机糙度对圆形截面微通道内电渗流的影响机理。

In order to examine the electroviscous effect of polar fluids on the friction factor for the laminar flow in microchannels, the numerical investigations were conducted, and the results were compared with the experimental data available in literature.

采用数值模拟方法确定极性流体电黏性对于微通道内流动摩擦系数的影响，并与文献中的实验结果进行了比较。

The numerical simulation results indicate that whether the electroviscous effect should be considered is determined by the ratio of channel hydraulic diameter to the Debye thickness. Smaller ratio leads to greater electroviscous effect.

数值模拟结果表明：极性流体电黏效应的影响是否可以忽略，要根据通道当量直径与双电层厚度的比值r来决定，比值越小电黏影响越大。

In order to verify the model mentioed above, the mathematical simulation of geotemperature field has been carried out. The thrust nappe sheat zones are handled with two ways: 1 they are treated as constant heat sources in terms of q=τμ, that is, the quantity of frictionally generated heat is constant; 2 as heat conduit with high thermal conductivities and with fluid flow in fault zones.

为了进一步检验上述逆冲推覆复合叠加构造模型的可信程度，开展了地温场数值模拟工作，按复合叠加型岩石圈热结构给定各种热物性参数，逆冲推覆剪切带以两种方式处理，一是把它作为定热源按q＝τU，即按摩擦生热量级大小取值；第2种是把它作为热通道处理。

Based on the simulated multispectral and multiangular satellite measurements, we analyzed the sensitivity of different wavelength and satellite view.angle to the retrieval of the aerosol optical thickness and effective radius.

2利用Mie散射和大气辐射传输模式模拟了一个给定条件下的卫星多视角、多波长的辐射观测，分析了各通道之间可用于气溶胶光学厚度和粒子有效半径反演的敏感性。

For the dress fabric, I mainly used the Oren Nayar Blinn shader from 3DSMax. One of the tricks I often use for fabrics is to put a Fresnel Falloff map in the self-illumination slot of my material.

对于服装面料，我主要用于从3DSMax的Oren Nayar Blinn 材质，这是我经常使用的材质之一，我经常使用衰减贴图贴到自发光通道上，用来模拟绒布的效果。

So far transgenic knockout models of AQP1, AQP3, AQP4 and AQP5, and a knock-in model introducing a point mutation (T126M) that causes autosomal recessive nephrogenic diabetes insipidus in human have been successfully established. Significant progresses have been made in characterizing the physiological functions of these AQPs by systematic mouse phenotype studies.

目前AQP1、3、4、5基因敲除和AQP2基因点突变的基因敲入小鼠模型（模拟人类常染色体隐性遗传尿崩症）已成功建立并广泛用于表型研究，在AQP水通道蛋白生理功能方面获得许多重要进展。

I'm strongly against the death penalty — it's an eye for an eye.

我不赞成死刑——这是以牙还牙的报复行为。

And to get you the support you need, we're enlisting all elements of our national power: our diplomacy and development, our economic might and our moral suasion, so that you and the rest of our military do not bear the burden of our security alone.

并给你们所须的支援，我们正徵召国家所有各种的力量：我们的外交及发展，我们的经济力量与道德劝说，所以你们与其他军人不须要孤独地负起国家安全的责任。