应受

Based on a two-phase flow momentulm equation and a mechanical energy balance equation, an expression for the buoyance on the fluidized partiles has been derived.

表明了广泛应用的拟均相模型的不合理性，提出了应采用分离流模型来分析散式流态化中颗粒的受力情况，证明了流化颗粒所受浮力符合阿基米德原理，即，还推导了流化颗粒所受流体曳力的表达式：并用实验对其进行了验证。

The location and orientation control valves installed in accordance with design drawings and design H44X rubber disc check valves documents provided, the installation location should have sufficient operating space for installation, operation and maintenance; its location should be avoided in a vibration, humidity, susceptible to mechanical damage , there is strong electromagnetic interference, high temperature, severe temperature changes and corrosive gases in place; installation should be firm, smooth; installation position should enable the control valve of the upper part of the implementing agencies in the regulation of body, Figure 6-8 shows a straight stroke control valve a variety of mounting positions.

1控制阀安装位置和方位按照设计图纸和设计文件的规定，安装位置应具有足够的操作空间，用于安装、操作和维护；其位置应避免安装在有振动、潮湿、易受机械损伤、有强电磁干扰、高温、温度变化剧烈和有腐蚀性气体的场所；安装应牢固、平整；安装方位应使控制阀的执行机构在调节机构上部，图6—8显示了直行程控制阀的各种安装方位。

Many structural deficiencies and mistakes were highlighted, which including excessive horizontal displacement in the ground, more severe damaged transition layer (the first masonry structure layer), ground with farraginous structure, and poor construction quality. Finally, lateral stiffness ratio of the second to ground story in masonry buildings with RC frame structure at the bottom will be optimized following difference of materials between the ground floor and the upper floors. The strength and the ductility of transition layer, as well as shear walls in the ground floor, are crucial to keep the building standing during large earthquake.

在介绍和总结了汶川地震中底框砖房的表现―底层过大的水平侧移、过渡层严重破坏或完全坍塌、底层严重破坏或房屋完全倒塌、上部砌体整体发生侧移、以及设计一和施工质量良好的底层抗震墙砖房&大震不倒&的基础上，得出以下结论和建议：在抗震设防地区应禁止使用部分底框砖房，地震中过渡层的实际受力情况与设计所采用的受力状态有明显的区别，规范应考虑砌体和钢筋混凝土材料的不同力学性质来制定上下层刚度比要求，明确对过渡层的延性和强度要求，明确该类结构抗震概念设计的具体措施。

Through designing of composition and structure of the bioactive graded coating,innerstress and its distribution in the coating were analyzed and calculated, the resultsshowed that when composition distribution coefficient n was 1.5, a reasonable stressdistribution could be got, that was at the beginning of deposition the suspension containingrichly BG granules was used so that a rich BG granules layer, a good transitional layerbetween BG layer at the bottom and the coating could be obtained at the titanium alloy side,the bottom of the coating; the stress value near the interface and surface and its character,pressure stress or tensile stress, were decided by the character of its composition itself.Changing composition distribution coefficient n could only change the variation tendency ofstress in the coating, but did not change the stress distribution rule in the coating. Thethinner the coating is, the sharper stress variation in the coating is, which does not mean thatthicker coating is better because the thicker the coating is, the little the permitteddeformation of coating is, so the coating thickness should be thinner, for example, about50μm for bending applications, but for applications only bearing pure shear stress, such asroot of tooth implant, the coating can be thicker little, for instance, about 80～100μm. The study on electrification characteristic and electrophoresis deposition of HAand BG granules in aqueous and non-aqueous solution system found that EPD almost didn'toccur in aqueous solution system. However, because HA granules take position charges inabsolute alcohol, a homogeneous EPD be carried out on the cathode titanium alloy slice, but taking negative charge in absolute alcohol the BG granules not be deposited on the cathode. A guided HA crystallizing, 100～300nm, on surface of the BG granules be realized by metathetical reaction, which cover BG granules with HA microcrystals and make the covered BG granules taking position charges in absolute alcohol, sequentially realize the EPCD of the BG and HA granules on the cathode, so it is feasible to make a titanium alloy/BG/HA bioactive graded coating by making use of EPCD technology. The corrosion experiment of rich boron bioglass coating and plasma spray coating showed that split phase, rich boron and rich silicon phase, occurred during its preparation. In basic medium the corrosion behavior of 〓 BG coating showed uniformity corrosion, the corrosion mostly occurred at rich boron phase area, therefore batch formula design of BGshould avoid the occurring of split phase. The corrosion appearance of plasma spray coatingappeared a non-uniform corrosion, mostly occurred at the edge of the laminated HA moltendrops, and emerged an accelerated corrosion tendency, which will easyly lead to corrosioncrackles extending to the interface and the happening of osmotic interfacial corrosion, thatmay be one of the major reasons leading to the coating cracking-off in the later period. Thetesting results of thermal expansion coefficient of 〓 and 〓BG showed the thermalexpansion coefficient of 〓 BG matched with that of titanium alloy better, and 〓 BG couldsinter with titanium alloy into densification enamel layer at low temperature (720℃).

将Ti6Al4V合金在1000℃下进行真空热处理会降低其力学性能，且合金内的V元素会向表面富集，因此，钛合金真空热处理和表面涂层的烧结温度不能过高，即应低于其相转变点；通过对生物活性梯度涂层的组成和结构的设计，分析和计算了梯度涂层内的应力大小和分布，结果表明：对于本研究，当成分分布系数n=1.5时，可以获得较合理的涂层力学性能，即在沉积开始时，采用富含BG颗粒的悬浮液，以便在钛合金侧获得同底层BG有良好过渡的富BG涂层；梯度涂层界面和表面的应力大小、性质由材料组成本身的性质决定，改变成分分布系数，只能改变涂层内应力变化的趋势；涂层的厚薄不影响涂层内的应力分布规律，但涂层越薄，涂层内的应力变化越快，但这并不意味着涂层越厚越好，因为涂层越厚，涂层允许的变形越小，对于应用于弯曲受力部位的涂层而言，涂层应薄一点为好(50μm)；而对于仅纯受剪切应力的部位，如牙根种植体，涂层可适当加厚(80～100μm)；通过对HA和BG颗粒在水溶液体系和非水溶液体系中的带电特性和电泳沉积的研究发现，它们在水溶液体系中很难发生电沉积；在无水乙醇溶液中，HA颗粒带正电，可在阴极钛合金片上发生均匀的电泳沉积，而BG颗粒则带负电荷；利用复分解反应法，可以制得100～300nm的HA，通过诱导HA在BG颗粒表面结晶，可对BG颗粒进行表面包覆，获得了被HA包覆的BG颗粒，改变了BG颗粒表面的带电特性，使BG和HA颗粒在无水乙醇中均带上正电荷，从而实现了HA和BG颗粒在阴极上的共沉积。

The act of Accepting money afterwards entrusted or agreed on beforehand carries the characteristic of the rights-money-deal,which should be undoubtedly regarded as a crime of accepting bribes.But on the other hand,the problem as to whether the act of Accepting money afterwards unentrusted or unagreed on beforehand totally accords with the essence of a...

事前有请托或者有约定的&事后受财&行为具备权钱交易的本质特征，应以受贿罪论处没有争议；但事前既无请托又无约定的&事后受财&行为是否完全符合受贿罪的本质特征，应根据刑法的规定，依照罪刑法定原则，具体情况具体分析。

The contractor first receives recompenses the power and the general mortgage occurs competes fashionably, should by establish the time to determine successively the precedence, our country will have the necessity in the future legislation explicitly to stipulate the contractor first will receive recompenses the power to be supposed to pass through the registration only then to live the potency.

承包人优先受偿权与一般抵押权发生竞合时，应以成立时间的先后来确定优先次序，我国有必要在将来的立法中明确规定承包人的优先受偿权应经登记才生效力。

For longitudinal bearing bar, in case of lapping joint, the tension lap length shall not be less than o.7L, and not less than 200m under any condition.

纵向受压钢筋，当采用搭接连接时，其受压搭接长度不应小于0.7L ，且在任何情况下都不应小于200mm。

The foreign materials in the coal may damage the belt feeding, thus dandruff comb shall be installed on the top of the coal receiving hopper of the tipper.

a。带式给煤机作为翻车机受煤斗配煤用，煤中的杂物可能造成带式给煤机的损坏，在翻车机受煤斗上部应装有篦子，翻车机翻卸完煤后，运行人员应将留在篦子上的杂物捡出，如果将杂物捅进煤斗则会造成皮带的损坏和堵煤，影响卸车。

Blessed are the death-defiant, for their days shall be long in the land -Cursed are the gazers toward a richer life beyond the grave, for they shall perish amidst plenty!

挑战死亡的受祝福，因它们在世上的时日应被延长；妄想身后更富贵的受诅咒，他们应在富足中毁灭！

Store opening and closing documents on transportation should be at the closing device, and also should do the following: a valve flap should be fixed in the open position b path ends with a foam board to plug in port, the port to be plugged with a boring cover, to dust, rust, clean and maintain the channel end of the formation; c cylinder parts to the appropriate protective packaging, shock and anti-collision; d valve should be placed on a smooth, pneumatic drive upwards, not with each other by the crowd.

存放月运输时启闭件应处于关闭装置，同时应做好以下工作： a 阀瓣应固定于开启位置 b 通径两端内口用泡沫板堵塞，端口须用闷盖塞紧，予以防尘、防锈，保持通道清洁和端面的平整； c 汽缸部位进行适当的包装防护、防震和防碰； d 阀门放置时应平稳，气动驱动装置朝上，不得相互受挤。

What are your goals and strategies for growth?

你的成长目标和策略是什么？

And unto the angel of the church in Sardis write; These things saith he that hath the seven irits of God, and the seven star I know thy works, that thou hast a name that thou livest, and art dead.

3：1 你要写信给撒狄教会的使者，说，那有神的七灵和七星的，说，我知道你的行为，按名你是活的，其实是死的。