查询词典 volume element

Plug in the power, the master volume knob to adjust the location of an appropriate, open the power switch, according to the needs of your volume knob to adjust the bass, you can enjoy the music Edifier charm R4.1 system.

插上电源，把主音量调节旋钮调至适当的位置，打开电源开关，根据你的需求来调节低音音量旋钮，即可享受到漫步者R4.1系统的音乐魅力。

The efficiency curve was fit using least-square method. The empirical formula of the efficiency curve slope of Ge detectors relative to their sensitive volume-S = a log + b -has been demonstrated in extremely large sensitive volume range. Using thisformula it can be estimated that the full en...

在极大的灵敏体积范围内，验证了锗探测器效率曲线斜率与其灵敏体积关系的经验公式：S=alogV+b，采用本公式可在小于3％的相对误差范围内，对已知灵敏体积的同轴HPGe探测器的全能峰效率随γ射线能量的变化作出估价。

Similarly a physical count is normally used to establish the volume of traffic on key roads and the volume of different brands sold by important retail outlets (increasingly via electronic point of sale — EPOS — installations).

同样，实物清点通常是用来建立的交通量的主要道路和数量的不同品牌销售的重要的零售商店（越来越多地通过电子销售点-电子销售点-设施）。

Aiming at this problem, a method for volume calculation based on matrix analysis is presented in this paper, and some examples are given to show that this method can be used to solve a class of volume problems in Euclidean space.

对此，本文提出一个基于矩阵分析的容积计算方法，并举例说明该方法可用于求解欧氏空间中一类容积问题。

The final volume of fermented broth is not less than 75 to 80 percent of the geometrical volume of the fermentor.

发酵液最后的体积应不低于发酵罐几何容积的75%到80%。

For average magnetic moment, average hyperfine field and roomtemperature elastic constants of 〓, the volume effect and the pure substitution effect of Pt atom are seperated by considering the composition dependence of lattice volume.

利用〓晶胞体积随成份的变化，针对平均磁矩、平均超精细场和室温弹性常数，本工作还区分了Pt原子的体积效应和纯粹的替代效应。

Compared with the graphite, the coefficients of friction of the RL-C/C are lower under the same load of about 0.08-0.12, and the increasing range of the volume losses are still lower than those of the graphite. Compared with the SL pyrocarbon material, the COF and the volume loss of the SL-C/C are about 0.02-0.05 and 0.2 mm^3, lower than those under the same load. The COFs of most RL-C/C and SL-C/C specimens remain stable or decrease slightly with time, while those of the graphite and pyrocarbon specimens increase. The thickness of the integrated friction film of the RL-C/C decreases with load, but the wear surface of the SL-C/C is rough. Tough the wear surface of the graphite is integrated, the serious abrasive wear make the debris move easily and accumulate on the edge of the wear trace to form a restacked morphology. On the wear surface of the pyrocarbon material, some loosed debris, circular worn holes and flake worn out pyrocarbon has been found.

结果表明：PAN炭纤维改善C/C复合材料的摩擦磨损行为；在实验载荷范围内，与高强度石墨材料相比，含RL炭C/C复合材料的摩擦因数降低0.08~0.12；体积磨损量增幅降低；与热解炭试样相比，具有SL炭C/C复合材料的摩擦因数降低0.02~0.05，体积磨损量低0.2立方公厘左右；随着时间的延长，大部分C/C复合材料的摩擦因数基本相对稳定或呈小幅下降，而石墨、热解炭块的摩擦因数均呈不同幅度的上升；具有RL炭的C/C复合材料摩擦表面膜厚度随载荷增加而降低，具有SL炭的C/C复合材料摩擦表面较粗糙；高强石墨能形成较完整致密的摩擦膜，但磨粒磨损严重，磨屑易在摩擦膜边缘形成层状堆积；热解炭块摩擦表面磨屑堆积松散，有较多的孔洞以及热解炭层整体剥落的形貌。

Compared with the graphite, the coefficients of friction of the RL-C/C are lower under the same load of about 0.080.12, and the increasing range of the volume losses are still lower than those of the graphite. Compared with the SL pyrocarbon material, the COF and the volume loss of the SL-C/C are about 0.020.05 and 0.2 mm3, lower than those under the same load. The COFs of most RL-C/C and SL-C/C specimens remain stable or decrease slightly with time, while those of the graphite and pyrocarbon specimens increase. The thickness of the integrated friction film of the RL-C/C decreases with load, but the wear surface of the SL-C/C is rough. Tough the wear surface of the graphite is integrated, the serious abrasive wear make the debris move easily and accumulate on the edge of the wear trace to form a restacked morphology. On the wear surface of the pyrocarbon material, some loosed debris, circular worn holes and flake worn out pyrocarbon has been found.

结果表明：PAN炭纤维改善C/C复合材料的摩擦磨损行为；在实验载荷范围内，与高强度石墨材料相比，含RL炭C/C复合材料的摩擦因数降低0.08~0.12；体积磨损量增幅降低；与热解炭试样相比，具有SL炭C/C复合材料的摩擦因数降低0.02~0.05，体积磨损量低0.2 mm3左右；随着时间的延长，大部分C/C复合材料的摩擦因数基本相对稳定或呈小幅下降，而石墨、热解炭块的摩擦因数均呈不同幅度的上升；具有RL炭的C/C复合材料摩擦表面膜厚度随载荷增加而降低，具有SL炭的C/C复合材料摩擦表面较粗糙；高强石墨能形成较完整致密的摩擦膜，但磨粒磨损严重，磨屑易在摩擦膜边缘形成层状堆积；热解炭块摩擦表面磨屑堆积松散，有较多的孔洞以及热解炭层整体剥落的形貌。

ULV Thermal fogger-Low-Volume Cold Fog A ULV Fogger generates fog droplets by using a high volume of air at a low pressure. Such a system enables dropfogging machine lets of a ...Foggers - cold foggers, thermal foggers and ULV sprayers, curtis ...Foggers, thermal and ULV aerosol generat

早报讯昨（18）日，青城山—都江堰旅游景区内人声鼎沸，首个300余人的内蒙旅游专列团队游客到达了都江堰景区，这也是世界遗产地青城山—都江堰于9月29日重新开放以来，呼和浩特旅游迎来的首个旅游专列团队。

At the same time provide professional ring plug gauge, plug gauge smooth ring, Anglo-American system of ring plug gauge, gauge block, another block volume, the volume of block attachment.

同时还提供专业环塞规、光滑环塞规、英美制环塞规、量块、另量块、量块附件。

The system can be widely used in belt weighing and batching process control,etc.

介绍了基于智能模糊控制的嵌入式配料系统的设计方法，对模糊PID控制过程和系统调零作了重点的讨论，同时给出了PID控制的程序流程图和系统定长调零子程序。

"I dunno," she answered,"but if you show me aroun', I'll recognize it from the lighthouse just outside the porthole."

"我不知道，"她回答说，"如果你能带我转转，我能认出来的，因为灯塔就在舷窗外。"