查询词典 vertical angle

That is to say, during the starting process of induction motor, hold-off angle of current has gradually decreased from initial value to zero. The method can always make the displacement angle less than thyristor's firing angle. So the voltage of the induction motor won't oscillate. Therefore, the oscillation of current, electromagnetic and speed can be eliminated during the soft-starting process of induction motor. This paper verifies the correctness of the method by simulation at first.

根据上述原因，本文提出了采用关断角控制的新型控制策略，这种控制策略是使电动机在起动过程中的电流关断角由某一初始值逐渐减小到零，利用该方法可以使感应电动机起动过程中的续流角始终小于晶闸管的触发角，这样续流角的变化就不会引起电动机端电压的振荡，因而就从根本上消除了感应电动机软起动过程中的振荡现象。

Blade twist angle may be automatically established by a balance of dynamic forces on the blade which cause twist angle to increase as root mounting angle is increased.

叶片扭角可自动建立一个平衡的动态部队对叶片造成扭角增加，以root的身份安装的角度来看是有所增加。

The definition of generator angle is proposed in this paper. A new method to deduce generator angle by using rotor rotation signal is illustrated, which compares the phase difference between GPS timing pulse and RRS. Using only mechanical signal, the technique unfreezes limitation of zero-cross of generator terminal voltage during transient process. Automatic correction of initial generator angle is also proposed .

本文介绍了同步发电机绝对转子角的定义，提出了一种测量绝对转子角，进而获得高精度的相对转子角的方法；此方法不使用机端电压过零整形脉冲，而是将机组键相脉冲与GPS 定时脉冲比相，并能够自动整定初始位置角，因此，测量结果不受发电机运行状态的影响，能够在各种运行方式和扰动情况下获取高精度的绝对转子角。

The Kuriles subuction zone subducts with an angle of 45°; while the subducting angle of the Japan Sea subduction zone may by smaller 30°; the Ryukyu and Izu-Bonin subduction zones subducts with an angle of over 70° or nearly 90°, providing an evidence for activities in back-arc basins.

千岛群岛俯冲带大约以45°角度俯冲，日本海俯冲带则可能小于30°，琉球群岛俯冲带和伊豆-小笠原俯冲带则以大于70°的角度或近于直立的角度俯冲，从而为弧后盆地的活动性提供了证据。

The experimental velocities cover subsonic,transonic and supersonic flows,and the content includes:(1) flow over flat plate,revolution body and wing with riblets surface at zero angle of attack;(2) the effect of pressure gradient,angle of attack and slide angle;(3) the burst characteristics,characteristics of turbulence,the streak structure in the near wall region and the drag reduction mechanism.

内容涉及沟槽面平板、旋成体、机翼等在压、跨、超音速流动情况下的实验研究成果；压力梯度、攻角、侧滑角等的影响；湍流猝发特性、紊动特性、近壁区带条结构的特征及减阻机理等方面的工作。

The sheath inserted directly in the Department indicating the degree of bounce angle and a yellow dot that low bounce angle (the smaller the width at the bottom), two Yellow-spotted as a standard rebound angle, another perspective of the figures that rebound.

该公司直接在插鞘处标明反弹角的程度，一个黄点表示低反弹角，两个黄点为标准反弹角，另外数字则表示反弹角度。

According to the results of this study, the ultimate strength of pin-bone interface increased as the moment arm decreased and torque increased. When the pin-bone angle approached 90°, the ultimate strength was the largest and as the angle decreased, the ultimate strength decreased. There was no significant difference between rigidity and torque, but rigidity decreased as the skull-bone angle decreased.

结果发现钉骨界面的极限强度在头圈距离颅骨的力臂短时较高，且随著所用扭力的增加而增加，当头钉与头骨表面的夹角成垂直时最强，随著夹角越趋锐角而渐减，钉骨界面的刚性与扭力并无明显关系但与夹角有关，夹角垂直时刚性最高，而后随著夹角渐趋锐角而递减。

In order to real-timely and accurately measure thread parameters such as thread angle(tooth-type half-angle),screw-pitch,lead,thread height,major diameter,minor diameter,pitch diameter,helix angle etc,and enhance the measuring accuracy,a non-contact thread parameter measuring system based on an array CCD was designed and achieved.

为实时准确地对螺纹的牙型角、螺距、导程、螺纹高度、大径、小径、中径、螺纹升角等参数进行测量，并提高测量精度，设计并实现了基于面阵CCD的螺纹参数非接触测量系统。

To further study this problem, the optical axis is rotated by an arbitrary angle. A striking phenomenon is discovered that the Brewster angle is always equal to the rotation angle. This is because the waves in the direction perpendicular to the optical axis become evanescent since the permittivity is positive while the permeability is negative in this direction.

然后进一步的研究了主轴不垂直于界面的情况，发现主轴转动的角度恰好等于此时的Brewster角，这是因为此时垂直于主轴的方向上介电常数为正磁导率为负，只有倏逝波而没有可传播的波存在，因此反射系数为0。

For improving the maneuver stability,safety and decreasing the tire wear,the combination of the optimization software,modefrontier and msc.adams,is applied to design the steering mechanism,with bottom angle of steering trapezoid,arm length,kingpins distance and axles distance as design parameters,transmit angle as constraint,minimum error between theoretical and practical steering angle as objective function,and simulated annealing as the optimization algorithm.

为了提高汽车操纵稳定性、安全性及减少轮胎磨损，将数值优化软件modefrontier同机械动力学仿真分析软件m sc.adam s集成，以转向梯形底角、转向臂长度、主销中心距和轴距为设计参数，传动角为约束，以转向时内轮实际转角与理论转角的误差最小为目标函数，采用模拟退火算法对转向机构进行最优化设计。

There had been a moment during the breakfast meeting, though, after the backslapping and the small talk and when all of us were seated, with Vice President Cheney eating his eggs Benedict impassively and Karl Rove at the far end of the table discreetly checking his BlackBerry, that I witnessed a different side of the man.

那次早餐会期间，在表示过关心和寒暄以后，我们所有人坐了下来，我注意观察了一下，副总统切尼面无表情地吃着班尼迪克蛋（Eggs benedict，源自美国，以英式松饼、火腿、水煮蛋以及荷兰酱组合而成），卡尔。罗夫在餐桌的远端谨慎地经常查看他的黑莓手机，我目睹了他所不为人知的一面。

Talk Undelete failed; someone else may have undeleted the page first.

Talk 无法删除选定的页面或图像（它可能已经被其他人删除了）。