查询词典 thin coating

The effects of blackening time and the mass fraction of phosphorus of the coating on the morphology of a porous coating was investigated.

以不同磷的质量分数的镀层为研究对象，研究了腐蚀时间、镀层中磷的质量分数对镀层表面构造一种多孔结构的形貌特征的影响。

Therefore, this part of conventional paint coating system in accordance with the life of the coating cabin bulkhead supporting the program.

因此，此部位涂料采用常规涂料系统，可按照生活舱舱壁的涂装配套方案。

Because the traditional resolver cellulose nitrate lustre-coating agent it does not bear the aging, the resistance to cold to be bad, shortcomings and so on hygienic performance difference receive the impact, but emulsion cellulose nitrate lustre-coating agent, although the comparison environmental protection and the hygienic performance are high, but because became the membrane glossiness to be bad and the emulsion long-term laying aside does not stabilize has limited its application.

传统的溶剂型硝化纤维光亮剂因其不耐老化、耐寒性差、卫生性能差等缺点而收到冲击，而乳液型硝化纤维光亮剂虽然比较环保且卫生性能较高，但因成膜光泽性较差和乳液长期放置不稳定而限制了其应用。

The cellulose nitrate lustre-coating agent's has surpassed for 100 years in leather Tu Shi application, because it surpassed the casein, the acrylicresin, the polyurethanes lustre-coating agent and the low in price obviously in the top layer Tu Shi overall performance obtained the widespread application.

硝化纤维光亮剂在皮革涂饰中的应用已超过一百年，因其在顶层涂饰中的综合性能明显优于酪素、丙烯酸树脂、聚氨酯类光亮剂且价格低廉而得到了广泛的应用。

Therefore, when configuration resolver leather lustre-coating agent uses the alkyd resin and the melamine xylenol-formaldehyde resin and the cellulose nitrate mix method, the retention cellulose nitrate Cheng Mo merit, improves it not to bear the aging, the cold resistant bad shortcoming, undergoes the repeated test, compounds the successful resolver lustre-coating agent to have the very good radiance and softness, bears the stretch, bears scours, becomes the membrane to be smooth.

因此，在配制溶剂型皮革光亮剂时采用醇酸树脂和三聚氰胺甲醛树脂与硝化纤维混合的方法，保留硝化纤维成膜的优点，改进其不耐老化，耐寒性较差的缺点，经过反复试验，配制成功的溶剂型光亮剂有很好的光亮度及柔软度，耐拉伸，耐擦洗，成膜光滑。

A new type in-situ reinforcing Cr7C3 ceramal composite coating was fabricated on carbon steel(C3) substrate by plasma cladding. Microstructure of the ceramal composite coating was characterized by SEM, XRD and EDS. Room and high temperature wear properties were evaluated under dry sliding wear test conditions and their wear mechanism was discussed.

采用等离子熔覆技术，在调质C3钢表面制得以原位生成初生相Cr7C3为增强相的金属陶瓷复合材料涂层；利用SEM、XRD和EDS等分析了涂层的显微组织和相组成；测试了在室温干滑动磨擦及高温滑动磨擦条件下涂层的耐磨性，并讨论了其磨损机理。

The plasma clad ceramal composite coating consistsed of primary Cr7C3 and Cr7C3/γ-Fe eutectics. The coating possessed excellent sliding wear resistance under both room and high temperature test conditions.

结果表明：涂层的相组成是Cr7C3增强相和γ-Fe固溶体与少量Cr7C3构成的共晶；涂层在室温和高温干滑动磨擦条件下均具有优良的耐磨性能。

The results showed that the corrosion resistance of the coating is close to that of chromate conversion coating.

结果发现转化膜耐蚀性能与铬酸盐钝化膜相当。

It was also found that the decrease of immersion resistance and impedance of the commercial anti-corrosion of poly (vinyl chloride co-isobutyl vinyl ether) coating with increase of directly adding of nano-TiO2, which was elucidated with the theory of critical pigment volume concentration. At last, the optimal coating prescription was gotten as follows: 0.5-1.0g nano-TiO2 B, 25.6g resin, 33.4g xylene, 1.4g chlorinated paraffin, 1.5g 15% slurry of organic bentonite, 0.8g green chrome, 7.7g grey mica ferric oxide and 0.6g non-float aluminum.

直接添加纳米二氧化钛的商品化防腐涂层耐浸泡性能和交流阻抗值随添加量增加而降低，利用临界体积浓度理论等解释了该现象；通过实验获得了如下最佳涂料配方为：0.5-1.0g纳米TiO2，25.6g氯醚树脂，33.4g二甲苯，1.4g氯化石蜡52＃，1.5g 15%有机膨润土浆，0.8g氧化铬绿，7.7g云母氧化铁灰，0.6g非浮型铝粉。

In order to find the suitable working condition for the coating applying, the slurry erosion tests of the 20〓 steel, high chrome cast iron and coating materials have been carried out.

最后，为了找到能较好发挥涂层材料作用的工作条件，我们对涂层材料、20号钢和高铬铸铁进行了浆体冲蚀磨损试验。

There are different types of personal loans available.

有许多不同类型的个人贷款优惠。

The above mentioned teaching model of spiral rising can be used to avoid rigidness in teaching.

上述螺旋式上升的教学模式，可以避免教学形成模式後的僵化现象。