查询词典 sample case

TDA4864 Pinout: 8- to 32-bit and 16- to 32-bit word packing options Programmable wait state options: 2 to 31 CCLK Digital audio interface includes six serial ports, two pre- cision clock generators, an input data port, three programmable timers and a signal routing unit Serial ports provide: Six dual data line serial ports that operate at up to 50 Mbits/s for a 200 MHz core on each data line each has a clock, frame sync, and two data lines that can be configured as either a receiver or transmitter pair Left-justified sample pair and I2S support, programmable direction for up to 24 simultaneous receive or transmit channels using two I2S compatible stereo devices per serial port TDM support for telecommunications interfaces including 128 TDM channel support for telephony interfaces such as H.100/H.110 Up to 12 TDM stream support, each with 128 channels per frame Companding selection on a per channel basis in TDM mode Input data port provides an additional input path to the DSP core configurable as either eight channels of I2S or serial data or as seven channels plus a single 20-bit wide syn- chronous parallel data acquisition port Supports receive audio channel data in I2S, left-justified sample pair, or right-justified mode Signal routing unit provides configurable and flexible connections between all DAI components, six serial ports, an input data port, two precision clock generators, three timers, 10 interrupts, six flag inputs, six flag outputs, and 20 SRU I/O pins Serial peripheral interface Master or slave serial boot through SPI Full-duplex operation Master-slave mode multimaster support Open drain outputs Programmable baud rates, clock polarities, and phases 3 Muxed Flag/IRQ lines 1 Muxed Flag/Timer expired line ROM based security features: JTAG access to memory permitted with a 64-bit key Protected memory regions that can be assigned to limit access under program control to sensitive code PLL has a wide variety of software and hardware multi- plier/divider ratios JTAG background telemetry for enhanced emulation features IEEE 1149.1 JTAG standard test access port and on-chip emulation Dual voltage: 3.3 V I/O, 1.2 V core Available in 136-ball BGA and 144-lead LQFP packages Lead free packages are also available

TDA4864引脚说明： 8 - 32位和16 - 32位字包装选择可编程等待状态的选择：2至31个CCLK数字音频接口包括6个串行端口，两个前643时钟发生器，输入数据端口， 3可编程定时器和一个信号路由单元串行端口提供：六双串口数据线，在高达50 Mbps的操作/为200兆赫的每个数据行每个人都有一个时钟，帧同步的核心秒，和两个数据可以作为任何一个接收器或发射器对左对齐和I2S样本对支持，最多可同时接收或传送24个频道，每使用两个系列的I2S兼容立体声设备配置可编程方向线；港口的TDM通信接口，包括支持128个电话接口的TDM的渠道，如H.100/H.110支持多达12个的TDM流的支持下，每帧128个频道每个压缩扩展每通道的基础上选择在TDM模式输入数据端口提供了一个额外的输入路径的DSP核心配置为I2S或串行数据或7加一个20位宽的SYN -异步的并行数据采集接口通道或8通道；支持接收通道I2S音频数据，左对齐样本对，或右对齐模式信号路由单元组件之间提供所有戴配置和灵活的连接，6个串行端口，一个输入数据端口，两个精密时钟发生器，3个定时器，10个中断，六旗投入，产出6个旗，20曼谷南南区域股的I / O管脚串行外设接口的硕士或奴隶通过SPI串行启动全双工运作主从模式多主机支持开漏输出可编程波特率，时钟极性和第三期合并调制旗/ IRQ线路1合并调制旗/定时器过期线光盘的防伪特征：JTAG的访问与64位受保护的关键允许内存内存可分配给程序访问控制的限制下对敏感地区有一个代码锁相环/分比率背景遥测的JTAG仿真功能增强的IEEE 1149.1 JTAG标准测试访问端口软件和硬件多钳各种各样和片上仿真双电压：3.3六/输出，可在1.2 V核心136球BGA封装和144引脚LQFP封装无铅封装，也可

Abstracts: To sample high speed random signals without drop, a design of O-shaped high speed random signals acquisition card based on the CPLD and its realization are presented. It consists of same three sets of acquisitive circuits, which construct O-shaped structure to sample the signals without drop .And it adopts threshold judging method to determine the valid data in the process of the acquisition, abandons vast of the redundant useless data at the same time, it only sends the useful data to the host computer by the way of DMA, so it is easy to processing the data. The design is concise and reliable. The sketch map of the logic circuit and the explanation of the main parts are presented. This design has been applied in the engineering project of sampling α nuclide.

为了对随机到来的信号进行不丢失的高速采集，提出了一种基于CPLD的随机信号环形高速采集卡的设计与实现；通过采用三套采集电路形成一个环形结构，可以对随机到来的信号进行不遗漏的高速采集，而且在采集过程中利用阈值的方法鉴别出有用信号，并舍弃了大量的冗余无用数据，从而只将有用数据以DMA的方式传于主机，便于进行信号的处理；电路设计简洁可靠，并给出了主要的逻辑电路示意图与主要部件说明；该系统已经应用在采集α核素的工程实践中。

The authors reviewed a training sample of 26 occurrences of DKA complicated by severe CE and 69 episodes of uncomplicated DKA, along with head computed tomograms, and they incorporated signs of neurologic disease into a bedside evaluation protocol. They then applied this protocol to an independent test sample of 17 patients previously reported to have developed symptomatic CE during treatment for DKA.

研究人员回顾了26个发生糖尿病酮酸血症并发严重脑水肿的训练样本，与69个单纯糖尿病酮酸血症的个案，合并头部电脑断层扫描、神经疾病的病徵融入一个临床评估方案中；接著他们将这个方案应用到一个有17位之前在治疗糖尿病酮酸血症期间，产生脑水肿症状病患的独立试验样本中。

The authors reviewed a training sample of 26 occurrences of DKA complicated by severe CE and 69 episodes of uncomplicated DKA, along with head computed tomograms, and they incorporated signs of neurologic disease into a bedside evaluation protocol. They then applied this protocol to an independent test sample of 17 patients previously reported to have developed symptomatic CE during treatment for DKA.

研究人员回顾了26个发生糖尿病酮酸血症并发严重脑水肿的训练样本，与69个单纯糖尿病酮酸血症的个案，合并头部计算机断层扫描、神经疾病的病征融入一个临床评估方案中；接著他们将这个方案应用到一个有17位之前在治疗糖尿病酮酸血症期间，产生脑水肿症状病患的独立试验样本中。

Microstructure-evolution of the silicon nitride ceramics sample during sintering process was investigated by a synchrotron radiation X-ray computed tomography technique. The projection images of the sample were obtained during the sintering process in real-time. 2-D and 3-D reconstructed images were obtained by treating the projection images of different sintering periods with filter back projection arithmetic and digital image processing methods.

利用同步辐射CT技术，在氮化硅陶瓷样品烧结过程中对其进行实时投影成像，并应用滤波反投影算法和数字图像处理技术，得到了样品在整个烧结过程中内部微结构演化的二维和三维重建图像，实现了对陶瓷固相烧结过程实时、无损的观测。

The crosstalk reducing unit (14) has a sample rate converter (19) coupled to a synchronous clock for converting the output of the subtractor to the data signal (8) at a synchronous sample rate.

所述串扰降低单元(14)具有与同步时钟耦合的采样率转换器(19)，用于以同步采样率把所述减法器的输出转换为数据信号(8)。

It is appropriate to evaluate asphalt pavement compactness by stoving the non-aridity core sample from half an hour to one half hours in oven at(60±5)℃ if the core sample needn't to be used in other tests again.

沥青路面压实度是指工地实际达到的密度与室内标准密度的比值，因此，准确量测沥青路面的密度是准确评价路面压实度的关键。

Based on moving least squares surface, the differential properties of each sample point on PSO are first evaluated. In terms of covariance analysis, the elliptical splat of sample point is then determined on its tangent plane. Finally, the splats are rendered from far to near by using elliptical weighted average filtering. According to the differential properties, moreover, the suggestive contours of PSG are attained so that non-photorealistic rendering of PSG is realized.

首先根据构造的移动最小二乘曲面计算采样点的表面几何属性，然后根据协方差分析确定点元在其切平面上的椭圆表示，最后采用椭圆加权平均滤波从远到近单遍绘制各点元，此外，根据表面几何属性确定点模型的轮廓线，实现了点模型的非真实感绘制。

One dimensional shockwave code SSS was adapted to simulate the number density andporosity of incipient spalled OFHC Cu and pure Cu sample at the range of 10~4-10~5s~(-1). TheNAG model coefficients were acquired, the nucleation coefficient was sensitive with thepurity of sample.

采用一维冲击波程序SSS结合SRI-DFRACT模型模拟10~4-10~5s~(-1)加载应变率范围内无氧铜和工业纯铜中微孔洞数密度和孔隙度分布，由微孔洞分布相关参数与应变率的关系，确定了～10~5s~(-1)应变率下NAG模型参数，发现成核速率与材料纯度有关。

Harbin Institute of Technology, Harbin 150001, China）Abstract: The modified layers by O2-PBII technology on Ti6Al4V alloy surface were studied using X-ray photoelectron spectroscopy. The negative pulse voltage of 10, 20, 30 kV was applied to the sample, which was mounted on an oil-cooled sample holder. The results show that the thickness of the oxide layer increases with increasing implanted ion energy.

摘 要：采用等离子体基离子注氧技术（O2-PBII）对Ti6Al4V合金进行了表面改性处理，实验过程中改变注入离子能量的工艺参数，负脉冲偏压分别为10、 20、 30 kV，离子注入过程中样品台通油冷却以实现低温注入；用XPS对离子注氧层的深度、成分及化学结构进行了系统的分析。

"The operators will suffer a temporary decrease in the number of consumers and short message services as people may not like having to provide their ID cards for a phone number," Xu Junqi, vice-dean with the Policy-Making Institute of the Telecommunications Research Centre under MII, said yesterday.

信息产业部下属的通信决策研究院副主任徐俊其昨天说：&实行手机实名制后，人们可能不太情愿用身份证注册手机号，所以通信运营商会暂时面临用户减少和短信用户减少的问题。&

I don't believe in make-believe!

我不相信这些虚构的故事。