查询词典 range angle

The central angle of the impingement fluid separated from the target surface became larger with the increase of jet Reynolds. And the separating angle also increased with the increasing ratio of the jet distance to the diameter of the jet hole, while the range of induced vortex became smaller.

试验中发现随着冲击雷诺数的增加，冲击气流与壁面分离处对应的圆心角增大，分离推迟；随着相对冲击间距值的增加，气流与壁面分离处对应的圆心角越来越大，相对于受限空间的大小，诱导涡的范围越来越小。

A FDTD program was written and the electromagnetic fields for various polarized incident beams are calculated and the polarization states of the diffractive waves are extracted. The relation between the polarization state of the diffraction wave and the grating balzed angle and polarization angle for the linearly polarized incident wave is analyzed; In the spectral range of 1530 ~ 1570nm, the polarization dispersion is studied for the linearly and circularly polarized incident beam.

用时域有限差分程序计算出任意偏振方向线偏光经过闪耀光栅衍射后的电磁场分布，提取衍射波的S偏振和P偏振分量，分析它们与光栅闪耀角和入射光波偏振角的关系；分析在1530 -1570nm光谱范围内，入射光波为线偏振波和园偏振波时，衍射光波的偏振色散特性与光栅闪耀角的关系。

The structure, component, morphology and magnetic property of the composites were characterized by X-ray diffractometry, Fourier transform infrared spectroscopy, transmission electron microscopy and vibrating sample magnetometry, respectively. The tangent value of magnetic loss angle and dielectric loss angle of the composites were measured by an impedance/material analyser with the frequecy in the range of 1 MHz～1 GHz.

利用X射线衍射仪、红外光谱仪、扫描电子显微镜和振动样品磁强计分别表征了样品的结构、形貌和磁性能，用阻抗/材料分析仪测定了复合物在1 MHz～1 GHz的频率范围内的磁损耗和介电损耗，并研究了聚苯胺和引发剂的相对含量对复合物的磁损耗和介电损耗的影响。

In order to design the angle of self-destroying bevel in fuze's centrifugal ball device properly,widen the ballistic environment range is applied to the centrifugal ball device and improve the reliability of self-destruction action for centrifugal ball device,the self-destruction movement of centrifugal ball device was analysed and the conditional expression for angle of self-destroying bevel in centrifugal ball device that ensure the self-destruction firing pin movement of centrifugal ball device can not self locked were got.

为了正确设计引信离心球自毁机构自毁斜面角度，从而拓展离心球自毁机构适用的弹道环境范围并提高其自毁作用可靠性，通过分析离心球自毁机构自毁运动，得出了确保离心球自毁机构自毁戳击运动不自锁的自毁斜面角度条件式。

According to the request of adopting advanced technology, the main designing has such contents as below:⑴ Designing the two-fluid nozzle that is based on the theory of air-atomize spraying.⑵ Designing and choosing the type of the axial fan that is used to supply assisted airflow to waft droplets that comes from nozzle.⑶ Designing the swaying outfit that can rotate the spray assembly at a speed and inside a angle in order to satisfy the spray request of different crops, different planting states and improve the uniformity of distribution, the deposition of droplet. Here, we select TYV type reduction gear motor to adjust the swaying speed and use course switch to adjust the swaying angle.⑷ Designing the lift outfit that can adjust the height of the spray assembly to satisfy the request of the crops of different tallness, different spraying range. Here, we select cylinder as the main component that can be used as kickstand and controlled easily.⑸ Designing the switch of the power supply that is put out of the greenhouse in order to prevent worker from poisoning. After the mist sprayer being made, the experiment is made to test the function of the greenhouse mist sprayer fully.

根据采用先进施药技术的要求，本研究的设计内容主要有：⑴采用气液两相流喷雾技术，基于气力雾化原理，设计双流体喷头；⑵采用辅助气流输送雾滴，气流源为风机，对风机进行设计、选型；⑶为满足不同作物、不同栽培情况及提高雾滴分布均匀性、沉积性的施药要求，设计能带动喷射部件在一定角度内、以一定转速的旋转摇摆机构，本研究选用调速电机调节其摇摆速度，并利用反向行程开关调节其摇摆角度；⑷为满足不同高度作物、不同射程的施药要求，设计能调节喷射部件高度的升降机构，这里选用气缸为主要构件，既可以起到整机支架的作用，又可方便进行升降、固定控制；⑸设计行程开关的控制电路以及整机的控制系统。

Especially, contact angle of a real three-phase system is usually not, as predicted by the Young equation, defined uniquely, but varies in a range of values-the phenomenon known as hysteresis of the contact angle.

特别是，实际三相系统的接触角一般能在某个范围内被钉扎不动，不象Young方程所指出的那样有唯一确定的值，称之为接触角的滞后现象。

The degree of angle θ at different cross-sections of anterior neck were all within the range of 35° to 55°. With the interval of 5 degree as a unit, the mean degree of angle θ is 45°for 9cases, 50°for 2 cases, and 40°for one case.

病人颈部标示区不同截面不θ角度数都落在35至55度之间，若以5度为间隔单位，其中有9例θ角平均值为45度，2例平均值为50度，1例平均值为40度。

In order to enlarge the angle measurement range, a new method which can linearize the principle and realize random angle measurement by interference was proposed here.

为了增大测角范围，提出了一种将测量原理进行线性化处理的方法，以实现任意转角的干涉测量。

4" Refers to four leisure industry piece area, respectively is the small fish mountain history culture leisure piece area, namely use small fish mountain peripheral Kang Youwei, Wen Yiduo, Liang Shiqiu, Tong Dizhou, Shen Congwen historical culture celebrity former dwelling Lian Cheng and so on tourist routes, form the wide range the historical culture celebrity block; Collects the spring movement culture leisure piece area, namely by the day peaceful stadium, collects the spring square, the Zhongshan Park, the Victoria Peak forest park, the botanical garden, happy moves the world, the oriental cherry to meet and so on activities, the guidance increases the movement, the cultural festival to celebrate the activity in this area development; Eight critical junctions convalesce the cultural leisure piece area, already is called "the international construction exposition" Ou Lu the character and style construction resources superiority, uses for guides the dining office, the foreign land character and style dining and so on industry condition gathering; The peaceful angle commerce culture leisure piece area, in retention peaceful angle construction original Ou Lu the character and style, makes into it by the coffee, the bar, the foreign land dining, the high-end office, convalesces the commercial culture leisure area primarily."

&4&是指四个休闲产业片区，分别是小鱼山历史文化休闲片区，即利用小鱼山周边康有为、闻一多、梁实秋、童第周、沈从文等历史文化名人故居连成的旅游线路，形成更大范围的历史文化名人街区；汇泉运动文化休闲片区，即以天泰体育场、汇泉广场、中山公园、太平山森林公园、植物园，欢动世界、樱花会等活动，引导增加运动、文化节庆活动在该片区发展；八大关疗养文化休闲片区，已被称为&万国建筑博览会&的欧陆风情建筑资源优势，用来引导餐饮会所、异国风情餐饮等业态的集聚；太平角商务文化休闲片区，在保留太平角建筑原有的欧陆风情，将其打造成为以咖啡、酒吧、异国餐饮、高端会所、疗养为主的商务文化休闲区。

This paper gives a precise definition about crank angle between extreme positions for planar four-bar linkage and deduces the range of crank angle between extreme positions of crank-rocker mechanism , slider-crank mechanism and crank shaper mechanism.

对平面四杆机构极位夹角的定义作了较确切的表述，并推导出了曲柄摇杆机构、曲柄滑块机构和摆动导杆机构极位夹角的取值范围。

"The operators will suffer a temporary decrease in the number of consumers and short message services as people may not like having to provide their ID cards for a phone number," Xu Junqi, vice-dean with the Policy-Making Institute of the Telecommunications Research Centre under MII, said yesterday.

信息产业部下属的通信决策研究院副主任徐俊其昨天说：&实行手机实名制后，人们可能不太情愿用身份证注册手机号，所以通信运营商会暂时面临用户减少和短信用户减少的问题。&

I don't believe in make-believe!

我不相信这些虚构的故事。