查询词典 radial engine

Methods: 60 Wistar rats were randomly divided into three groups, with 20 rats each. The right radial nerve was repaired with end-to-side fashion after windowed, the distal end being sutured to the epineurial window (0.12 cm×0.12 cm) 0.15 cm distal of the medial fasciculus. The left radial nerve was only windowed as control.

Wistar大鼠60只，随机分为3组，每组20只，每只右侧神经外膜开窗（0.12 cm×0.12 cm），将臂丛后束损伤后的桡神经远断端端侧吻合于外膜开窗的内侧束远端0.15 cm部位，左侧不做吻合。

The radial mobility is highest in the region of high electron temperature and when the magnetic field lines are radial.

光线的可动性在高的电子温度和有磁性的领域线何时是光线的区域中是最高的。

The plurality of teeth are radially distributed, line parts of the finger-shaped teeth form a certain angle with the radial line in radial direction of the round disk, and extend to the outer circle from arc.

多个轮齿非放射状排布，指形上直线部分与圆盘径向放射线成一定角度，最后由圆弧延展到外圆上。

Firstly, the equation for stress intensity factors under static uniform pressure is used as the reference case, and then the weight function for a thick-walled cylinder containing a radial edge crack can be worked out. Secondly, the dynamic stresses in uncracked thick-walled cylinders are solved under internal impulsive pressure by using mode shape function method. The solution consists of a quasi-static solution satisfying inhomogeneous boundary conditions and a dynamic solution satisfying homogeneous boundary conditions, and the history and distribution of dynamic stresses in thick-walled cylinders are derived in terms of Fourier–Bessel series. Finally, the dynamic stress intensity factor equations for thick-walled cylinder containing a radial edge crack subjected to internal impulsive pressure are given by dynamic weight function method.

首先采用静态内压下的应力强度因子作为参考解，得到了带径向边裂纹厚壁圆筒的权函数；然后用振型函数方法推导无裂纹厚壁圆筒在冲击内压下的动应力响应，分析中将相应的弹性动力学方程解分为满足非齐次边界条件的准静态解和满足齐次边界条件的动态解的叠加，利用傅立叶-贝塞尔级数展开，推导出了厚壁圆筒内动应力的响应历程和分布规律；最后由动应力权函数方法导出带径向边裂纹厚壁筒在冲击内压下的动态应力强度因子计算公式。

Firstly, from Gauss' equations and relative motion equations, the relation of control impulse and relative motion was expressed as analysis formulas and simplified based on the near circular condition. By deeply analyzing the mechanism of impulses in each directions (radial, in-track and cross-track directions) effect on relative motion respectively, two maneuvers to establish formation flying are provided: one is to utilize the impulses in radial and cross-track directions, the other is to utilize the impulses in along-track and cross-track directions. Both of the two methods can establish satellite formation flying of any configuration. The method with impulses irradial and cross-track directions needs only 3 impulses, while the method with impulses in along-back and cross-track directions needs 4 impulses. Lastly, by an example of establishing a space-circle formation flying, two maneuvers were compared with each other in the amount of impulses and fuel consuming estimation.

首先由高斯型拉格朗日轨道摄动运动方程得到轨道坐标系中控制冲量与轨道根数偏差的关系，基于近圆轨道的条件简化并带入相对运动方程，得到控制冲量与相对运动的关系表达式；通过深入分析各个方向（径向、沿迹向与轨道面法向）的控制冲量对相对运动的影响，给出了分别用径向与轨道面法向控制冲量组合和沿迹向与轨道面法向控制冲量组合实现编队捕获的两种控制策略；最后给出了一个空间圆编队捕获实例，并从燃料消耗、施加冲量次数及捕获时间等角度对比研究了两种控制策略的特点。

The axial direction and radial direction spectrum is blue-shift or red-shift. On axial direction, the blue-shift or red-shift increases with the relative propagation distance, truncation parameter, refractive index constant increases and temporal coherence length decreases, and the spectral-shift gurgitation becom gragually steady. On radial direction, spectral switches appear, and the truncation parameter, spatial coherence parameter, temporal coherence length and refractive index constant also influence critical position and transition height et al.

光谱沿轴向、径向均出现蓝移或红移，随着相对传输距离、光阑截断参数、空间相干参数及折射率结构常数的增大，脉冲时间相干长度的减小，轴向光谱蓝移量或红移量逐渐增大，并且由明显地起伏逐渐趋于稳定，沿径向出现了光谱开关，光阑截断参数、脉冲时间相干长度、空间相干参数和折射率结构常数对光谱开关的数目、光谱开关的临界位置和光谱跃迁量等也产生影响。

The paper introduces to the control principle of the radial drilling machine. Established the programmable controller improve the design project of electric control system of Z3040 radial drilling machine. Completed the design of the software and hardware of the electric control system, Among them include the model of PLC choice、the I/O allotment of the address、the I/O hardware connects the line diagram、PLC trapezium diagram ' s design.

论文分析了摇臂钻床的控制原理，制定了可编程控制器改造Z3040摇臂钻床电气控制系统的设计方案，完成了电气控制系统硬件和软件的设计，其中包括PLC机型的选择、I/O端口的分配、I/O硬件接线图的绘制、PLC梯形图程序的设计。

The average correlative coefficients of linear regression function for isochronous stress- axial strain curve are 3.92% higher than that of average correlative coefficients of linear regression function for isochronous stress- radial strain curve, so nonlinear creep property of the fine sandstone specimen in axial direction is correspondingly weaker than that in radial direction.

应力－轴向应变等时曲线线性回归函数的平均相关系数高出应力－径向应变等时曲线线性回归函数的平均相关系数3.92%，因此其轴向非线性蠕变特性相对于径向非线性蠕变特性更弱。

The gear double-faced joggle instrument is the special system to measure the errors of the radial resultant error for one gear and the radial resultant error for one tooth of a gear.

齿轮双面啮合检查仪是检测齿轮径向综合误差ΔF"和齿轮一齿径向综合误差Δf"i的传统仪器。

Until the 1990s, surgical treatment involved a procedure called radial keratotomy, which entailed making radial cuts in the corneal surface to flatten the curvature to correct myopia.

直到20世纪90年代，外科治疗所涉及的一个程序，所谓的放射状角膜切开术，其中涉及决策径向削减在角膜表面平坦的曲率，以纠正近视。

It has to be computed by the host for the actual clock rate.

主控制器可以用来计算实际的时钟速率。

Let's see what you got.

让我看看你的东西