查询词典 printer error

The best ink in the off-time after opening the packaging end use, not to open the ink on the outside when not in use Add to carton packaging, the cartridge so as to avoid talking about the dust falling into the hands of the next use of the dust caused by plugging into the nozzle first, the head following a reset state of ink wash sponge pad, open the front cover, press the Print Paper knife, move out, the hair can not suction clean cloth towel or sponge the ink pad, a large amount of about 10 days, then wash first, because each sponge pad is printer ink wash drawing of fatigue, if the dust and fatigue more ink will be solidified with the protection of Garra and print images will be the first flush, if the plug was found, and if the use of cleaning 3 seconds is not normal use, we must enter the printer maintenance menu kk2 or use kk1 cleaning, large format printers and a small printer operation principle is similar, if the correct maintenance and use, it will increase the service life, which Like is like a car, but also for us to maintain and are familiar with it

墨水最好在拆开包装后断时间内使用完，不要把打开的墨水放在外面，不用时包装好放入纸盒内，以免墨盒嘴上落入灰尘，下次使用时灰尘进入喷头造成堵头情况，喷头复位状态下面有一个洗墨海绵垫，打开前盖，按下打印切纸刀，往外移，用不起毛的纸巾或布吸干净海绵垫的墨水，用量大的话大约在10天清洗一次，因为海绵垫是打印机每次冲洗时吸取疲墨水的，如果灰尘多就会和疲墨水凝固在一起，对墨头的保护和打印头冲洗会有影像，如果发现堵头情况，如果使用清洗3秒还不能正常使用，我们要进入打印机的维护菜单用kk2或kk1清洗，大幅面打印机和小打印机的操作原理是差不多的，如果正确的维护和使用，它的使用寿命就会增长，这也好比一辆轿车一样，还要我们去维护和熟悉它

But note monlchamus, we should first of all, clearly a few details: if I'm using the print head integralization cartridge, note white without note, waydifferent spent cartridge, and throw away, it would be better then reuse, even when printed, generally does not have any prejudice to the printer; if the print head and the wall split-printer ink cartridges, ink in the note, we'd better choose the original manufacturer's selection of ink, because, the printer manufacturers compatible ink normally eligible for canceling the user's warranty, if inadvertently broke the print head and is concentrating.

但在注不朱后，我们答首不后澄辉几个梗概：假如我用的是打印脚一体化不朱盒，那么不注白不注，横竖不朱盒也不有什么用了，与其扔失，不立不如再宝贝诳骗，不离算打印不败果不抱负，凡是也不会差打印机有什么保护；假如用的是打印脚与不朱盒分体的打印机，那么在轻注不朱水时，我们最坏拔取原厂的不朱水，因为采取兼容不朱水，打印机厂家凡是城市裁撤用户的保修资格，给是失慎不弄好了打印脚，不离真是因小失不小了。

For equipment of effective protection good printer, many people want to be restricted to undertake limitative to the access of printer, be used in order to prevent printer at will!

为了有效保护好打印机设备，不少人都想对打印机的使用权限进行限制，以防止打印机被随意使用！

Print ribbon is installed, we need to print frame first uninstall it from the printer, uninstalling the device must be near the print head from the location you pull up hard, in order to easily print aircraft had come from the printer ; the following, we also need to open the print frame, taking into account different models of printers that it installed on the structure of the printing frame is not exactly the same, so the installation of ribbon winding method is not exactly the same, we have to uninstall it before the original band, we a good look around the ribbon before the correct method, or else do not print the right way to install the ribbon will not be able to function properly, but also may lead to the printer not work correctly.

在安装打印色带之前，我们需要先将打印架从打印机中卸载下来，在卸载该设备时，必须先从靠近打印头的位置处用力向上拉一下，才能把打印架轻松地从打印机中拿下来；下面，我们还需要将打印架打开，考虑到型号不同的打印机它的打印架安装结构并不完全相同，因此色带的安装缠绕方法也不完全相同，我们在将原色带卸载下来之前，一定要好好地观察一下色带以前的正确绕法，否则不按正确方法安装的打印色带不但不能正常发挥作用，相反还有可能导致打印机无法正常工作。

The time that it takes the job to get to the printer, the time that it takes for the printer to process the job and the time that it takes for the printer to actually print the job once it has received it.

当时，它以就业去印当时，它以就业为印表机加工和时间缩为打印机打印实际工作一旦收到。

For the all classes of dies, if we analyse the fluctuate, tendency of increase and decrease and law which appeared in the die's whole life, we will find that the master of the error are changeless; the error that because the abrade of the cutter and impression will be as the cutter grinding times increased at the same time. And that will cause the error oversize gradually; and also have another part error are unconventional , unforeseen.

对各类冲模冲件误差在冲模整个寿命中出现的波动、增减趋向及规律等进行全面分析便可发现：冲件误差的主导部分是不变的；因刃口或型腔的自然磨损而出现的误差增量随冲模刃磨冲数增加而使这部分误差逐渐加大；还有部分误差的增量是非常规的、不可预见的。

Because of fault in operation and the precision of instrument,the defect error and accidental error are involved in the procession of data collection,the defect error that are brought by mistakes of people and influence of outside is large,the contingency error that are inevitably and randomicity is little.

在采集数据过程中，由于某些操作或仪器原因，往往使数据中包含人为错误，或外界干扰产生的量值较大的"过失误差"以及不可避免的带随机性质且量值较小的"偶然误差"。

After analyzing the main error sources in the system, it discusses the error separation and error compensation of parts of the error source.

在分析了系统的主要误差源后，本论文重点研究了部分测量误差的分离补偿与修正。

Error analysis of digital instruments on their characteristic parts including sample/holder circuit error and analogue/digital convector error was reviewed in this paper. With the help of some examples and data tables, error origins and the synthetic method were discussed.

评价了数显仪特征部分误差分析方法，包括：采样／保持电路、模数转换单元的误差，并通过典型例子和列表数据分析了多种误差源及其综合计算方法。

Relation between geometrical contour error of inner corner and machining condition is investigated by the experimental plan of Taguchi quality design. Through the quantitative analysis, the geometrical contour error is mainly affected by wire tension and flushing pressure. By regression analysis, a mathematical model is established to estimate cutting path error of corner cutting. According to the estimated cutting path error, the program path is corrected.

研究首先以田口式品质设计实验计画法来探讨加工参数与隅角形状误差间的关系，从变异数分析的结果得知，线张力与冲水压力是对於隅角精度影响最显著因子，应用回归分析建立转角加工路径误差量估测模式，利用此模式以预测不同加工条件下隅角加工路径误差量，依据预测加工路径误差量计算轨迹补偿量，实验结果证明本文所提出轨迹补偿策略可有效提高60%之隅角加工精度。

Fostering the concept of multi-culture firmly and mastering the development of advanced culture correctly are conductive to resisting terrorism, separatism of nationalities and ultraism of religion, which is of great academic theoretical, immediate and profound historical si...

牢固树立多元文化的理念和正确把握先进文化的发展方向，有助于在世界范围内自觉地抵制恐怖主义，民族分裂主义和宗教极端主义。不仅具有重大的学术理论意义，而且也具有重大的现实意义和深远的历史意义。

But if anyone walks in the night, he stumbles, because the light is not in him.

11：10 若在黑夜行走，就必碰跌，因为那光不在他里面。