查询词典 plane angle

Also be aware that changing the orientation or size of a parent part changes all of it's "children" as well. If you shrink the WingRin for instance, the whole wing, plus engines and landing gear will shrink with it. Changing the CF_D0 will usually affect the whole plane. Speaking of the CF_D0, this is the most important part of the plane. All the other parts are connected to it, and reorienting it can sometimes cause the plane to fly incorrectly. Not all plane parts are oriented properly in the first place, so simply replacing the CF_D0 in the folder might lead to a fuselage 90 degrees off angle, etc, but changing the orientation sometimes changes the flight profile, etc.

同样要注意你改变"父模型"的方向或尺寸的话依附它的"子模型"也会跟着改变，如果你缩小机翼，那么机翼上的发动机和起落架会跟着缩小，改变CF_D0通常会影响整个飞机，说到CF_D0，它通常是整个飞机最重要的部分，其他的部分都依附于它，改变它有时会使飞机飞行不正常，通常第一次导入不是说有的部分都能准确定位，所以简单的替换CF_D0可能会导致机身偏转90度，而有时后改变方位会影响飞行轨迹，这是很让人头疼的。

Sort-and-Incremental Algorithm Definition of h-plane's polar angle:' for h-plane like x-y≥constant, we ≥ define its polar angle to π.

半平面的极角定义：比如x-y≥半平面的极角定义比如≥常数的半平定义它的极角为π。

Using guyed tower middle line insulator string as an object, through analyzing of distance between cross arm and boom guy plumb plane, and projecting insulator string length, angle, conductor wind inclined angle, and sag to boom guy plumb plane, middle line insulator string tracking equations can be established.

以拉线塔中线绝缘子串为分析对象，通过对横担、拉线铅锤面间的距离分析，再将绝缘子的串长、角度，导线风偏角、弧垂投影至拉线铅锤面，在拉线铅锤面建立中线绝缘子串的轨迹方程，以带电体与拉线间的距离为限制条件，从不同角度计算出第1、2、3极限风偏角，取其中的最小值为极限风偏角。

The following values was measured: angle of cusp line between the second and third molar, impact state and depth, distance from Rickett's Xi to distal cusp of third mandibular molar along the occlusal plane, anterior border of ramus to the third mandibular molar, distance from projection of distal contact point of maxillary third molar to intersection of pterygoid vertical on occlusal plane.The change between pre-and post-treatment was calculated and analyzed with SPSS10.0 software package.α angle, Xi-LTM, R-LTM, R-LTM were tested with independent-sample t test, impact state and depth was tested with Chi-square test. Influence of age on the values was also evaluated.

测量治疗前后的第二、第三磨牙牙尖连线角度、阻生状态和深度，Rickett's Xi点到下颌第三磨牙远中尖距离、下颌支前缘到第三磨牙远中尖距离、翼上颌裂切线到上颌第三磨牙后缘的距离及上、下磨牙的前移量，计算治疗前后各变量的差值，采用SPSS10.0软件包进行统计学分析，α角、Xi-LTM、R-LTM、R-LTM用t检验，阻生状态和深度用χ^2检验，比较年龄因素对各指标的影响。

Results: The atlanto-occipital transarticular screw trajectory was cephalad tilting in sagittal plane and medially tilting in coronal plane; the ideal angle of the trajectory was (53.3±3.4)° upper tilting in sagittal plane and (20.0±2.6)° midline tilting in coronary plane.

结果：寰枕关节经关节螺钉固定的钉道理想角度为：螺钉方向在矢状面的上倾角为(53.3±3.4)°，在冠状面的内倾角为(20.0±2.6)°。

In light of Fresnel formula the author analyses the features of linearly polarized light reflecting on the surface of apparent medium,discusses the relationship between the circumrotation in the plane of vibration,changes of the light intensity and the angle of incidence,the orientation of the plane of vibration,and addresses the relationship between the swing,phase and the incident angle and medium.

自然光在分界面上反射的一些特点在许多光学教材[1，2]上都进行了介绍，本文根据菲涅耳公式和菲涅耳定律，分析线偏振光在透明介质分界面上反射时的一些特点，讨论反射光的振动面所发生的旋转及光强度的变化与入射角、振动面的方位之间的关系；进一步讨论在全反射情况下，反射光的振

Through Hilbert transform, a signal's plane trace can be get. There are two frequencies in the tested signal, so the signal's plane trace may be looked as the track of the out pole's end when two poles rotate around parallel axles. Using the knowledge of motion synthesis in theory mechanics, a formula to describing the change of plane trace's step length and angle for two-frequency be get. So we may prolongate the tested signal's plane trace from the echo's initial arriving moment, and get a certain length of the signal's prolongation.

通过Hilbert变换可得到测试信号的平面迹线，测试信号中只含有两个频率成分，视为双频信号，双频信号的平面迹线相当于两连杆绕平行轴转动时外杆杆端迹线，利用理论力学中运动合成和瞬心知识，推导出双频信号平面迹线步长平方满足余弦线性复合函数，而迹线转角可视为线性变化，据此可对回波到来之前的测试信号平面迹线作延长，得到一定长度的信号延展段，信号延展段与实测段作差可得到一次、二次回波的第一个波峰值。

A crown angle is the angle of the bezelfacet plane relative to the table plane.

检察官一角是角的左边框侧面平面相对表平面。

A pavilion angle isthe angle of the main facet plane relative to the table plane.

一亭角的角度来看，主要面平面相对表平面。

A crown angle is the angle of the bezelfacet plane relative to the table plane.

稽查官一角是角的左边框侧面平面相对表平面。

With the development of highway construction, the speed of cars has been gradually increased.

随着公路的发展，汽车的车速也在不断提高。

So we basically had to develop a bond with the animal in terms of socializing with it.

所以我们就主要想通过跟它沟通的方式来建立一种良好的关系。