查询词典 plane angle

The contents of this dissertation are involved in studies on quasi steady-state condition of a slow speed-varying rotor system, gain-scheduling control of a quasi steady-state rotor active balancing system, adaptive control of active balancing for a fast speed-varying rotor with actuator time delay and adaptive control of active balancing for a fast speed-varying rotor with actuator saturation. The rotors to be studied include a Jeffcott rotor, a Jeffcott rotor with anisotropic bearings, a flexible rotor with single collocated balancing plane (actuator plane and measuring plane are almost the same one) and a flexible rotor with multiple collocated balancing planes.

研究的内容涉及慢变速转子的准稳态条件、变速准稳态转子主动平衡系统的增益调度控制、带作动器时迟的快变速转子主动平衡系统的自适应控制与带作动器饱和的快变速转子主动平衡系统的自适应控制，转子类型包括Jeffcott转子、轴承各向异性的Jeffcott转子、单并置平衡平面(作动器和测量平面几乎在同一个平面)的柔性转子和多并置平衡平面的柔性转子。

Common rolling plank is shown intense (orientaton of 0002) tool reference plane, after rolling of horn waiting for diameter, plank grain orientaton by original (change of orientaton of 0002) tool reference plane is; of orientaton of blame tool reference plane the existence after strain crack of common rolling plank is many twin brilliant, amount of brilliant of twin of drawing of direction of rolling of edge of plank of rolling of horn w

普通轧制板材呈强烈的(0002)基面取向，等径角轧制后，板材晶粒取向由原来的(0002)基面取向转变为非基面取向；普通轧制板材拉伸断裂后存在大量孪晶，等径角轧制板材沿轧制方向拉伸孪晶数量明显减少，等径角轧制有可能启动了新的滑移系，而拉伸孪生只是作为一种协调变形机制。

The rub-impact between rotor and stator often occurs because the rotor shaft stiffness decreases following the occurrence of the crack in the rotor shaft, and thus the coupling fault with rub-impact and crack is hackneyed fault type. Based on the nonlinear dynamical model of the cracked rotor-bearing system with rub-impact, the stability of the periodic motion and instability way were studied in unbalance-rotating speed plane and rotor/stator clearance- rotating speed plane and crack depth- rotating speed plane, and the main results were validated by the experiment.

转子轴承系统裂纹故障的出现会引起转子系统转静件之间碰摩故障的发生，因此裂纹碰摩耦合故障也是转子系统常见的故障类型，本文在裂纹碰摩耦合故障转子轴承系统的非线性动力学模型基础上，分析了系统在不平衡量-转速、碰摩间隙-转速、裂纹深度-转速等参数域内，周期运动的稳定性及其失稳规律，并用实验验证了主要理论结果。

In the typical setup of Michelson interferometer, turning the tested object a small angle generates an air wedge between the object plane and the reference plane. The wedge produces equal thickness interference fringes.

采用典型的迈克尔逊干涉光路，将物体偏转一微小角度（等效为物面与参考面间形成空气楔）产生等厚干涉，可在物体的表面引入包含物体高度信息的载波干涉条纹。

The problem of obtaining the dip angle of the plane figure to projection plane with Rytz Method is studied in this paper.

本文应用里茨作图法，研究由单面投影求平面图形对投影面的倾角问题

The said Martinez stretcher comprises concave spherical reflecting lens, plane reflecting lens and grating. The said compressor comprises plane reflecting lens, inner right angle reflecting lens and grating, which is characterized by the following: the grating fringe density of the stretcher is larger than that of the compressor.

所述的马丁内兹展宽器由凹球面反射镜、平面反射镜和光栅组成；所述的压缩器由平面反射镜、内直角形反射镜和光栅组成，其特征在于，展宽器的光栅条纹密度大于压缩器的光栅条纹密度；展宽器中的凹球面反射镜曲率半径位0.9～1.2米，光栅距凹球面反射镜的位置为凹球面反射镜曲率半径的1/3～1/2。

Rytz Method ; maximum oblique line ; Right-angled Triangle Method ; plane figure ; projection plane ; dip angle ; conjugate diameter

里茨作图法；最大斜度线；直角三角形法；平面图形投影面；倾角；共轭直径

In the design of the structure, a new 2-D scanning machine is put forward which has overcome the limit of common underwater TV system influenced by the environment of water. It can scan 360 degrees in horizontal plane and 90 degrees in vertical plane, and there isn't dead angle.

根据以上内容的研究和分析，在结构设计方面，提出了二维扫描机构，它克服了一般水下电视系统由于使用特殊环境的限制不能进行扫描的缺点，可以进行水平360度，垂直90度全方位扫描，并且不存在盲区。

The parity-violating energy difference of D- and L-alanine was undertaken as a function of the dihedral angle θ of the carboxylate plane with respect to the Cα-Hα plane.

自然界的力只有弱力是宇称不守恒的。在分子物理中，电弱力宇称不守恒是导致D-和L-丙氨酸能差的根源。

The in-plane equivalent elastic modulus and tensile strength of stitched composite laminates are studied, and its found that the in-plane equivalent elastic modulus decreases with the increase of stitch density, stitch thread diameter, maximal misalignment angle and the distortion width, and the range is about 5%. The tensile strength of stitched composite laminate increases with the increase of stitch step and decreases with the stitch space.

研究结果表明：随着缝纫密度、缝纫线直径、最大纤维偏转角和缝纫变形区宽度的增加，缝纫复合材料层合板面内等效模量逐渐降低，最大降幅一般在5%左右；缝纫复合材料层合板的拉伸强度随缝纫针距的增加而增大，随缝纫行距的增加而降低，因此缝纫密度对拉伸强度的影响程度要看具体的缝纫针距和行距。

If you were not , and OS X just booted normally, have no fear.

如果你没有，和OS X刚刚启动通常，没有恐惧。

I only want to preserve our all .

我只想保存好我们的一切