查询词典 parallel angle

To the problem that the isotropy and the technological efficiency of the parallel kinematic machine based on Stewart platform are not satisfactory, a novel architecture of 6-DOF 3-dimensional platform parallel kinematic machine (6-DOF 3-D PPKM) based on the 2-2-2-SPS 3-D PPR is presented. The technological efficiency of design of the parallel kinematic machine is analyzed. Its workspace and the effect of design parameters to the workspace volume are studied. By using the submatrices of Jacobian matrix and force Jacobian matrix, the kinematics/mechanics transmission isotropic indices, kinematics transmission indices, load-bearing capacity indices at any configuration of the parallel kinematic machine are proposed, respectively.

分析其结构和装配工艺性，研究其定位姿工作空间及机床结构参数对工作空间大小的影响，基于Jacobian矩阵和力Jacobian矩阵中同量纲元素构成的子阵，提出该并联机床在任意位姿的运动／力学传递各向同性评价指标、运动学传递能力评价指标和承载能力评价指标；基于柔度矩阵中同量纲元素构成的子阵，提出该并联机床在任意位姿的力-位置柔度评价指标、力-姿态柔度评价指标、力矩-姿态柔度评价指标和力矩-位置柔度评价指标；研究各性能指标在定位姿工作空间内的分布情况。

In this paper, mainly from the parallel curves, the definition of the parallel surface to start to discuss the legislation of their sentence, nature, and to study certain aspects of their applications, have been on parallel curves, parallel surfaces at some conclusions.

本文主要从平行曲线、平行曲面的定义入手，讨论了他们的判立、性质，并研究了他们在某些方面的应用，得到了关于平行曲线、平行曲面的一些结论。

The electrostatically actuated membrane is used in this kind of tunable capacitor. Both of two parallel-plate of the new tunable capacitor can deflect when subject to parallel-plate electrostatic actuation, this is different with the novel parallel-plate tunable capacitor which is only one of the two parallel-plate can deflect.

这种可调电容器采用静电驱动金属膜的原理工作，与一般的只有单极板可动的可调电容器相比，这种结构的不同之处在于采用一些复杂的制作工艺，制作出电容两块极板均可动的可调电容器。

As walk-off angle and acceptance angle of beam limit the conversion efficiency and the tunable wavelength range of difference frequency generation, research include effective nonlinear coefficient, walk-off angle and acceptance angle as functions of wavelength, the relationship between conversion efficiency and acceptance angle, and the impact of crystals length on the process of frequency conversion.

由于光束的走离角、允许角限制了转换效率和差频调谐波长范围，研究内容还涉及了有效非线性系数、走离角和允许角与波长的关系，转换效率与允许角的关系，以及晶体长度在频率变换过程中产生的影响。

Based on force diagram an analytical expression between some factors and splaying angle of the bar is brought forward, pointing out that splaying angle of the bar should be 2 3 degrees, and slitting angle should be 30 degrees approximately, outboard slant angle on the slitting groove should be 45 50 degrees and bite angle should be 7 8 degrees.

为稳定小规格带肋钢筋的三线切分轧制，对涉及棒材张开角的切分孔孔型诸角度进行了分析，通过对轧件受力状态的讨论，提出了诸因素与棒材张开角之间的解析式，指出满足三线切分稳定轧制时的棒材张开角应为 2°～ 3°，相应的孔型切分角为 30°左右，孔型外侧壁倾角应在 4 5°～ 5 0°之间，咬入角可控制在 7°～ 8°之间等。

Under the vertical load, the strength of rock mass is higher when there is only one group of joint and the dip angle is less than 20 or higher than 80; When dip angle is between 20 to 80, the strength of rock mass is much lower, it is smallest when dip angle is about 50, and it is lower when this kind of dip angle is in combination with other angle.

7在铅直向荷载作用下，岩体中只存在一组倾角小于20°或者大于80°时，岩体的强度相对较高；当岩体中存在一组节理的倾角在20°～80°间时，岩体的强度值很小，而且在与其他倾角的节理组合时，岩体的的强度值变化不太大，特别是当节理倾角为50°左右的时候，岩体的强度相对最低。

Exterior Opposite Angle Area : According to one angle area of the triangle, if we extend the two angle lines to the opposite direction, the area formed by the extending lines which like mirror area to the original angle is called here Exterior Opposite Angle Area.

外部对角映射区：针对三角形的一个角，将构成该角的两条相邻线段进行对角方向的虚线，这两条虚线围成的区域就是该三角形一个角的外部对角映射区。

Exterior Opposite Angle Area: According to one angle area of the triangle, if we extend the two angle lines to the opposite direction, the area formed by the extending lines which like mirror area to the original angle is called here Exterior Opposite Angle Area.

外部对角映射区：针对三角形的一个角，将构成该角的两条相邻线段进行对角方外部对角映射区向的虚线，这两条虚线围成的区域就是该三角形一个角的外部对角映射区。

With a dip angle between 15° and 30°, the uplift of an obducted plate during continental collision is much higher, and able to form a high mountain. The uplift is greatest with a dip angle of 15°; whereas with a dip angle between 30° and 45°, the subduction depth of a plate is much deeper, and able to form a deep basin. The subduction depth is greatest with a dip angle of 45°. When the dip angle is equal to or greater than 75°, subduction and obduction movements between two continents become undistinguishable.

当断裂带倾角在15~30°时，两个大陆板块碰撞导致的仰冲板块一侧隆升高度相对更大，利于形成高大的山脉，其中以15°倾角对应的仰冲板块一侧隆升最高；当断裂带倾角在30~45°时，两个大陆板块碰撞导致的俯冲板块的俯冲深度相对更深，利于形成深陷的盆地，其中以45°倾角对应的俯冲陆块一侧俯冲最深；当断裂带倾角≥75°时，两个大陆板块之间的相对俯冲和仰冲作用变得不明显。

Experiments exposed that the inner flow of tooth space in the micro-channels was proved to be cycled flow after fully development. For the more, low velocity vortex cavities existed in the vertex angle and inner side of bend angle of straight angle micro-channel, while back flow only appeared in the internal side of bend angle of round angle micro-channel. It's easy to take place deposition in the low velocity vortex cavities, which is the main cause of blocking.

试验发现各类微通道齿间内流充分发展后是一种重复性流动，平角微通道顶角和转角内侧存在低速涡旋区，圆角微通道只在转角内侧出现回流，颗粒在低速涡旋区易发生沉积，是造成堵塞的主要原因。

Fostering the concept of multi-culture firmly and mastering the development of advanced culture correctly are conductive to resisting terrorism, separatism of nationalities and ultraism of religion, which is of great academic theoretical, immediate and profound historical si...

牢固树立多元文化的理念和正确把握先进文化的发展方向，有助于在世界范围内自觉地抵制恐怖主义，民族分裂主义和宗教极端主义。不仅具有重大的学术理论意义，而且也具有重大的现实意义和深远的历史意义。

But if anyone walks in the night, he stumbles, because the light is not in him.

11：10 若在黑夜行走，就必碰跌，因为那光不在他里面。