查询词典 message block

The simulation results of the cylinder-block model were given in the article, consistent with that of Middlemen"s. It was shown that the block part could improve the uniformity of the flow distribution. The analysis of the flow field of some materials with different power-law factor in the die designed by Mckelvey was close to that of Mckelvey"s. It was shown that the flow distribution was uniform in the die that can producesheets with 1200mm in width. During the analysis the flow channel was divided into several parts to get the details about the fluid flow in each area. A conclusion was drawn after analyzing the influence of the die pressure on the flow distribution, that the higher pressure is good for the output and bad for the uniformity of the distribution. Simulation of the die applying the cylindrical main runner showed the fact that when the cylinder replaced the cone the change of uniformity was trivial. The uniformity of the non-block flow channel was so poor that the block in the proper position of the die channel was necessary. The project of the die for the wider sheet was put forth, and the analysis of the fluid flow in the die was shown.

本文模拟了圆柱管缝隙流模型的三维流动场，得到了与Middlemen结论一致的流动均匀性，并通过模拟直观地展示了采用阻尼块可以改善挤出均匀性的现象；分析了多种幂率指数的流体在Mckelvey等人设计的流道模型中的流动分布，得到了与Mckelvey的分析结果接近的压力降和流量偏差；本文建立了1200mm幅宽机头流道的三维有限元模型，并逐个分析各个区域和多个截面的流动分布状况，由此揭示了1200mm幅宽L-型机头流道内的流北京化工大学硕士学位论文动分布基本均匀，并在分析了机头压力对于挤出流动分布的影响后得出结论：较高的机头压力可以获得较大的产量，但是不利于物料均匀分布；模拟了采用圆柱管主流道时机头流道内的流动分布，得出结论：主流道由圆锥管改为圆柱管时对流动均匀性影响不大，通过设置适当的阻尼仍然可以达到挤出平衡；模拟了两端进料式圆柱管无阻尼流道的流动均匀性后得到结论：两端进料式无阻尼结构的流动均匀性较差，宽机头中仍然有必要设置阻尼块；确定宽幅机头流道的基本方案，并设计了一种宽幅防水卷材挤出机头流道的结构，通过流动模拟表明该种结构的流动均匀性较好；考察了宽幅机头对于不同厚度片材的挤出适应性，得到结论：当生产不同厚度的片材时，阻尼块高度需要调整。

First, the use of "BIOS BOOT BLOCK guide block" to restore, normally there is a BIOS will not be set to retain part of that process BOOT BLOCK, even if the BIOS update failure, Boot Block, or to control ISA card and floppy drive.

一是利用&BIOS BOOT BLOCK引导块&恢复，通常情况下BIOS中会有一个保留部分不会被刷新，那就是BOOT BLOCK程序，即使BIOS刷新失败，Boot Block还是能够控制ISA显卡与软驱。

The sketch and specific design approaches of mid-block street crossing are generalized and three management and control modes are discussed. Based on extensive investigation and survey, the paper analysis the arriving laws in different land-use condition and the traffic characteristics of different crossing entities under different control modes. The initial characteristic, the speed and dispersion of the mobile flow are also intensive studied, as well as the effect of mid-block street crossing. Establish the linear planning models on the coordination between the signals of mid-block crossing and intersection. Finally the evaluation of the model output is carried out from time saving results, safety, economic results and social results. Set the example of Taiping north road in Nanjing, surveying the traffic situation, applying the method of signal coordination between the mid-block crossings and intersection to realize the south-to-north signal coordination design. The evaluation results show the coordination plan are more superior to the current signal plan.

本文首先阐述了行人过街物理设施的概略设计和详细设计方法，讨论了路段人行横道的三种交通管制方式的设计方法和实用条件；其次，在充分的实际调查基础上，详细分析了不同用地性质条件下的过街需求的到达特性和不同交通管制下不同过街实体的交通特性，分析了进入路段的机动车初始流特性，并对机动车在路段中的车速特征、离散性以及路段信号控制人行横道对机动车流的影响进行了研究；然后，根据以上分析的过街交通和机动车交通的交通特性，建立了路段行人过街信号与交叉口信号协调控制的线性规划模型；最后，对模型输出的协调控制方案进行了效益评价分析，从时间效益、安全性、经济效益和社会效益四个方面，定量和定性相结合地对其实施效果予以评价；以南京市太平北路路段为例，根据现状交通状况，应用行人过街信号与交叉口信号协调控制的方法，对该路段由南向北方向进行单向协调控制设计，并进行方案效益分析评价，提出了优于现状控制方案的人行过街信号与交叉口信号协调控制方案。

Candy will be half plus half of the candy to the first block of a child; of the remaining one-third of the candy with candy third block to the second child; candy will be left with the fourth quarter to the third block candy child; candy will be left with the fifth block fifth candy to the fourth child; the last remaining 11 candy to the fifth child.

将全部糖果的一半再加二分之一块糖果发给第一个小孩；将剩下糖果的三分之一再加三分之一块糖果发给第二个小孩；将剩下糖果的四分之一再加四分之一块糖果发给第三个小孩；将剩下糖果的五分之一再加五分之一块糖果发给第四个小孩；将最后剩下的11块糖果发给第五个小孩。

In order to enlarge applied field of autoclaved aerated concrete block, China engineering building standardization association sent down "A class Autoclaved aerated concrete block and brickwork structure technology rules". The rules point out definitely building autoclaved aerated concrete block tier building can only use A class Autoclaved aerated concrete block.

为了将蒸压加气混凝土砌块推广应用至具有节能、抗震保障的多层承重建筑，扩大应用领域，以求得加气混凝土行业的更大发展，中国工程建设标准化协会砌体结构委员会已下达了，《A类蒸压加气混凝土砌块砌体结构技术规程》，规程将明确指出建造加气混凝土砌块多层房屋只能用A类蒸压加气混凝土砌块。

The invention discloses a device for spreading machine docking with trucks, which consists of damping mechanisms installed on both side between the spreading machine and the roller; the damping mechanism consists of side plate 1, sliding block 2, flexible element 3, and shaft 4, the flexible element 3 is sleeved on the shaft 4 of which one end linked with spreading machine and the other with sliding block 2, side plate is on upper section of sliding block 2 and fixed on the machine, lower section of sliding block is linked with roller.

本发明公开了一种摊铺机与卡车对接缓冲装置，它为设置于摊铺机机身前端与推滚之间的左、右各一副阻尼机构(10)；所述阻尼机构(10)包括端板(1)、滑块(2)、弹性元件(3)和轴(4)，弹性元件(3)套于轴(4)上，轴(4)的一端与推铺机机身(5)相连，滑块(2)与轴(4)的另一端相连，端板(1)位于滑块(2)上段之外，并固定于推铺机机身(5)上，滑块(2)的下段与推滚(6)相接。

Our main products include: cast iron inspection plate, crossed plate, welding plate, T-slot assembly platform, boring and milling machine table, coordinate platform, electrical test platform, Fire Works platform, floor boring machine table, magnesium light ping-foot aluminum, cast iron-type ping-ping-foot, bridge-type flat feet, feet, square, angle ruler tool dedicated, inspection box, line box, magnetic box, magnetic V-frame, deflection tester, gear beat tester machine testing wand adjust Sizing Block Machine, Machine Tool Sizing Block earthquake, ladder Sizing Block, contour Sizing Block.

我公司主要生产的产品有：铸铁检验平板、划线平板、焊接平板、T型槽装配平台、镗铣机工作台、三座标平台、电机试验平台、火工平台、落地镗床工作台、镁铝轻型平尺、铸铁平型平尺、桥型平尺、方尺、直角尺、机床专用角度尺、检验方箱、划线方箱、磁性方箱、磁性V型架、偏摆检查仪、齿轮跳动检查仪、机床检验棒、机床调整垫铁、机床防震垫铁、阶梯垫铁、等高垫铁。

The angle bracket is a standard way of showing that These lines are quoted from a previously posted message - the message to which this message replies.

角括号是一个标准方式表示，这些列被引述从一则事先被张贴发表的文章-这则文章回复的文章内容。

In the meantime, he still points out very much nowadays involve " short message network address " the company of business lacks stability, still get not less among them the tie of venture capital investment, Still be in network address of short message of cry out of ground of exert to one's utmost today, to tomorrow board of directors, feel another business has more again ' money ' road, short message network address is thrown into ash-bin by their conveniently.

同时，他还指出如今很多涉及"短信网址"业务的公司都缺乏稳定性，其中不少还受到风险投资的约束，今天还在卖力地吆喝短信网址，到明天董事会一开，又觉得另外一个业务更有'钱'途，短信网址就被他们随手扔进垃圾桶了。

If you have supplied a handler for a specific message, or for a range of messages, in your parent window's class, it will override reflected message handlers for the same message provided you don't call the base class handler function in your own handler.

如果你在控件的父窗口类中为一个或一定范围特定的消息提供了一个处理函数，对于同样的消息，如果在您的处理中您并没有调用其基类的处理函数它就会覆盖掉被反射的消息处理。

Now he worked in ajoint venture.

现在他在一家合资企业工作。

More troops in Afghanistan won't change any of the foregoing.

更多的在阿富汗的军队也不会改变之前的状况。