查询词典 mechanical efficiency

In this paper, two assemblies of special test equipments have been designed and fabricated by authors in our laboratory: namely Catalyst Molding Process Analyzer and Catalyst Mechanical Process Tester. These new skills are developed for the dynamic studies on whole mold forming process and crushing process of Fe-Cr WGHS catalyst pellet. Based on the orthogonal experimental design, the effects of some factors during the forming process of solid catalyst, such as predensification proportion, calcination time, calcination temperature and content of graphite on the mechanical strength of catalyst pellets are systematically examined, and the molding conditions have been optimized. Based on the experimental data, the relationship between catalyst density and forming pressure are educed, and the physical significances of some related parameters are described. The parameter of macro scopic elastic moduls has been suggested to character the mechanical properties of molding catalyst. The effects of molding pressure on mechanical properties of catalyst pellets are discussed, and results show that there exists a optimal molding pressure for the ideal mechanical properties: when over-high or over-low pressure is applied, the specific surface area and side crushing strength of catalyst pellets will decreased. The "rebound effect" will be undermined by the unsuitable pressure maintain process, resulting in the apparent decrease of mechanical strength of catalyst pellets.

本研究通过自行设计制造的催化剂模压成型过程分析仪（Catalyst Molding Process Analyzer， CMPA）和催化剂力学性质测试仪（Catalyst Mechanical Properties Tester， CMPT），以Fe-Cr系高温变换催化剂片剂为研究对象，对成型过程和受压破碎过程提供了全过程动态研究的新手段；本研究利用正交实验设计方法考察了固体催化剂成型过程中诸因素（包含预密致比例、煅烧时间、煅烧温度和石墨含量等）对催化剂成型体强度的影响，并对成型条件进行了优化；根据实验结果，关联确定了固体催化剂成型过程中的密度－压力关系式，并对方程中诸因子的物理意义进行了描述；提出了一种利用宏观弹性模量来表征成型催化剂的力学性质的方法；研究讨论了成型压力对催化剂成型体强度性质的影响，结果表明：对于催化剂成型体的强度和比表面性质，成型压力存在着一个最佳值，过高的成型压力会导致比表面积和侧压强度的降低；不适当的成型压力的维持时间会破坏&压力回弹&作用，造成催化剂成型体的机械强度明显降低。

In the seedlings time, the content of chlorophyll decreased by the deficiency of B, but the content of chlorophyll in the high efficiency cultivar decreased slowly than that of the low efficiency cultivar. This suggested that the leaves of the high efficiency cultivar can capture more light energy and the photosynthetic rate of the high efficiency cultivar decreased slowly. In the bolting time and blooming time, after two weeks of B deficiency treatment, the content of chlorophyll in the top leaves of the high efficiency cultivar decreased, and in the late time, the content of chlorophyll decreased slowly. But, the content of chlorophyll in the bellow leaves of the two cultivars had little changes. The reason may be that B in the high efficiency cultivar distributed to the propagative organ in the late growth, and the leaves were short of B.

苗期，缺硼导致甘蓝型油菜色素含量降低，且高效品种色素含量下降的幅度小于低效品种，表明营养生长阶段，同等程度的缺硼条件下，高效品种叶片对光能的收集能力以及光合速率下降的程度相对较小；苔期和花期，在两周的缺硼处理后，高效品种上部叶色素含量依然呈下降趋势，但随着生育期的推移，其下降幅度减小；而高效品种下部叶和低效品种叶片含量变化不大，可能是甘蓝型油菜进入生殖生长阶段后，高效品种将硼更多地分配到繁殖器官，而其叶片却承受了相对较大的缺硼胁迫。

The details of the research include: By studying the structure of the natural bamboo fiber, make the basic morphological structure and the degree of crystallization clear; By studying the mechanical property of the fiber, make the feature of mechanical property of the natural bamboo fiber clear; By studying the mechanical property of the pure yarn and its blends, make the feature of mechanical property of the yarn clear; and we also study the mechanical property changes of the pure yarn and its blends in the hygrometric state different temperature state and after mercerization and alkali shrinkage.

研究内容包括：通过对天然竹原纤维结构的研究，探明竹原纤维的基本形态特征和结晶度等特征；通过对天然竹原纤维机械性能的研究，探明竹原纤维的力学性能特点；通过对竹原纤维纯纺、混纺纱线力学性能研究，探明其纱线的力学性能特点；研究在湿态条件下，竹原纤维纯纺、混纺纱线力学性能的变化特点；研究在不同温度条件下，竹原纤维纯纺、混纺纱线力学性能的变化特点；研究在丝光、碱缩条件下，竹原纤维纯纺、混纺纱线力学性能的变化特点。

Having studied the relation of oil well paraffine precipitation and the rod load, the paper finds one new method to predict the oil paraffine precipitation ---statistics comparison of the indicator diagram, and calculates the paraffin removal cycle as well as the paraffin removal time And predicts the oil well paraffin precipitation; Combined with the test data of oil field and the basic production parameter of the oil well system, the paper has carried on close analysis of the efficiency of the single well system, and obtained each target reflecting the system operation; the efficiency of the oil pumping mechanical well system has been improved and the submersion pressure mathematical model has been completed, and the author draws up the dynamic control chart of sub-area system efficiency, thus raises the management level in the oil well system efficiency.

通过研究油井结蜡速度与抽油机悬点载荷的关系，将油井结蜡与示功图结合到一起，找到一种对油井结蜡预测的新方法——示功图统计对比法，计算出清蜡周期与清蜡时间，预防了油井蜡卡；以现场示功图为依据，结合生产参数对抽油机井系统效率进行实测分析，完善系统效率与沉没压力的数学模型并绘制油井系统效率动态控制图，对系统效率进行了检测评价与优化。

Then the author summarizes the framework for efficiency review in the western jurisdictions into the following four aspects: that is, how efficiency should be factored into the merger review; which types of efficiency should be counted; what is the cognizable efficiency and how to weight efficiency against anti-competitive effects.

在此基础上从效率在合并审查中的地位和作用、所认可的效率类型、效率的认可条件以及效率与反竞争性效果的权衡四个方面概括欧美主要国家对效率审查的基本框架。

The Series are the newly products with premium efficiency, The whole range motors efficiency are designed and manufactured according to America NEMA Premium Efficiency Standard, The efficiency is much higher tnan of NEMA Standard Epact high-efficiency motors.

NEP系列高效率三相异步电动机是全新设计的超高效率电动机，整个系列的效率是按美国NEMA超高效率标准进行设计的，整个系列的电动机效率高于NEMA标准的Epact高效电机的效率。

When Red mentioned product mix and from the State Committee for Standardization issued a "room air conditioners to limit the value of energy efficiency and energy efficiency rating," the draft, the Chinese air-conditioning energy efficiency standards from the current threshold of 5 energy efficiency ratio, to 2 energy efficiency ratio.

时红提到的产品结构调整，源于国家标准化委员会下发的《房间空气调节器能效限定值及能源效率等级》征求意见稿，中国空调能效标准门槛将从现行的5级能效比，提高至2级能效比。

First ,it carry on the demonstration analysis to the efficiency of Chinese stock market , judge present efficiency state , then use relevant analysis technology and T examine law in econometrics to analyze the relevant relationship between split share structure and the efficiency of Chinese stock market , and then ,put qualitative analysis on the reason of low efficiency of Chinese stock market and the uncertainty change of Chinese stock market after reform , to investigate the influence degree on the efficiency of Chinese stock market by split share structure .

第三章为股权分置改革对股票市场效率的影响分析，先对中国股票市场效率进行实证分析，判断中国股票市场目前的效率状况，然后运用计量经济学中的相关分析技术和T检验法，对股权分置制度与中国股票市场的效率进行了相关性分析，再从对中国股票市场低效率的成因、股权分置改革后中国股票市场不确定性变化的定性分析中，考察股权分置改革对中国股票市场效率的影响程度。

But overall, it is insufficient to exist flowingly: First, more application western relevant theory of economics is it state the fair and efficiency issue of China to come, introducing three western fair and efficiency view " efficiency comes first theory "," fair preferential theory " and " the fair and efficiency replace the theory " mainly, it is not enough to theoretical research about the fair and efficiency relation of Marxism; Second, the theory circle studies this question from standardizing the economics angle mainly, adopt and standardize the analytical method, the positive research is relatively insufficient.

但就总体而言，还存在以下不足：一是较多的运用西方经济学的有关理论来说明我国的公平与效率问题，主要引入西方的三种公平效率观&效率优先论&、&公平优先论&以及&公平效率交替论&，对马克思丰义关于公平与效率关系的理论研究不够；二是理论界主要从规范经济学角度研究这一问题，采用规范分析方法，实证研究相对不足。

The area is small to the highest ( conversion efficiency 13 - 15%, some have achieved more than 20%) of monocrystalline silicon solar energy cell conversion efficiency, and output power is big, and stability is good, grows ( generally can reach more than 20 years ) service life, but the raw and processed material cost height, the weak light specific property is wronger, and production technology is complicated, hence the selling price is also higher; The polycrystalline silicon solar energy cell is basic identical with the function characteristic of monocrystalline silicon solar energy cell; The conversion efficiency of non- brilliant silicon solar cell than hangs down ( simples about 6 - 8%), the area is than greatly, but because of his raw and processed material cost than hanging down, can be easy to big area industrialize production, what will have hope to be used the generally big area to generate electricity from now on most will be this kind of application that battery is along with manufacture technique and new material, in a single day the practical package photoelectricity conversion efficiency of its big area achieves more than the 10-15%, and the price of every tile electric power-generating equipment is fallen 1 - 2 U.S.dollar of time, and just is enough to that the solar energy cell efficiency that big area the getting extensive use will constantly replace in now convention certainly special use and the laboratory of sources of energy s will high get many.

单晶硅太阳能电池转换效率最高（转换效率13～15%，有的已达到20%以上），面积小，输出功率大，稳定性好，使用寿命长(一般可达20年以上)，但原材料成本较高，弱光特性较差，生产工艺复杂，故售价也较高；多晶硅太阳能电池与单晶硅太阳能电池的性能特点基本相同；非晶硅太阳能电池的转换效率较低（约6～8%左右），面积较大，但因其原材料成本较低，可便于大面积工业化生产，今后最有希望用于一般大面积发电的将是这种电池。随着制造技术和新材料的应用，一旦它的大面积实用组件光电转换效率达到10-15%以上，每瓦发电设备的价格降到1～2美元时，便足以大面积得到广泛应用并将不断取代现在常规能源。当然特殊用途和实验室中的太阳能电池效率要高得多。

I hope that this success is just the first in a long series.

我希望这只是成功的开始。

Three dimensional stresses on the interface of tire and soil, tire deflection and soil sinkage are measured.

测试轮胎——沙土界面上的三向应力、轮胎变形和沙土沉陷；建立考虑剪切应力对沙土承载特性产生影响的车轮牵引性能预测模型；分析车轮作用下土壤的纵向稳定性。