查询词典 load up

On the single row angular contact bearings, radial load rating of bearing rings relative to each other purely radial displacement of the load of the radial component.

对单列角接触轴承，径向额定负荷为引起轴承套圈彼此相对纯径向位移的负荷的径向分量。

To a module of single output, its load is rated load.

单路输出的变换器，其输出负载就是其额定负载。

In this case the 225/45R17 91W Standard Load size's rated load capacity of 1,477 lbs.

在这种情况下， 225/45R17 91W标准负荷大小的额定负载能力1477英镑。

When is tested,testing shall be performed with rated load current of firstly, and then with load current of inverter.

在测试时（仅限 Power 测试），的额定负载电流，后带的负载电流。

Traditionally,the vehicle overload is defined as the load that exceeds its rated load.

传统意义上车辆的超载是指车辆当前负荷高于该车型的额定载荷。

At the detecting point of the load signal,the rated three-phase load power is divided in section on real-time.

在负荷信号检测端，采取按三相负荷功率的额度进行实时分段的措施。

As the test shows, when the rated load is 25%, the air leakage volume will be about twice of 100% load.

因此在低负荷启动时，必须抽除更多的空气以保持凝汽器的最低压力。

Compared with the traditional shunt APFs, there is no need to sense load current, noneed to calculate the harmonic and reactive component of the load current, and noneed for multiplier.

与传统APF相比，采用单周控制方法的APF的突出优点是：不需要检测负载电流，不需分离出负载电流中的谐波和无功分量，因此省略了高精度乘法器，控制电路简单。

For the principal component, namely the voltage stability analysis function, three kinds of nodal injection power modes are defined, i.e., the random varying direction of load, the response setting direction of generator and the ratio of active power component to reactive power component in load power, and a continuous power flow model that is easy to utilize and comprehend by dispatching center is built, based on this model three kinds of formulae to calculate the sensitivities of loading margin with respect to three kinds of nodal injection power modes are derived respectively, and on this basis the influence of nodal injection power mode on loading margin can be analyzed in order that the voltage collapse can be avoided by fast implementing early warning of voltage stability and adopting effective corrective control.

文章针对N-EMS的主要组成部分--电压稳定分析功能，定义了3类节点注入功率模式：负荷的随机变化方向、发电机的响应设定方向、负荷的有功和无功比例，建立了易于被调度中心运用和理解的连续潮流模型，在此模型基础上分别推导得到负荷裕度对3类模式的灵敏度公式，据此分析节点注入功率模式对负荷裕度的影响，以便能够快速进行电压稳定预警和采取有效的校正控制来避免电压崩溃。

Based on the research production, with three prestressed concrete hollow slabs from the bridge in active service for ten years, this essay studies the ultimate bearing power ,the load-bearing failure mechanism and structure reenforcement measures influence on them, through examination of each performance index, failing load test, theoretical analysis and computing research work.

对预应力混凝土桥梁结构在使用中存在的问题及国内外相关研究发展水平进行了综述，指出目前对旧桥预应力混凝土空心板实际极限承载能力进行相关研究的必要性及其重大意义； 2、对旧桥预应力混凝土空心板的混凝土强度、碳化深度、预应力筋的锈蚀状况以及裂缝状况的检测评定； 3、通过破坏荷载试验，对损伤旧桥预应力混凝土空心板的受力性能进行试验评定； 4、采用在桥面做混凝土叠合层的加固措施，通过破坏荷载试验对加固后的旧桥预应力混凝土空心板的受力性能进行评定； 5、提出在役旧桥预应力混凝土空心板的维护、加固和使用建议。

Tom: You are right, he worked hard all the time.

你是对的。他一直都是努力工作。

Take shortcomings,failures,and mockings of others as commonplace and a drive to complete oneself,hold your own opinion over the evalution and disscution divested from others,afterwards sink into the state of eliminate mistakes if any or encourge oneself being not being influenced by the sayinngs of others or having no ideas to do.

把缺点、失败及别人的耻笑等看成是一种常事，当成完善自己的动力，对别人的评价和议论自己心中有主见，做到&有则改之，无则加勉&，不为人言所左右或无所适从。