查询词典 load up

Power load has been forecasted in 24 hours on the base of local linear prediction in the end and this method is a new way to power load forecast.

此方法是一种新的电力系统负荷预测方法，为以后的研究人员提供了新的思路。

This design first gives the system logical circuit and all load parameter according to the project description, the analysis load trend of development.

本次设计首先根据任务书上所给系统与线路及所有负荷的参数，分析负荷发展趋势。

First acts according to in the project description to give the system logical circuit and all load parameter, the analysis load trend of development.

首先根据任务书上所给系统与线路及所有负荷的参数，分析负荷发展趋势。

The paper studies UFLS with several times accelerating shedding load function, analyzes dynamic frequency characteristic of power system during UFLS, derives the formula which is served as setting rate of frequency change for criterion of accelerating shedding load, and designs the logical diagram expressing UFLS operation.

研究了同时依据频率和频率变化率两个变量，在每个频率定值处设置加速减载功能的低频减载方案。文中详细分析了低频减载过程中频率的动态特性，推导了作为加速减载判据的频率变化率整定值的计算公式。

The paper studies UFLS with severaltimes accelerating shedding load function, analyzes dynamic frequencycharacteristic of power system during UFLS, derivesthe formula which is served as setting rate of frequency change for criterionof accelerating shedding load, and designs the logical diagram expressing UFLSoperation.

研究了同时依据频率和频率变化率两个变量，在每个频率定值处设置加速减载功能的低频减载方案。文中详细分析了低频减载过程中频率的动态特性，推导了作为加速减载判据的频率变化率整定值的计算公式。

Next, the following points are emphasized:(1) The design of photoelectric conversion preamplifier circuit. In order to improve the measurement accuracy of luminometer and ensure linear relationship of the photoelectric, operational amplifiers is designed as current-voltage converter form, on the one hand, it is available to zero-load effect; on the other hand, short-circuit current can be transformed into a voltage volume through the feedback resistor, it is equivalent to voltage drop flowed through a load resistor on the actual effect.

其次，本文重点做了以下工作：(1)光电转换前置放大电路的设计：为了提高照度计的测量准确度，确保光电间的线性关系，本设计把运算放大器接成电流电压变换器的形式，一方面可得到零负载效应；另一方面，短路电流通过反馈电阻变成电压量，实际效果相当于流过一个负载电阻形成的压降。

The main dimensions are calculated by magnetic track, then the fields of load and without load are computed by 2-d FEM and references of the motor are obtained, so the structure of the motor can be adjusted.

用磁路设计法确定电机的主要尺寸，然后用二维有限元法计算电机的空载和负载磁场分布，得到电机的参数和性能，根据性能要求对电机结构尺寸调整。

2TheMax GPX750 PSU for the desktop computer features total output of 750W, rated supply voltage of 115V to 230V auto range, rated mains frequency of 47 to 63 Hz, rated input of 115V at 10A or 230V at 5A, efficiency of 85% minimum at typical load, holdup time of 16.6ms at nominal line under full load condition, power good signal between 100ms to 500ms, over current protection at 110% to 150% individual output power, over voltage protection for +5V is between 5.8V to 6.3V,+12V from 14V to 17V, 3.3V from 3.6V to 4.2V, air flow by DC fan, operating temperature of 0°C to 50°C and operating humidity of 20% to 90% non-condensing.

2themax gpx750电源为桌上型电脑的功能总产量750瓦特，额定电源电压115v到230v汽车范围，额定工频47至63赫兹，额定输入的115v在10 A条或230v在5 ，效率85 ％，最低在典型负载，持的时间16.6ms的名义在网上下，满负荷条件下，电源良好信号之间的100 ms到500ms ，过电流保护在110 ％至150 ％个别的输出功率，过电压保护，为5 V是之间的5.8 V至6.3v ，+12 V的从14v至17v ，电压为3.3 V从V到3.6 V至4.2 V ，空气流量由直流风扇，操作温度0° C到50 ° C和运作中的湿度为20 ％至90 ％，非冷凝。

Traditionally, autoloaders can only handle one duplication job at a time and additional manpower is needed to load a new duplication job ex. Load new master disc, insert more blank discs, etc.

传统的自动加载器一次仅能完成一个拷贝任务，然后需要人力加载新的拷贝任务（例如，加载新的主要光盘，插入更多的空白光盘等）。

Simulation result shows that, our peer-to-peer network architecture has less maximum load of single node and load mean square deviation of overall nodes than Chord.

仿真实验结果表明，单个节点的最大注册用户负载量和节点负载量均方差均小于Chord对等网络。

Tom: You are right, he worked hard all the time.

你是对的。他一直都是努力工作。

Take shortcomings,failures,and mockings of others as commonplace and a drive to complete oneself,hold your own opinion over the evalution and disscution divested from others,afterwards sink into the state of eliminate mistakes if any or encourge oneself being not being influenced by the sayinngs of others or having no ideas to do.

把缺点、失败及别人的耻笑等看成是一种常事，当成完善自己的动力，对别人的评价和议论自己心中有主见，做到&有则改之，无则加勉&，不为人言所左右或无所适从。