查询词典 load chart

From the experimental results, both in no-load and full-load cases, all the proposed slip estimation schemes exhibit good performances of speed tracking and robust load disturbances rejection.

由实验结果证明不管在无载或满载情况下，所提出四种不同无转速感测的系统都具有良好的转速追踪能力，并且对於负载的扰动系统都拥有很好的强健性能。

All mechanical loads are considered, including internal pressure, gravity, wind load and earthquake load, in which the modal analysis of the drum, functional wind load and temporal analysis for earthquake are the innovations of this paper.

分析焦炭塔在机械载荷，如内压、自重、风载和地震载荷作用下的应力情况，其中塔体的模态分析、风载的函数加载和地震载荷的时程分析是本文的创新。

It comprises: CN pages call and the page message carries the sonic service information, as the sonic service of CS region; UE responds page, and sends the sonic service information to RNC in the initial access request message; RNC receives request and makes sure it is sonic service of CS region, to decide one sonic speed parameter Rm, and based on the resource demand, to build one wireless chain and ground load between Iub interface signal and service, and the signal and service load of wireless interface; UE and CN processes QoS consultation, and CN sends the consulted Qos parameter to RNC, which comprises a sonic speed parameter Ra of this service; RNC compares parameter Ra and Rm, if Ra is higher then Rm, builds the ground load of Iu interface and sends distribution answer message to CN to continuously page answer process.

一种WCDMA系统被叫侧语音呼叫的快速建立方法，包括步骤：CN寻呼被叫，寻呼消息中携带语音业务信息，指明是CS域的语音业务；UE响应寻呼，在初始接入请求消息中将所述语音业务信息传递到RNC；RNC收到请求并获知是CS域的语音业务后，决策出一个语音速率参数Rm并基于其对资源的要求，建立Iub接口信令和业务的无线链路及地面承载，以及无线接口的信令和业务承载；UE和CN进行QoS协商，CN将协商得到的Qos参数指派给RNC，其中包括本次业务的语音速率参数Ra；RNC比较参数Ra和Rm，如果Ra≥Rm，则建立Iu接口的地面承载，向CN发送指派应答消息，继续呼叫应答过程。

Damage checking. To prove the load spectrum testing and research is correct, our load spectrum and AAR wagon load spectrum which 90.7 tons of high-sided wagon linear is transformed to 70 tons, the accumulated fatigue damage amount were compared under the same mileage.

损伤检验。为了证明本次载荷谱测试与研究的正确性，将实测和统计推断后的载荷谱，与AAR标准90.7吨高边敞车线性转化到70吨的载荷谱，在相同里程下疲劳累积损伤量，进行了比较。

On the basis of the roundly summing-up of the research on NSP inlands and overseas, the existed problems and developing trends are analyzed. The instructional meaning of estimating the annual load is higher than forecasting the load of sometime or some section. Aiming at the scarcity of data and the difficulties in building mechanism model, hydrological methods are used to calculate the annual load of NSP because the data needed in statistic methods is less. The NSP brought by livestock and poultry is also numbered and differentiated.

本文在对国内外非点源污染模型的研究进行较为全面的总结，分析存在的问题和发展趋势的基础上，针对非点源污染数据资料稀缺，机理模型难以建立而统计模型所需资料相对较易于获得，计算简便直观，并且在水环境规划管理中对年负荷量预测、估算的指导意义要大于对某一时点、某一断面的负荷量的模拟预测的情况，对非点源污染年负荷量估算时运用水文分析方法计算非点源污染年负荷量，并对畜禽养殖带来的非点源污染进行量化区分。

The time history curves of axial load and impact load were recorded,the effect of axial load on mid-span deflection was achieved.

试验中记录的撞击力时程曲线可分为迅速上升的冲击力加载、平稳的塑性动力响应和卸载三个阶段。

After carries on the load computation and the component section estimate, selected a pin frame to carry on the computation, the computation content including the frame beam column section size selection and the line rigidity computation; Dead load, live load, under earthquake function Liang Duan, column end moment, shearing force computation; Frame endogenic force combination; The frame beam column matches the muscle computation; The staircase matches the muscle computation and the foundation matches the muscle computation.

在进行荷载计算和构件截面估算后，选取了一榀框架进行计算，计算内容包括框架梁柱截面尺寸的选取及线刚度的计算；恒载、活载、地震作用下梁端、柱端弯矩、剪力的计算；框架内力组合；框架梁柱配筋计算；楼梯配筋计算及基础配筋计算。

The results show that in the applied load range of 10250 N, the mass loss rate of coated AZ91D alloy can be identified to three stages, which are related with whether the coating is worn out. Abrasion is the main mechanism for the coated alloy. The friction coefficient of the coated alloy during sliding wear appears oscillation before it reaches a constant value, which is close to the μ value of the matrix alloy. The mass loss rate of coated alloy increases slightly with increasing applied load when the applied load is more than 150 N because of high plastic deformation accommodation on the matrix alloy surface.

结果表明：根据载荷大小，涂层处理后AZ91D镁合金的磨损行为明显分为3个阶段，这些阶段同陶瓷层是否磨穿密切相关；微弧氧化涂层AZ91D镁合金的磨损机理主要是磨粒磨损；受表面状况的影响，陶瓷涂层的摩擦因数在 0.20~0.45 间波动；在较高载荷下，涂层被磨穿后，涂层的摩擦因数趋于基体合金的摩擦因数，涂层合金的表面变形能力提高，该阶段质量磨损速率随载荷增加，趋势变得缓慢。

Five suitable load models for the Taipower system are adopted here in order to discuss the effect of the load characteristics on the setting of the overcurrent relay at the time of the incident, as a basis for setting the system coordination:(1) Static ZIP model;(2) Dynamic Motor model;(3) Composite load model;(4) PTI IEEE model;(5) Exponential model.

采用五种适於台电系统之负载模型：(1)静态ZIP模型、(2)动态Motor模型、(3)复合模型、(4)PTI IEEE模型、(5)指数模型，探讨当发生事故时负载特性对过电流电驿设定之影响，以作为系统保护协调设定之依据。

ABSTRACT: In order to analyze effect of summer weather factor on the peak load, adopting comfort index to analyze peak load is brought forward based on summarizing limitation of normal load characteristic analysis.

为更好地分析夏季气象因素对日峰荷的影响，在总结常规负荷特性分析缺陷的基础上，提出用人体舒适度作为综合气象指标来反映其对日峰荷的影响。

Foods high in this vitamin include oily fish such as salmon, tuna and, and fish liver oils.

维生素D含量高的食物包括诸如大麻哈鱼、金枪鱼和鲭鱼之类的油鱼以及鱼肝油。

We need you to cosign our public letter demanding that press intimidation cease immediately, and that all charges be dropped.

我们需要您cosign我们的公共信，要求记者立即停止恐吓，并要求所有收费下降。