查询词典 lift pump

The test bedstand which is composed of electro-motor ,hydraulic pump ,hydraulic motor ,speed verily box and parallel compensating pump, can resolve the problem of power consumption and the power warm while large power hydraulic pump and motor testing.the principle of system is that electro-motor drive the hydraulic pump first,then the pump make the hydraulic motor work through its high pression oil,the follow working hydraulic motor feedback the power in niuju re-drive the hydraulic pump,at last the power is recovered.this bedstand make use of bishi hydraulic system ,which can have a closely construct ,and steadly chuandong ,lower noise ,high power recovery percentage and so on.

本实验台由电动机、油泵、油马达和变速箱以及并联补油泵等一起构成功率反馈实验油路，以解决大功率液压泵及马达在试验时的大功率消耗和能量耗散时的发暖问题。实验台由电动机带动油泵，油泵输出油液驱动液压马达，油马达输出的扭矩通过变速箱传动来回馈给液压泵的输渗入渗出轴，从而实现功率往返收。采用闭式液压系统，结构紧凑、运行平稳、噪声低、功率回收率高；机械补偿，电动机输渗入渗出扭矩经变速箱传动驱动液压泵；液压补偿，并联补油泵对系统的高压油路入行流量补偿。

To certain viscosity experimental medium, the discharge coefficient of the great pitch pump is higher than the conventional pump, along with the obliquity of the pump barrel is increase(that is from the level to the vertical lay),the discharge coefficient of the well pump is increase, looked from the test result, the discharge coefficient of the great pitch pump is higher than the conventional pump, on this condition that low frequency of stroke, and it is more obvious on the small oblique angle condition.

对一定粘度的试验介质，大斜度抽油泵的流量系数高于常规抽油泵，随泵筒倾角的增加(即从水平放置到垂直放置)，抽油泵流量系数增大，从试验结果看，低冲次条件下，大斜度抽油泵流量系数高于常规泵，且小倾斜角状态较明显。

The hydraulic loss of conduit in both vertical pump system and bulb tubular pump system were calculated using the numerical simulation, and the influence of pump impeller diameter on hydraulic loss of conduit was analyzed. Based on the similitude rules of impeller pump, the relationship between pump impeller diameter and nD value and the influence of pump selection and design were analyzed.

采用数值计算的方法，分别计算了具有不同水泵叶轮直径的立式轴流泵装置和灯泡贯流泵装置的流道水力损失，比较了水泵叶轮直径对流道水力损失的影响；根据叶片泵的相似律，分析了在一定设计流量条件下水泵叶轮直径与nD值的关系以及对水泵选型设计的影响。

Series is a kind of mechani-cal seal component with centripetal. inbuilt, single face. multi-spring and non-equil-ibrium structrure and conforms to ISO 3069 and JB1472-75. It applies to all kinds of centri-fugal pump,chemical pump,inline pump,pipe pressure pump,dredge pump and multi-stage feed pump.

本型号机械密封件是一种内流内装，单端面，多弹簧非平衡型结构，符合ISO-3069，JB1472-75标准，应用于各种离心泵，化工泵，管道泵及管道增压泵，排污泵，多级给水泵。

We hope you pay more attention to jobs are as follows haven't been finished this week:(1) right and left side of upper water wall has been aligned and fixed;(2) Nine downcomers been pre-stored;(3) All the wall packing aligned and fixed, then install right and left side rigid beam;(4) Finishing welding counterpart of front wall packing;(5) Get two booster pump for turbine driven boiler feed water pump aligned and make inspection;(6) Electric Feed Water Pump Unit, Coupling and Motor Pump positioned;(7) Equipment in Start-up Boiler House aligned and make inspection;(8) Get three Reusing Water Pump aligned;(9) Equipment in Integrated Water Pump House aligned and make inspection.

本周，以下工作未完成，希望贵单位引起重视：（1）上水左右侧找正完，且加固完；（2）下降管9根预存完；（3）包墙全部找正完，加固完，之后安装左右侧刚性梁；（4）前包墙对口焊接完毕；（5）2台汽动前置泵找平找正，并验收；（6）电动给水泵组，耦合器和电泵就位；（7）启动锅炉房内设备找平找正，并验收；（8）3台复用水泵就位；（9）综合水泵房内设备找平找正，并验收。

For the upper and lower physical decomposition of the fuel pump, pump body can be placed, open side cover, remove the pump head fastening nut, remove the pump head, hand clamp plunger living roots, slowly out the plunger and spring cylinder fault, with clean petrol or diesel repeated washing, wash, after-loading complex (note the plunger into the regulation of regulation must fork arm), and alternately tighten pump head nut, rotating camshaft, oil pump pulled the handle to manipulate the review.

2对于上、下体能分解的喷油泵，可将水泵体平放，打开侧面盖板，卸下泵头紧固螺母，取下泵头，用手钳夹住柱塞根部，慢慢抽出故障缸柱塞和弹簧，用清洁的汽油或柴油反复清洗，洗净后装复(注意柱塞调节臂必须装入调节叉内)，并交替拧紧泵头螺母，转动凸轮轴，扳动油泵操纵手柄复查。

Enterprise specializing in pumps, valves, pipes, pipe fittings, corrosion-resistant equipment, mechanical equipment, steel-lined plastic·úmaterials and various types of product development, design, production and sales of main products have fluoroplastics pump, steel-lined PTFE pump , liquid pumps, self-priming pump, magnetic pump, centrifugal pump, stainless steel pump, fluorine plastic lined plug valves, butterfly valve, ball valve, valve, check valve, valve, gate valve, pipe fittings and steel equipment ten Level of stress, some more than 1120 kinds of model specifications.

企业专门从事水泵、阀门、管道、管件、防腐设备、机械设备、钢衬氟塑料及全塑各类产品的研发、设计、生产和销售，主要产品有氟塑料泵、钢衬四氟泵、液下泵、自吸泵、磁力泵、离心泵、不锈钢泵，氟塑料衬里旋塞阀、蝶阀、球阀、截止阀、止回阀、隔膜阀、闸阀、管道件及钢塑设备十个压力等级，约1120多种型号、规格。

Its major products include electric lift emergency devices, elevator manostat , alternating and direct voltage-stabilized source , switching power supply ,lift emergency lamps, lift walkie-talkie, lift acoustic floor reporter and lift door frequency converters.

西奥电气位于经济发达的长江三角洲——启东经济开发区南苑工业园，主要产品有：电梯应急装置、电梯稳压器、交直流稳压电源、开关电源、电梯应急灯、电梯对讲机、电梯语音报站器和电梯门机变频器。

In case maintenance workers are not informed of the incident, the stranded person will have to stayin the lift over night or a few hours. In order to ensure the safety of lift users, our technicians, after over 10 years of persistent efforts for improvement and perfection, have put forward a new device for lift emergency cases. This device, with an intelligent trouble tracing system to trace lift troubles and electricity failure, is able to automatically perform rescue work and ensures lift users's afety by performing timely rescure.

另外，如果电梯维保人员收不到困梯的信息，乘客被困在电梯里一个晚上、几个小时是可想而知的事，为了保障电梯乘客的人身安全，我厂科技人员经过十余年不懈努力，不断改进和完善，推出了新一代电梯应急装置，采用了电梯故障智能跟踪系统，随机检测电梯故障及电网故障，进行智能化的自动救援工作，确保电梯的被困乘客能得到安全、及时的自动救援。

In ideal conditions, a pump, the second pump and the lift of a pump system pumps the same lift.

在理想工况下，一次泵、二次泵的扬程之和与一次泵系统水泵扬程相等。

After oxidation, pH value of the surface of carbon black has a specific relation with the volatile content.

氧化后炭黑表面的pH值与挥发分之间有一定的关系。

Knowing that such a person is warped and sinful; he is self-condemned.

因为知道这等人已经背道，犯了罪，自己明知不是，还是去做。