查询词典 hexagonal prism

The results indicate that only tungsten oxide grains are formed without sodium sulfate additions, while tungsten oxide whiskers with 0.20.3 μm in diameter and aspect ratio of 5-50 or tungsten oxide nanowires with 1030 nm in diameter and aspect ratio of 50200 are synthesized by some sodium sulfate additions on conditions at 180 ℃ for 1236 h. The phase composition of tungsten oxide whiskers is hexagonal tungsten trioxide. The whiskers/nanowires grow oriently through 〈200〉,〈002〉,〈202〉and〈100〉.

结果表明：未添加硫酸钠时，在180 ℃水热反应12~36 h只能得到氧化钨颗粒粉末，而添加适量硫化钠后，可制备出直径为0.2~0.3 μm、长径比为5~50的氧化钨晶须和直径为10~30 nm、长径比为50~200的氧化钨纳米线；氧化钨纳米线晶体结构良好，物相为六方晶系WO3；微/纳米氧化钨晶须/线主要沿〈200〉，〈002〉，〈202〉和〈100〉方向定向生长。

XRD showed hexagonal wurtzite structure. Room-temperature PL spectra of perfectly overcoated CdSe/ZnS only showed a narrow band edge emission. Emission peak was great red-shifted relative to absorption and the shift increases as the size decreases. The size-dependence of shift could be explained very well in terms of excition fine-structure model and stress at interface owing to lattice mismatch contributes to the shift between CdSe and CdSe/ZnS with the same size.

结果显示表面修饰完善的样品的荧光光谱只有一个窄而强的带边发射；所有样品的荧光峰相对于1S-1S吸收峰有较大的红移，并且移动量随尺寸的减小而增加，利用激子的精细结构模型很好地解释了红移量和尺寸的关系；核／壳结构的样品的吸收峰和荧光峰相对于同尺寸的单量子点也有红移现象，这是由于CdSe和ZnS的晶格失配在界面上产生压力造成的。

Then on the base of photoisomerization of azobenzene molecules,we get thelong-rang order hexagonal symmetry and rectangular symmetry microstructures in theazobenzene polymer film(2μm),induced by optical lattices.

在此基础上，根据偶氮分子的光致几何异构的特性，在偶氮苯有机聚合物薄膜(2μm)中得到了长程有序的六角对称微结构和矩形微结构。

And the primary products are high quality round steel, strip steel, screw steel, high speed line material , galvanized iron wire, black annealed wire, draw wire, flat wire, precut iron wire, welding wire mesh, hexagonal wire mesh, welding wires for gas shielding arc welding, welding electrode, common nails, roofing nails, concrete nails, coil nails, staples, u nails, T nails, blots and nuts, galvanized barbed wire, steel strip, barchair ,etc.

目前，公司主要生产金属制品母材和各种金属制品，主要产品优质圆钢、带钢、螺纹钢、高速线材、镀锌铁丝、软质黑铁丝、冷拔产品丝、扁丝、切断丝、电焊网、六角网、CO2气保焊丝、电焊条、普通元钉、瓦楞钉、水泥钉、卷钉、订书钉、 U型钉、枪钉、螺栓、螺母、刺绳、打包铁皮、铁架子等300多个品种规格，其中，元立牌镀锌铁丝荣获&浙江名牌产品&和&浙江省著名商标&称号，钢钉系列产品荣获&国家免检产品&称号。

Recently, Shelnutt and co-workers obtained discrete porphyrin nanosheets reprecipitated from their solutions;[3] Sathish and co-workers constructed hexagonal C60 nanosheets using a liquid–liquid interfacial precipitation method;[4] the groups of Yao[5] and Hu[6] prepared singlecrystalline nanosheets of polycyclic aromatics using a surfactant- assisted reprecipitation and a physical vapor transporting method, respectively; and Zhang and co-workers suggested that molecules with intramolecular charge-transfer dipole moments could be grown into quasi-2D nanostructures.

近年来，Shelnutt及其同事由他们的溶液再沉淀获得了离散的卟啉纳米片[3]； Sathish和他的同事用液－液界面沉淀法构建了六边形的C60纳米片[4]； Yao[5]和Hu[6]分别用表面活性剂辅助的再沉淀和物理气相输运法制备了多环芳烃的单晶纳米片；而Zhang和他的同事提出，具有分子内电荷转移偶极矩的分子可以生长成准二维的纳米结构[7]。

Recently, Shelnutt and co-workers obtained discrete porphyrin nanosheets reprecipitated from their solutions;[3] Sathish and co-workers constructed hexagonal C60 nanosheets using a liquid–liquid interfacial precipitation method;[4] the groups of Yao[5] and Hu[6] prepared singlecrystalline nanosheets of polycyclic aromatics using a surfactant- assisted reprecipitation and a physical vapor transporting method, respectively; and Zhang and co-workers suggested that molecules with intramolecular charge-transfer dipole moments could be grown into quasi-2D nanostructures.

最近，舍纳特和同事获得离散卟啉薄片reprecipitated其解决方案； [3] Sathish和同事构建六角 C60的薄片采用液液界面沉淀方法； [4]姚明集团[5]和胡[6]准备singlecrystalline 多环芳香烃薄片的使用表面活性剂再沉淀和辅助物理气相传输法分别，张和同事建议随着分子内电荷转移分子偶极时刻可以发展成为准二维纳米结构。

A series of copper halides in one, two, or three dimensions have been successfully synthesized such as rhomboid dimers of stoichiometry [Cu2X2L2]n, the tetranuclear species on cubane or stepped cubane tetramers of stoichiometry [Cu4X4L4]n and hexagonal[Cu6X6] grid chains.2 The main strategy in crystal engineering is a secondary building block approach.3 For a given building block, there are two routes to construct frameworks.

在一维、二维或三维的一系列卤化铜已经成功地得到了合成，比如化学计量法[Cu2X2L2]n的长菱形二聚物、化学计量法[Cu4X4L4]n和六边形[Cu6X6]网格链的在立方烷上的四核类或阶梯式立方烷四聚物。[2] 在晶体工程上的主要策略是一种次级构件途径。[3] 对于一给定的构件来说，有两条构件骨架的路线。

BR is embedded in the purple membrane and organized in trimeric unit arranged in a hexagonal twodimensional crystalline lattice, there are about 30 lipid molecules surrounding a BR trimer.

BR分子在紫膜中以三聚体的形式存在，并形成二维的六角型晶格，每个三聚体周围约有30个脂质分子。

Using trimeric surfactant C_(14-2-14-2-14) as templating agent, the low cost and facile inorganic species sodium aluminate and sodium silicate as inorganic precursors, highly ordered 2D hexagonal aluminosilicate MCM-41 with high Al content were successfully synthesized.

利用廉价易得的硅酸钠和偏铝酸钠作为无机前驱体，以低聚季铵盐表面活性剂C_(14-2-14-2-14)为模板剂合成了高铝含量，高有序性的二维六方结构介孔硅铝酸盐材料，并对材料的结构、表面性质、形貌以及酸性进行了研究。

Equiaxed and bigger grains are produced after C.P.Ti is deformed under the high temperature. Besides, many tiny subgrains were found in some of the metallurgical structure. The dislocation reaction caused by the deformation under the high strain rate generates ductile cellular metastructures, while the equiaxed cellular metastructures are generated under the low strain rate. The metallurgical structure of TC4 alloy including lath-shaped hexagonal martensite and trimetric martensite only exists in the higher temperature. The homogeneous, tiny and reticular grain shown after extreme high temperature deformation.

在高应变速率下变形引起的位错反应形成拉长的胞状亚结构，而低应变速率下变形则形成等轴的胞状亚结构；TC4合金在特高温变形条件下其金相组织呈网篮状，显微组织几乎全部为均匀细小的晶粒，同时出现了板条状六方马氏体；在温度尤其高的情况下还形成了斜方马氏体，变形引起的位错反应形成六方位错网络，在1200℃以下的变形易产生孪晶。

I hope that this success is just the first in a long series.

我希望这只是成功的开始。

Three dimensional stresses on the interface of tire and soil, tire deflection and soil sinkage are measured.

测试轮胎——沙土界面上的三向应力、轮胎变形和沙土沉陷；建立考虑剪切应力对沙土承载特性产生影响的车轮牵引性能预测模型；分析车轮作用下土壤的纵向稳定性。