查询词典 gap between ... prices

Tests were carried out using ±1 000 kV simulation tower in this paper, and switching impulse and lightning impulse flashover characteristic curves of typical air gap in ±1 000 kV transmission tower were obtained. These curves were compared with test results of ±500 and ±800 kV air gap, and the flashover characteristic of 750 kV AC transmission tower and square tower window were also discussed in this paper.

利用±1 000 kV模拟塔头进行试验，得到了±1 000 kV杆塔典型空气间隙的操作冲击和雷电冲击放电特性曲线，并与±500和±800 kV杆塔塔头的空气间隙研究成果进行对比分析，同时结合750 kV 交流杆塔塔头和正方形塔窗的操作冲击特性进行了讨论和分析。

This paper presents conductive polymer molecular materials with insulating powder, mixed into the deployment of surge suppressors for low capacitance of paste, while the component design concept is based on the field of passive components, manufacturing process to make the basic theory to design the protective components, the main use of the existing ceramic substrate for the component body structure design, screen design in the body through the structure of the gap at the top of the printing layer of a different conductors, and then to learning to know the printing process technologies approach the low capacitance of the surge suppressor paste cover the gap in the two conductors, and by the resistance of plastic burning process technology, the temperature of sintering parts made of electrostatic protection element, and this protection through the external ESD components in bombardment tests, measurement of capacitance electrostatic discharge after bombardment, Trigger voltage and leakage current data, and the volume measured by the results of future discussion of the layout of this different style of work in the same area, different clearance, solid content and temperature than the next, for the attainment of performance components, a low capacitance ESD protection devices with low breakdown voltage requirements and to chip-based protection devices can be designed to integrate with the advanced Integrated Circuits or used independent of the electrostatic protection element in the system.

本文提出高分子导电分子材料搭配绝缘粉末，调配混合成适用於低电容突波抑制器之PASTE，而元件设计概念是以被动元件制程领域作基础理论去设计此防护元件，主体利用现有陶瓷基板为元件本体结构设计，在经由网版设计在本体结构上方印刷一层不同的间隙导体，再以习知印刷制程技术方式，将低电容突波抑制器之PASTE覆盖在两导体的间隙内，并经由电阻制程习知塑烧技术，将元件烧结适当温度制成静电防护元件；而此防护元件在经外加静电放电轰击测试后，量测静电放电轰击后的电容、Trigger voltage及漏电流相关数据，并藉由测结果讨此同的布局样式，在相同工作区面积、不同间隙、固含量与温度比下，对於元件效能是否达到静电防护元件低电容与低崩溃电压的需求，并藉此晶片型防护元件可设计整合於先进积体电或应用於独系统的静电防护元件中。

If there is no excessive wear or the time gap, they should check: First, the steering gear worm gear wear, or the required space, such as the gap is too large to be adjusted; Second, the shift device connected part of the wear and tear, or whether or not to adjust too loose; Third, the steering is loose parts installed; Fourth, there are loose steering arm down.

如无过大磨损或间隙时，则应检查：第一，转向器蜗轮蜗杆磨损情况，或间隙是否符合规定，如间隙过大应调整；第二，转向装置连接部分的磨损情况，或是否调整得过松；第三，转向器安装部位是否松动；第四，转向垂臂有松动。

The thermal boundary condition of the cast iron cooling stave with surface alloyed steel pipe was used for numerical simulation of temperature field and commercial software ANSYS and the method of coupling heat-structure were used to calculate thermal deformation of steel pipe at high temperature,and analyze the influence of air gap and thermal deformation on the life of cooling stave.The optimal size of air gap and hot load to guarantee long life of cast iron cooling stave were obtained.

根据合金化管铸铁冷却壁热态试验数据确定了合金化管铸铁冷却壁温度场数值模拟的边界条件，利用ANSYS软件、采用热-结构耦合的方法计算了高温状态下合金化管铸铁冷却壁内钢质冷却水管的变形，分析了气隙层和水管热变形对合金化管铸铁冷却壁寿命的影响，得出保证合金化管铸铁冷却壁长寿的最佳气隙层厚度和相应的最佳使用热负荷。

Under the conditions of keeping other design parameters constant, design thickness of valve flap increases with the mass increment on single wheel spring of the vehicle; throttle gap of oil-air spring is in linear decrement relationship with mass on single wheel spring. For each mass increment of 100kg on tested single wheel spring, design thickness of throttle valve flap will increase by 0.007mm and the throttle gap will decrease by 0.001mm.

在其它设计参数保持不变的情况下，阀片设计厚度随车辆单轮簧上质量的增加而增加；油气弹簧节流缝隙与单轮簧上质量成线性递减关系；试验的单轮簧上质量每增加100kg则节流阀片设计厚度将增加0.007mm，节流缝隙将减小0.001mm。

For each nut, and screw all gap exists, but in General, there is no gap and screw.

差每个螺母来说与丝杠都有间隙活命，但是从个体来说与丝杠操纵间隙。

Furthermore, by the vertical difference model, the fifth chapter analyzes the influence of some technology features on the laggard country social welfare in the market with network externality and scale economics, such as technology quality gap, scale economics gap, the charge rate of international high-technology transfer, etc, so as to provide some suggestions on technology introduction.

第五章利用纵向差异化竞争模型，研究了在具有网络外部性特征和规模经济性特征的质量标准竞争型市场中，技术质量差距、生产规模经济性差距、国际高技术企业技术转移收费比例等技术特性对技术后进国社会福利的影响，为我国质量标准竞争型高技术产业技术引进策略提出建议。

The free-time gender gap mainly reflects the gap in employed women's free time, an average 32.8 hours a week, compared with employed men's free time, an average 38.9 hours a week.

空闲时间的性别差距主要反映在女性雇员和男性雇员休闲时间方面的差异，女性为平均每周32.8小时，而男性为38.9小时。

The properties are the dispersion equation of IREBs drifting in the tube, and the transmission line model of IREBs interacting with the gap electrical field of input cavity of RKA and bunching in the drift tube. The expression of modulated current after the gap of input cavity is got, which is content with the experimental results.

建立了IREBs在漂移管中传输的色散方程，以及IREBs与RKA输入腔间隙电场相互作用和IREBs在漂移管中群聚传输的传输线模型，获得了电子束经过输入腔间隙后产生的调制电流表达式。

To narrow the gap between the data of receiving rale and the actual data, it is necessary to explore the rural potential market and settle the relationship between the audience in the unexplored regions and the programs in the well-established regions and solve the conflicts between the changeable audience and the lack of suitable programs.

要缩小收视率理论数据与实际数据之间的差额，本文认为很有必要挖掘农村潜在收视市场，处理好没地域的受众与有地域的节目之间的关系，解决易变的观众与缺乏对路的节目之间的矛盾。

Chimborazo and Cotopaxi, took me by the hand.

越过琴博腊索山和科托帕克西山。

This car is in a good condition.

这辆车的状况很好。