查询词典 fractional error

You can't choose a fractional number, deal fractional damage, gain fractional life, and so on.

你不能选择分数，造成有小数点的伤害，或获得小数点的生命等等。

Two special cases are discussed: flow due to a constant pressure gradient and flow due to a periodic one; In chapter 4, on the basis of the method of fractional element proposed by Schiessel et al and of the generalized fractional element networks proposed by Xu and Tan and by the use of discretization method for solving the inverse Laplace transform, we obtain the creep compliance of Zener and Poynting-Thomson models which are composed of the generalized fractional element networks.

并讨论了如下两种特殊情形：常压力梯度下的流动和周期性压力梯度下的流动；第四章在Schiessel等提出的分数阶单元法和徐明瑜等提出的广义分数阶单元网络的基础上，应用离散求逆Laplace变换的方法，给出并讨论了广义分数阶单元网络Zener和Poynting-Thomson模型的蠕变柔量。

The results demonstrated that the fractional conversion and reaction rate were rapidly increased in the initial curing reaction. The higher the curing temperature, the higher the fractional conversion and reaction rate was. With increasing of the curing temperature and time, the fractional conversion and reaction rate decreased and became constantly. The initial curing reaction was a first order reaction. The apparent activation energy and frequency factor of curing reaction used G- capryl ester was bigger than that of used G-oligomer.

结果表明：固化体系在研究的固化温度下，转化率和反应速率在固化反应初期增加快速，温度越高增加越快，随着固化时间的延长，这种变化逐渐变慢，并最终趋于恒定；初期固化反应为一级反应，反应初期的表观活化能和指前因子大小顺序为G-预聚体＞G-辛酯。

Based on this, aim at the disadvantage on Wigner Distribution and Fractional Fourier Transform that can't restrain noise interference effectively when be used to detect Linear Frequency Modulated signals interfered by heavy noises, we proposed a improved WD. Simulation results show that this method can restrain noise interference effectively and improve the ability of LFM signals detection. On the other hand, in multi-component cases, WD suffers from the cross-terms, which may impair some of the auto-terms. In order to separate original multi-component signals into components and reconstruct them separately, we can use the method of optimal filtering in fractional Fourier domain. But this method also has a problem that if signals have aliasing in the fractional Fourier optimal domain as well, the reconstructed signals will be distorted. In this thesis, a novel method of quasi Fourier transform is proposed in order to solve the problem of multi-component signal reconstruction, and have good results.

在此基础上，针对Wigner分布和分数维傅里叶变换在处理高噪声背景下线性调频信号检测的问题时存在不能有效抑制噪声干扰的缺点，提出了改进Wigner分布的办法，该方法能够抑制噪声，提高信号的检测能力；针对Wigner分布在处理多分量非线性调频信号时存在干扰项的缺点，以及分数域最优滤波方法在处理多分量非线性调频信号分离重构问题时存在的局限性，该局限性表现为在对最优分数域上也有信号分量重叠的情况进行处理时重构信号发生畸变，提出了新颖的类傅里叶变换的方法，该方法对在最优分数域上也有信号分量重叠的情况也能处理，得到的重构信号失真很小。

Based on the theory of fractional Fourier transform and one of its very important parameter, fractional order, the relationship between FRT and Fresnel diffraction are deduced and analyzed. The fractional Fourier transform hologram reconstructed with the Lohmann Ⅰ FRT system is presented and its computer simulation and digital reconstruction are realized. It is shown that FRT is an ideal tool to describe Fresnel diffraction,and the FRTH can record information on the object and the system at the same time,which extends the application areas of FRT and holography.

基于分数傅里叶变换理论并以分数阶这一重要参量为纽带，推导和分析了分数傅里叶变换与菲涅耳衍射之间的关系；提出了基于罗曼I型分数傅里叶变换系统的分数傅里叶变换全息图，并实现了其计算机生成及数字重现；研究表明，分数傅里叶变换是描述菲涅耳衍射的理想工具，分数傅里叶变换全息图可以同时记录物体和系统的信息，开拓了分数傅里叶变换和全息术的应用领域。

The common method, that all strong-correlation terms of the model are eliminated, can bring the loss in the engineering application, so the new method is proposed that the identified model reserves some correlation. The augmented matrix A is constructed by the outputΔW and the matrix S. The"determinating order based on ratio of determinant"is brought out to screen the strong-correlation terms in the structure identification. The latent root estimation is improved in screening the eigenvalues and eigenvectors. Thus the estimation precision is improved greatly.The consistence check of guidance instrument error coefficients of flight test and ground test is the purpose of flight experiment. The causes of inconsistency of the two models are analyzed. The hypothesis test of linear regression model based on F statistics is proposed to check the consistence.Finally, the instability of error coefficients is probably caused by the change of the flight environments, therefore, the relation between the error coefficients and flight environment is analyzed. The approach is presented to identify SINS guidance instrument error models and compensate the error in the segmented sections corresponding to the change of vertical acceleration of aircraft.

在结构辨识中，常用的方法由于将模型中的强相关项全部剔除而给工程应用带来损失，因此，本文提出了新的有益思想，即在保留一定相关性的基础上进行辨识：将输出向量ΔW与环境函数矩阵S构成增广矩阵A，然后采用"比定阶行列式"来剔除相关向量的方法，这样既可以尽可能多地保留了对落点影响大的强相关参数，又可以对落点影响小的强相关参数给予剔除；在参数估计中，改进了特征根估计中特征根和特征向量的筛选方法，提出"近零"准则，从而大大提高了参数估计的精度；再者，鉴于天地模型"一致性"检验是飞行试验和SINS制导工具误差系数分离的主要目的，因此，本文又深入分析了造成天地模型不一致的原因，提出了采用基于F统计的线性回归模型假设检验方法来进行捷联制导工具误差模型的天地"一致性"检验；最后，鉴于飞行环境剧烈变化可能会对惯性仪表误差系数稳定性带来一定的影响，因此本文深入地分析了SINS制导工具误差系数与外界环境的关系，提出了基于过载变化大小的分段辨识和分段实时补偿的算法。

The details as follow: 1.Based on rules about form error in GB, mathematical models of form error are established including straightness error on the base of minimizing zone method、least-squares method and two dots linked method ; flatness error based on minimizing zone method、lease-squares method、diagonal line and three dots method; circularity and cylindricity error based on minimizing zone method、lease-squares method、minimum circumscribed circle and maximum inscribed circle.

具体内容如下：根据国标中形状误差的相关规定建立了各种要素评定方法的数学模型包括：直线度的最小区域法、最小二乘法、两端点连线法；平面度的最小二乘法、最小区域法、对角线法、三远点法；圆度和圆柱度的最小区域法、最小二乘法、最小外接圆法、最大内切圆法。

The adaptive program is calculated by T-B stress recovery scheme and z-z error estimation, the error is estimated by energy norm of difference of recovery stress and meshless stress. If the local relative error exceeds the limit relative error, then new nodes will be generated at the high error area.

本研究的自适应方法采用TB应力平滑技术和Z-Z误差估计，利用平滑应力和无网格法所得应力解差值的能量范数来估算误差，如果局部相对误差超过了允许误差，则在高误差域插入新的离散点进行加密。

Besides, we have studied deeply error of two kinds which appeared frequently in the hypothesis testing (error of the first kind and error of the second kind), including the relations to error of two kinds and its effect to the result of hypothesis testing and the effective control of error of two kinds so as to be satisfying and etc.

另外，对假设检验中经常出现的两类错误（第一类错误和第二类错误）也作了深入的探讨，其中涉及到了两类错误之间的关系，两类错误对假设检验结果的影响以及如何有效的控制两类错误使之达到令人满意的程度等。

In this paper the effects of scanning truncation error, scanning position error, random amplitude and phase error, and multiple-reflection error in near-field antenna measurement are analyzed; error equations and the uncertainty of measurement are obtained through computer simulation; compensated techniques for reducing the effects of measurement errors in near-field antenna measurement are presented and the formula and arithmetic of phaseless near-field techniques are derived.

本文从解析法和数值仿真两个角度深入分析口面天线近场测量中扫描面截断误差、扫描面位置误差、随机幅相误差、多次反射误差等误差源对天线远场特性测量精度的影响，一方面从理论上给出相应的误差方程，另一方面建立误差分析模型，通过计算机模拟，得到不同误差条件下测量结果的不确定度，并介绍了减小这些误差的修正方法，推导无相位近场测量的公式和算法。

In the chapter 2, the theoretic knowledge about the photosensitive resin and the grinding tools was firstly introduced.

第二章阐述了光固化树脂结合剂磨具的相关理论研究。

Do not use the program's indenting or margin-setting features; these will be added during typesetting.

不要使用缩排，页面边缘设置之类的选项，偶看不大懂。