查询词典 filler wall

In the dissertation, a new stabilization method, equal-density method was adopted to prepare modified asphalts with storage stability at high temperature. In this method, a compound was prepared by premixing polymer and filler, and the compound was mixed with asphalt to prepare Polymer-Modified Asphalt by changing the ratio of polymer and filler. The asphalts with good storage stability were formed with the addition of filler, by regulating the density difference between polymer and asphalt. With identifying the effect of composition factor and the technique conditions on mechanical properties of polymer/filler compound and the molecular distribution of the polymer, identifying the effect of composition factor and the technique conditions on the properties and structure of polymer/filler modified asphalt, Styrene-Butadiene-Styrene copolymer, Low Density PolyEthylene, Styrene-Ethylene-Butadiene-Styrene block copolymer modified asphalts with good storage stability and performance were prepared. Rheological method, gel content analysis and swelling measurement were adopted to elucidate the interaction between the polymer and filler. Filler reduced the difference between the polymer and asphalt with the premixing technique, which led to the improvement of the storage stability of the modified asphalts. The thermo-oxidative aging process of base asphalt and PMA were studied and the effect of antioxidant additives on the base asphalt and PMA were analyzed.

本论文采用等密度方法，即预先混合聚合物与填料制备复合物，复合物在沥青中会吸收油份而溶胀，改变填料的用量从而调节聚合物与沥青的密度差异的方法，制备出高温贮存稳定的改性沥青，并研究了工艺条件和配方因素对聚合物/填料复合物力学和聚合物分子量分布的影响，系统考察了工艺条件和配方因素对聚合物/填料改性沥青性能与形态结构的影响，研制出性能优良、高温贮存稳定的苯乙烯-丁二烯-苯乙烯三嵌段共聚物、氢化SBS、低密度聚乙烯改性沥青，并通过流变学分析方法及凝胶和溶胀测试探讨了聚合物与填料的相互作用，指出经过预混工艺填料改变了聚合物与沥青的密度差异，以此说明聚合物/填料改性沥青高温贮存稳定的原因；研究了基质沥青和聚合物改性沥青热氧老化过程，并分析了抗氧剂对基质沥青及聚合物改性沥青的影响，探讨了抗氧剂提高沥青耐老化性能的原因。

The research on bound rubber and reinforcing effect of mineral filler showed that there are four kind of interactions between filler and rubber matrix in uncured mix The unbounded rubber on the surface of filler will solve in organic solvent The rubber bounded by stronger physical or chemical interaction with filler will dissolve in organic solvent The bound rubber on the surface of filler by different extent acid-base interactions will solve in basic organic solvent The bound rubber on the surface of filler by chemical action (no acid-base type) will dissolve in basic organic solvent

结合橡胶和增强作用的研究表明，在混炼胶中，硅橡胶与矿物填料的作用形式有四种。没有联结在矿物表面的非结合橡胶和仅靠物理吸附联结在填料表面的硅橡胶将溶解于有机溶剂；与填料有较强相互作用的硅橡胶不溶于有机溶剂；通过不同层次的酸碱作用联接在矿物表面的硅橡胶将溶解于碱性有机溶剂；与填料有牢固化学结合的硅橡胶不溶于碱性有机溶剂。

The results show that the spreading area of series Ni-P filler metal increases with the increase of brazing temperature, and the spreading areas of Ni-P filler metal is larger than that of Ni-Cr-P filler metal; the shear strength of the brazed joint at room temperature increases with the increase of temperature from 925℃ to 1000℃, and the shear strength of the stainless steel joint brazed with Ni-P filler metal is superior to that with Ni-Cr-P filler metal by 30~40 MPa in the same brazing technology.

结果表明，Ni-P系钎料铺展面积随钎焊温度的升高而增大，并且相同温度下不含Cr的Ni-P钎料铺展面积大于Ni-Cr-P的铺展面积；钎焊温度从925 ℃升高到1000 ℃过程中，Ni-P、Ni-Cr-P钎料钎焊不锈钢接头的室温剪切强度均增大，并且在相同钎焊工艺下，不含Cr的Ni-P钎料钎焊不锈钢接头室温剪切强度优于Ni-Cr-P钎焊接头强度30~40 MPa；Ni-P系钎料钎焊接头高温强度随温度升高而下降，测试温度超过500 ℃时，相同温度下含Cr的钎料能够提高钎焊接头强度0~30 MPa。

Aiming at filler wall quality problems,it analyzes the chief origins of the filler wall crack,brings forward corresponding prevention measures,overcomes the filler wall crack quality control problems basic with the reinforced management in construction,and increase the quality requests of housing.

针对填充墙体的质量问题，分析了填充墙体产生裂缝的主要原因，提出了相应的防治措施，并在施工中加强管理，基本克服了填充墙体裂缝的质量控制难题，提高了住宅楼的质量要求。

The mechanical properties and microstructure of the joints joined by the new developed filler metal and TC18 filler metal were compared,the results showed that only the strength of the joint joined by TC18 filler metal was satisfied,while the comprehensive mechanical properties of the joint joined by the developed filler wire were ideal.

对采用研制的焊丝和采用TC18同质焊材钨极氩弧焊焊接TC18钛合金的接头力学性能及微观组织进行了对比研究，结果表明：采用同质焊材焊接TC18钛合金只能保证接头的强度指标，而采用研制的新型焊丝焊接TC18钛合金，可以保证接头具有优良的综合力学性能。

Two Mode Carrueau Viscosity model showed that polymer and filler had a strong effect on structure orientation, demonstrating that the interaction between polymer and filler in premixing them existed, and the interaction made the polymer and the filler gather in blending the polymer/filler compound with asphalt.

老化使得沥青的软化点及粘度增大，而针入度和延度降低，在红外谱图上主要表现为羰基峰的增大，而亚砜基峰的变化趋势和老化时间及强度相关，老化之初亚砜基峰增大，但随后又减少。

Based on a computing model of floor heating residences, indoor thermal environment and heat distribution under the effect of heat charge/discharge, operation control and solar radiation has been concluded. Concept and formula of equivalent heat supply has been put forward which indicate that actual heat supply will be equal to the sum of design heat supply and equivalent heat supply. Recommend coefficient has been given taken Dalian as an example. Computed according to the new method, design heat supply can be reduced to 37% in cloudy day and 43.3% in sunny day, energy saving effect is very obvious. In Tromb wall solar house, effect of concrete wall on indoor temperature swing and attenuation of temperature wave is very obvious. While the outdoor air-temperature swing exceeds 10℃, indoor air-temperature swing belows 3℃. In the experiment, maximal difference in temperature between inner surface and outer surface of the 300mm wall exceeded 10℃. Heat storage and collector efficiency varies adversely according to solar radiation. Factors such as thickness, material, absorptance of the wall and permeation of the glass cover all have big influence on heat storage and collector efficiency. There exsisted an optimal thickness of the wall, which can make the best of heat storage and collector efficiency. Most of the heat stored in conventional Trombe wall during the daytime has been lost to the outside at night without heat preservation. Heat preservation on the outside surface of the wall has effectively improved heat release performance of the wall at night, heat supply to the room has increased too.

通过建立的地板采暖系统动态热性能分析模型，得出了在蓄放热特性、运行方式和太阳辐射等因素耦合作用下的室内热环境及热量分配比例，提出了等效供热量的概念及计算公式，指出实际所需供热量应等于设计供热量加上等效供热量，并以大连为例，给出了等效供热量的修正系数，以新方法计算，阴天可减少设计供热量37％，晴天最大可以减少设计供热量43.3％，节能效果显著；集热蓄热墙式太阳房中，混凝土蓄热墙的室温均一化效果和对温度波的削减作用非常明显，当室外温度波动最大幅度超过10℃时，室温波幅不超过3℃，实验中300mm厚墙体内外表面温差超过10℃；墙体蓄热效率与集热效率随太阳辐射照度的变化呈相反的变化趋势；墙体厚度、材料、表面吸收率以及盖板透过率等因素对集热和蓄热效率均有较大的影响，存在一个最佳的墙体厚度值，使得墙体集热和蓄热综合性能最优；传统的蓄热墙夜间没有外保温，辐射散热损失很大，研究表明墙体外保温方式明显改善了蓄热墙夜间的散热性能，增加了向室内的供热量。

These buildings has encompassed all available faade systems which includes the stick built curtain wall system, the unitized curtain wall system, point-supported curtain wall system, the double-decked curtain wall system, the metal curtain wall system, the stone material curtain wall system, the terra cotta panel curtain wall system, the photovoltaic curtain wall system and the shading system, as well as the energy conservation environment protection aluminum alloy windows and doors system and towering structure and steel structure system, etc.

这些外墙涵盖了目前几乎全部的外墙系统，包括构件式幕墙系统、单元式幕墙系统、点支幕墙系统、双层幕墙系统、金属幕墙系统、石材幕墙系统、陶土板幕墙系统、光电幕墙、遮阳系统、节能环保铝合金门窗系统、高耸结构以及钢结构系统等。

Ade systems which includes the stick built curtain wall system, the unitized curtain wall system, point-supported curtain wall system, the double-decked curtain wall system, the metal curtain wall system, the stone material curtain wall system, the terra cotta panel curtain wall system, the photovoltaic curtain wall system and the shading system, as well as the energy conservation environment protection aluminum alloy windows and doors system and towering structure and steel structure system, etc.

这些外墙涵盖了目前几乎全部的外墙系统，包括构件式幕墙系统、单元式幕墙系统、点支幕墙系统、双层幕墙系统、金属幕墙系统、石材幕墙系统、陶土板幕墙系统、光电幕墙、遮阳系统、节能环保铝合金门窗系统、高耸结构以及钢结构系统等。

Shanhaiguan is now the territory of the Great Wall is 26 kilometers length, including: the old leading the Great Wall, Great Wall, South Wing, Guan City, Great Wall, the north wing of the Great Wall, Great Wall, Cape Mount, three off the Great Wall and the nine other locations outside the Great Wall.

现属山海关境内的长城全长26公里，主要包括：老龙头长城、南翼长城、关城长城、北翼长城、角山长城、三道关长城及九门口长城等地段。

The father that if work,mad father, love annoys, disposition is too indrawn the be short ofing that the father of Mu Ne, resign oneself to adversity causes father easily to love is broken; Communicate time effectively between father and son, Mu Zizhi to be less than a hour on average to wait a moment every week, it is the cause that causes the child to become addiction.

如工作狂的父亲、爱愤怒的父亲、性格过于内向木讷、逆来顺受的父亲都易造成父爱的缺失；父子、母子之间的有效沟通时间每周平均小于一小时等等，都是造成孩子成瘾的原因。

These are vandal proof and they come with a locking mechanism.

这是野蛮的证据，他们来到了锁机制。