查询词典 factor loading

Carbon nanotubes after oxidation and purification were used to pack a micro-column which was incorporated into a sequential injection system for facilitating online selective sorption of lysozyme from egg-white. The retained protein was afterwards quantitatively eluted by a carbonate buffer. With a sample loading volume of 2.0 mL, an enrichment factor of 12 was obtained, along with a retention efficiency of 100% and a recovery rate of 100%.

将多壁碳纳米管经氧化和提纯后装入固相萃取柱，在顺序注射系统中实现对蛋清中溶菌酶的在线选择性萃取，以碳酸盐缓冲溶液定量洗脱，进样量为2 mL时，富集倍率为12，吸附率和洗脱率均为100%，采样速率为10 h^(-1)，精密度为3.0%。

Based on the FEM results, influences of bolts number n, flange plate thickness t and bolts edge distance factor η on the failure characteristics and loading capacity are studied.

利用有限元计算结果，分析了螺栓个数n，法兰板厚度t以及螺栓边距参数η等参数对节点破坏形态和承载力的影响。

Hot diet, hot tea, dry rigidity food, pickled vegetables, fast hot diet, cigaretter smoking, alcoholic drinking, family history of esophageal cancer had great loading in the first common factor; the second common factors were lower body mass index, education, occupation, economic income; the third common factors were inhabitancy landform, polluted water drinking; the forth common factors were batter cake, pickled foods, tinpot vinegar, mildewed foods; the fifth common factors were tea drinking, greenness vegetables fruit, bean products and garlic and gingers and the sixth common factors were upper alimentary canal diseases, chronic oesophagus inflammation, pharyngitis, stomatitis and decayed tooth.

结果 34项影响因素间存在6个主要公因子，其中，第一公因子上因子载荷较大的有喜烫食、烫茶、干硬食物、口味重、热食且快、吸烟、饮酒、及家庭关系、脾气性格、家族史，第二公因子上因子载荷较大的有BMI、文化程度、职业、经济收入，第三公因子上因子载荷较大的有居住地形、饮水污染，第四公因子上因子载荷较大的有煎饼、腌制品、醋、发霉食物，第五公因子上因子载荷较大的有饮茶、蔬菜、水果、豆制品、姜、大蒜，第六公因子上因子载荷较大的有消化道病史、慢性食管炎、咽炎、口腔溃疡、龋齿。

Through above numerical analysis of the TiN coating/substrate system, some typical rules about the fatigue failure are found:(1) the fatigue damage of a coating/substrate system appears first on the interface, then expands along the interface and to the substrate, and finally causes the coatings broken and spalled;(2) under the cyclic loadings of tangential sliding and radial extrusion, the equivalent plastic damage on the interface is mainly generated by the shear stress and the accumulated plastic contributed by the increments of shear stress. Thus the change of the shear stress is the main factor for the contact fatigue damages of coating/substrate system;(3) the frictional coefficient, external loading and coating thickness have some influence on the carrying capacity and contact fatigue life for a coating/substrate system.

通过对TiN涂层／基体系统的数值模拟分析，得到了涂层／基体系统疲劳失效的一些典型规律：(1)、涂层基体的初始损伤首先出现在交界面处，然后沿界面并向基体中扩展，最后导致涂层断裂而发生剥落失效；(2)、在切向滑动和径向挤压循环载荷作用下，交界面处的塑性损伤主要是由剪应力τ产生，塑性累积也是由于△τ的变化引起，说明循环过程中剪应力变化是影响涂层接触疲劳破坏的主要因素；(3)、材料摩擦系数、外界载荷大小以及涂层厚度都对涂层／基体系统的承载能力以及疲劳寿命都有一定影响。

Also, the performance of four techniques, using different approximation to estimate the equivalent peak value of shear stress and strain were investigated for the purpose to determine the equivalent shear modulus, damping, excess pore water pressure and residual strain induced by seismic loading, in which the equivalent peak value was computed in terms of its standard deviation and the corresponding peak factor.

利用上述动力有限元程序分别对水平地基进行了总应力、不排水有效应力和排水有效应力随机动力响应分析，并通过4种不同的方法来计算地基的等效剪切模量、阻尼比、振动孔压和残余剪应力。

After the relation between the torsion moment and the torsion angle, then the relation between the compliance of the loading system and the crack length are obtained, the compliance method has been used to obtain the energy release rate, and from that the stress intensity factor has been obtained.

通过求解弹性力学的夹层截面扭转问题进行应力分析，求得试件的扭矩和扭转角的关系以及加载系统的柔度C和裂纹长度a的函数关系，再用柔度法求得能量释放率，最后由能量释放率G求得应力强度因子K。

Since historical times,England ,where the early inhabitants were Celts, has been conquered three times .

从有历史以来，英国，在此地早期居住的是凯尔特人，已经被征服了三次。

Bluetooth OBEX File Transfer Enables the sending and receiving of files on your phone via Bluetooth.

蓝牙OBEX文件移动允许经过蓝牙传送和接受文件。。。。