查询词典 element of surface

The preliminary results show that the technique can not only in voke fast heating and rapid cooling proceses inside surface lagers of the samples, but also implant the required element into the material surface.

试验结果表明，该技术能使材料表面产生快速加热和快速冷却，并能把所需要的元素注入材料表面，在材料表层有新的氮、碳化合物相产生。

The results of XEDS suggested that U and Ba were enriched on the surface; at the same time, Ca and Ti had a little depleted on the surface of pyrochlore-rich synroc; the results of XRD and SEM indicated that Fe〓O〓 can increase the corrosion of glass and pyrochlore-rich synroc; The results of glass mass loss rate showed that bentonite had the most corrosive to the glass specimens among barrier media; the results of XEDS indicated that Ca、Fe and A1 element were enriched on the glass surfaces, Si and Mg had slightly depleted, and Na was completely depleted.

玻璃固化体样品分析结果显示，膨润土体系有增加玻璃腐蚀的倾向。X-射线能谱分析表明，在玻璃样品表面Ca、Fe和Al元素呈富集，Si和Mg元素略有浸出，Na元素基本完全浸出，这同其他浸出实验结果一致。

Sb doped Ti-base tin dioxide electrode with an inter-layer was prepared by electrochemical deposition and thermal oxidation. The micrograph of the electrode surface, the element composition of different layers and the structure of the electrode surface were analyzed by SEM, EDX and XRD.

采用电沉积热氧化法制备了含有中间层的Sb掺杂钛基SnO2 电催化电极(Ti/SnO2)，采用SEM、EDX以及 XRD 等检测方法对所制备电极的表面形貌、元素组成及结构进行分析，并以苯酚为目标有机物，研究所制备电极对有机污染物的电催化降解能力。

The simulations of the design of the pressing surface, technological supplementing surface and drawing rib of the die and the forming process of the metal sheet part were realized with the commercialized software AutoForm, which changed the traditional method that needs frequent improvements in the die with a CAD software after finite element simulation.

改变了传统的在有限元模拟后依靠CAD软件进行频繁模具改进的方法，在有限元软件内部实现了模具的参数化设计，既缩短了模具设计时间，又提高了模具设计可靠性

Accompanied with the spark discharge,the cell voltage presents oscillations within the range of several volts,and the surface morphologies,the element distribution as well as the surface potential distributions of the anodic layer are significantly changed.

在电火花的影响下，镁合金氧化试样的表面形貌、元素分布以及表面电位分布等都发生了显著的变化。

In order to study the principle of the road surface deicing and snow-melting system where electric heating cable is used, finite element method is adopted for calculating the change of road surface temperature.

为研究发热电缆路面融雪化冰机理，采用有限元分析方法对路面温度变化进行研究，得到不同气候条件下道路表面及结构层内的温度分布、升温规律。

Based on the theory of shrinkage, capillary force theory, the influence of road concrete additives in common use on surface tension of water is studied, and the results show that the influence of water reducer is very small whereas shrinkage-reducing agent and air entrainer can reduce surface tension of solution significantly. The relation between surface tension and additive dosage are non-linear relation. Each additive has an obvious critical micelle concentration.

从混凝土收缩的基本理论——毛细管张力理论出发，通过道路混凝土外加剂对水的表面张力的影响研究发现，减水剂对水的表面张力的影响很小，而减缩剂和引气剂可以大幅度降低溶液的表面张力，溶液的表面张力随外加剂的掺量呈非线性形式降低，而且都存在临界胶束浓度。

Release coating which is the backing sheet surface coated with silicone oil layer, coated with silicone oil makes the backing sheet as a surface tension is very low and very smooth surface that are used to prevent adhesively bonded to the backing sheet.

离型涂布即在底纸表面涂布硅油层，涂布硅油可使底纸成为表面张力很低，很光滑的表面，作用是防止粘合剂粘结在底纸上。

The lower part is attached to the base plate, and the rectangular slot has (1) a first side wall adjacent to and parallel with the base plate, the first side wall being defined by a surface of the lower part,(2) a second side wall defined by a surface of the upper part, and (3) a bottom wall defined by a surface of one of the upper and lower parts.

紧固件，较低的部份是连接到底板、矩形槽有(1)第一次侧墙毗邻，平行底座、第一次侧墙被定义为一个表面的下方，(2)第二次侧墙定义为一个表面的上方，和(3)底壁由一个表面的上部和下部阀部件。

For a general parametric curve/surface, we usually cannot compute its exact implicit form. Even though its exact implicit form can be computed, the curve/surface implicitization involves relatively complicated computation and the degree is higher. Moreover, it may have unexpected components and self-intersections. All these unsatisfied properties limit the applications of the exact implicitization. So finding curve/surface approximate implicitization has become a practical problem. In this paper, we present an algorithm to solve the approximate implicitization of a given parametric curve by using a quadratic algebraic spline curve.

由于精确隐式化过程不一定可以实现，即使可以实现隐式曲线曲面的阶数高计算复杂，并且具有不希望的自交点和奇异分支，从而限制了隐式化的运用，所以寻求参数曲线曲面的近似隐式化问题成为很实际又重要的问题，提出利用二次代数样条曲线来实现一般平面参数曲线近似隐式化的一种算法。

I'm not an actor. I'm a professor of paleontology.

我不是演员，我是古生物学教授

Spider Network Web site that is a very image of the name.

网络蜘蛛即Web Spider，是一个非常形象的名字。