查询词典 distortion angle

Information such as attitude angle of aircraft is used to emendate the large-geometry-distorted image, so the research of this paper is based on the hypothesis that images used have small geometry distortion and invariant moment feature is used to reduce this distortion.

由于大的几何失真图像可利用飞行器本身信息进行几何校正，所以本文的研究都是基于小的几何失真这一假设的，并且利用不变矩特征来减小这种失真。

On Image-Collecting, trapezoidal distortion is one of the most common distortion. We present a rectification method for it. In the case of knowing the focal distance and the size of CCD, the only parameter needed to know to restore the image is the angle of the camera axis with the ground.

摘要图像采集中的梯形失真是工程中最常见的失真之一，对此本文提出一种校正方法，在已知摄像机的镜头焦距和CCD大小的情况下，仅需要知道摄像机中轴线与地面的倾角一个参数，不需要控制点，就可以恢复原始图像。

While corner sharpness is good, it produces significant barrel distortion at the wide-angle end,and some pincushion distortion at the telephoto end.

虽然边缘图象的清晰度不错，但广角端产生了比较大的桶形失真，在长焦端也少许枕形失真。

Accurate measurement of geometrical distortion of image display system with wide-angle objective lens is the precondition and key of digital distortion correction.

准确地测量含有广角耦合物镜的图像显示系统的几何畸变是实现图像显示系统几何畸变数字校正的前提和关键。

Optimal screw path length: The distance from the optimal entrancepoint to the optimal vent point Screw tail distance: The distance between left and right optimalentrance point Transverse section angle: Half of the included angle between left andright optimal screw Sagital section angle: The average of angle between both side optimalscrew with the upper terminal plate 1.2.2 Modify the threshold of CT value to distinguish the rear partof the lumbar, Observate the the optimal entrance point and the adjustable range.

1.2.2三维重建观察螺钉最佳进钉点的位置和各方向螺钉进钉点关系，调整CT值下限阈值使椎弓后部结构尽量显示清晰，以利观察。 1.3统计方法本实验采用SPSS13.0统计软件。对同一椎体左右两侧椎弓根螺钉相对数据行计量资料配对样本t检验，对男女组间相关数据行计量资料独立样本t检验，对男女组内不同腰椎节段间相关数据行单向方差分析及不同腰椎节段间LSD法多重比较。

Based on varying process of generator terminal parameters after excitation fault, shortages of excitation protective principle of static stability boundary and asynchronous impedance boundary are analyzed. It proposed that excitation fault research relates to large-disturbance stability. Because dynamic power-angle character of generator after excitation fault is non-sinusoidal, there are differences between dynamic power-angle character and static state power-angle character. So it isn't ideal to protective operation result based on small-disturbance stability and static stability boundary criterion. At the same time, it proposed that asynchronous boundary impedance criterion is a constant reactive power circle moving adown j Xd′. It can ensure complete loss-of-excitation generator measuring impedance enter into the circle, but can't ensure the other condition measuring impedance including impossible losing synchronism enter. So loss-of-excitation protection would be maloperation when system voltage drops short and recovers or generator rejects load.③Based on stability principle, it puts forward setting conditions and calculation method of generator loss-of-excitation protection by direct measuring power-angle.

以励磁故障后发电机端的相关参数的变化为基础，通过对以静稳定边界和异步阻抗边界作判据的两类三种现行励磁保护在原理上存在的缺陷分析，发现：励磁故障是一个大干扰稳定性问题，励磁故障后的发电机的动态功角特性与静态功角特性有很大的差异，已远非正弦曲线，因此基于小干扰稳定性原理、以静稳定边界作判据的保护必然动作不理想；异步边界阻抗判据是一个下移j Xd′的等无功阻抗圆，它可以保证完全失磁后的发电机测量阻抗能进入该阻抗圆，但不能保证完全失磁之外的其它状态不会进入该阻抗圆，因此在系统电压短时下降或发电机突然甩负荷等情况下可能启动该保护使之误动。

In this paper, a spark advance angle adjusting system is presented. In the system, spark advance angle of engine with carburetor on which spark controlled ECU is installed can be matched, the spark advance angle was real time adjusted according to engine different speed and load to find the ideal spark advance angle.

提出了一种具有调节点火提前角功能的控制系统，该系统能够在对化油器发动机进行简单改造加装点火控制ECU后对其点火提前角进行标定，对发动机在不同转速和工况下的点火提前角进行实时的调节，寻找到发动机在该转速和工况下的理想点火提前角。

Results There were obvious mandible changes such as the increase of SNB angle and decrease of ANB angle and overjet after treatment with Twinblock, suggestive of mandible growth, increase of facial angle, reduction of mandible process angle, mild adduction of upper incisors, and mild anteversion of lower incisors.

结果 矫治前后下颌骨的变化具有统计学意义，表现在SNB角的增大和ANB角、OJ的减小，提示下颌骨的生长、面角增加和颌突角减小，上前牙轻度内收和下前牙少量前倾。

［Objective］To identify the standard of radiographic diagnosis and analyse the measurement between tailor's bunion and normal feet.［Methods］The fourth-fifth intermetatarsal angle (IM4～5),modified fourth-fifth intermetatarsal angle (MIM4～5),metatarsophalangeal-fifth angle,lateral deviation of the fifth metatarsal angle,width of fifth metatarsal head,distance of prominence of the fifth metatarsal head were measured by X-ray for 131 feet of normal persons and 117 feet of tailor's bunion. The measured results and other clinical presentations were compared.

［目的］通过对小趾囊炎足与正常足X线的测量及对比分析研究，明确小趾囊炎足X线诊断标准［方法］对131例正常足与117例小趾囊炎足的第4～5跖骨间角(IM4～5)，改良4～5跖骨间角(MIM4～5)，小趾内翻角，第5跖骨外翻角，第5跖骨头宽度及突出距离进行X线测量，结合临床对测量结果进行对比分析研究。

Methods］The fourth-fifth intermetatarsal angle (IM4～5),modified fourth-fifth intermetatarsal angle (MIM4～5),metatarsophalangeal-fifth angle,lateral deviation of the fifth metatarsal angle,width of fifth metatarsal head,distance of prominence of the fifth metatarsal head were measured by X-ray for 131 feet of normal persons and 117 feet of tailor's bunion.

方法］对131例正常足与117例小趾囊炎足的第4～5跖骨间角(IM4～5)，改良4～5跖骨间角(MIM4～5)，小趾内翻角，第5跖骨外翻角，第5跖骨头宽度及突出距离进行X线测量，结合临床对测量结果进行对比分析研究。

No, it's unnecessary. I don't think I have a fever.

不，没有必要，我想我没有发烧。

We live in a culture of instant gratification.

我们生活在即时满足的文化中。