查询词典 discussed

In this paper, the control strategies of variable flow in secondary pump system and primary pump system in air conditioning were also discussed.

本文还探讨了空调二次泵系统和一次泵系统变流量的控制策略。

So in this paper based on the characteristics and the optimum state theory of the vehicle, some kinds of control schemes are compared and discussed, and the fuzzy PID control scheme is adopted at last. The relation between air-cushion pressure and fan rotational speed on the optimum driving state is studied. The cushion pressure is used as controlled variable and the fan revolution is used as regulated variable. And transducer and fan motor are actuators.Based on the structure and operating properties of half-tracked air-cushion vehicle, the control system scheme and structure are presented. A control scheme using the self-tuning PID fuzzy logical controller is adopted. Fuzzy rules are set up and some researches have been done for fuzzy tuning method. At the same time the real-time measurement scheme by computer control is proposed, and electric circuits are designed. In the control system of half-tracked air-cushion vehicle cushion pressure P〓 is used as controlled variable and the fan speed n〓 as regulated variable.

因此本文以半履带式气垫车的特性和最佳工作状态理论为指导，通过对各种控制方法的比较与探讨，提出采用模糊PID控制方案，并且研究了在最佳工作状态下垫压及风机转速的关系，提出气垫压力作为控制参数，变频器和风机电机为执行机构，风机转速为调节量；主要进行了自整定模糊PID控制器的设计，研究了自整定PID模糊控制器的实现方法，编制了模糊控制规则，制定了模糊控制参数查询表，并分析了影响自整定模糊控制器相关的影响因素，确定了模糊控制表；为了实现半履带式气垫车的自动控制，还提出了计算机模糊控制系统的原理与结构，设计了相应的测量电路与控制软件。

This article elaborated the construction principle of two pipe jacking methods——Sludge-liquid balance method and air-pressure balance method , introduced the main equipments used, discussed the construction technology and the treatment measures, then summarized and evaluated the construction effects as well as the merits and disadvantages.

本文结合工程实例，论述了顶管施工中泥水平衡顶管法和气压平衡顶管法两种顶管法的施工原理，对其主要设备及作用进行了简单介绍，对顶管施工中技术及问题处理措施进行了详细阐述，并对施工效果和两种顶管法施工中的优缺点进行了总结和评价。

How to effectively apply to the existing airborne PD radar is discussed in this paper.

如何在现有PD雷达的基础上实现有效的机载GMTI技术是本文研究的主要内容。

Thermal design and its simulation of airborne electronic equipment are discussed in this paper.

对机载电子设备的热设计及其仿真进行了初步探讨。

In this paper,the constitution of the airborne bus system is introduced and the realization of communication on software and hardware is discussed.

介绍总线系统的组成，讨论其通讯功能的硬件及软件实现的问题。

The airgun signal was detected all along the line of the largest offset equal to 185 km, seismic phases Pg, Pc, P2, PmP and Pn have been picked successfully, based on which 1-D forward modeling of deep crustal structure has been conducted and the low-velocity layer of crust-mantle transition zone has been discussed.

在185km长的测线上均记录到了气枪信号，成功检测到Pg，Pc，P2，PmP和Pn等多组震相，并在此基础上对地下深地壳结构进行了一维速度结构正演，讨论了该区域壳幔过渡带的低速结构。

This project also compared and discussed the research results of OBS and onshore-offshore experiments in nearby areas. The conclusion is that the active airgun source is equivalent to an earthquake of about magnitude 0.5, and the airgun signals can be detected at the maximum distance of only about 250 km, which is not enough for the study of deeper lithospheric structure below the crust. Furthermore, the onboard airgun source and MCS streamer are difficult to operate in the shallow water of reef and island areas.

本项目还分析对比了周边地区海底地震仪探测和海陆联合地震探测的研究成果，发现人工气枪震源约相当于0.5级的天然地震，其信号传播距离最远只有250 km左右，很难探测到地壳以下更深部的岩石圈结构特征，此外船载的气枪震源和多道电缆在岛礁区和浅水区很难开展工作。

Methods of testing China uplands cotton fibre fineness and maturity coefficient rapidly by constant pressure airometer is discussed.

1前言棉纤维细度和成熟度系数与纱线加工和性能之间存在十分密切的关系，许多科技工作者提出的由棉纤维性能预测其纱线性能的相关方程已得到应用［1～5］。

Discussed its bearing structure design and the reasonable choice of bearing's tolerance and fit,windage, lubrication and airproof .

对其支承结构的设计和轴承的公差配合、轴承的游隙以及润滑与密封等方面的合理选择进行了论述。

It has to be computed by the host for the actual clock rate.

主控制器可以用来计算实际的时钟速率。

Let's see what you got.

让我看看你的东西