查询词典 diameter

HVAC piping design with valve selection 1, chiller plant, cooling water between inlet valve design; 2, before the butterfly pumps, filters, pumps after the check valve, butterfly valve; 3, sets, water separator pressure differential between the bypass valve; 4, set, divider into the returning pipe valve 5, the level of dry pipe valve; 6, valve air handling units, filters, electric two-pass or three-way valve 7, fan coil valve (or plus electric two-way valve) Note: The valve is typically used when the diameter is less than 150mm used Handle Butterfly Valve (D71X, D41X); diameter greater than 150mm used worm drive butterfly (D371X, D341X).

暖通空调管道用阀门的选型设计 1、冷冻水机组、冷却水进出口设计蝶阀； 2、水泵前蝶阀、过滤器，闸门水泵后止回阀、蝶阀； 3、集、分水器之间压差旁通阀； 4、集、分水器进、回水管蝶阀 5、水平干管蝶阀； 6、空气处理机组闸阀、过滤器、电动二通或三通阀 7、风机盘管闸阀注：一般采用蝶阀时，口径小于150mm时采用手柄式蝶阀（D71X、D41X）；口径大于150mm时采用蜗轮传动式蝶阀（D371X、D341X）。

The following General 100 mm diameter rollers against the version of the printed version of the drum of nano-imprint lithography width is 5-6 mm, and more than 100 mm diameter rollers by Edition and a printing plate cylinder embossing width to 7 ~ 8 mm ,does water roll of indentation width to 6 ~ 8 mm guests'glasses.

凡是直径在100mm以上的靠版墨辊与印版滚筒的压印宽度为5～6mm，而直径在100mm以上的靠版墨辊与印版滚筒的压印宽度以7～8mm为宜，火辊的压痕宽度以6～8mm为宜。

Material: Mew?10mg/ is raised, shandong Qi Lu pharmaceutical factory produces , recombine 10 thousand U/ of 2(20 of leucocyte interpose element to raise, inc. of industry of drug of Beijing double aigret produces), canal of central vein buy covers a bag, its are in charge of external diameter 1.7mm, internal diameter 1.1mm, drainage bag, transparent dressing is stuck and article of thorax puncture convention. 1.2 operations and remedial method patient are taken ride cross, towel of groovy disinfection, shop, local anaesthesia, take out central vein conduit, exceed fixed position dot to be puncture dot with B.

材料：顺铂(10mg/支，山东齐鲁制药厂生产)，重组白细胞介素2(20万U/支，北京双鹭药业股份有限公司生产)，中心静脉置管套件包，其管外径1.7mm，内径1.1mm，引流袋、透明敷料贴和胸腔穿刺常规物品。1.2操作及治疗方法患者取骑跨位，常规消毒、铺巾、局部麻醉，取出中心静脉导管，以B超定位点为穿刺点。

Results RAS(defined as ≥50% diameter stenosis) was detected in 22 of the 157 patients (14.01%) and 21 of the 81 patients with coronary artery disease(25.93%) who had at least one coronary artery of ≥50% diameter stenosis, while no RAS was found in patients whose coronary angiograms were normal.

结果 157例患者中，肾动脉狭窄发生率为14.0%；经冠状动脉造影证实的81例冠心病患者中，肾动脉狭窄的发生率为25.9%；冠状动脉造影完全正常的62例患者中，无1例有肾动脉狭窄。

The results indicate that the Sauter mean diameter is smaller and the diameter distribution is more uniformity for the droplets obtained from a pulsating flow than those from conventional atomizers.

试验结果分析表明：脉动气流频率越大、料液流量越小和料液粘度适中时雾化效果最好；采用脉动气流雾化得到的雾滴的Sauter平均直径更细，粒度重量分布均匀，。

Zenith telescopes, spectrographic instruments and attachments, micrometers, photometers, comparators, coelostats of at least up to 65 cm diameter, and sundials of up to at least 90cm diameter rounded out the product line.

还有大到65 cm物镜直径的天顶仪、摄谱仪及配件、测微计、光度测定器、测远仪、定天镜(注：观测或拍摄天体时镜面与地轴一同转动可使图像固定不动)，大到90 cm物镜直径的日昝仪都出现在蔡司的生产线上。

Nano-zirconia particle diameter and calcium phosphate powder, added sufficient quantum compound SiO2 and Na2O adjunct, after added deionise water and grind 4h, select polyurethane scaffold (interval porosity of 75%、85% and 92%, pore diameter 300um) as mould to obtain nano-zirconia calcium phosphate scaffolds.

以纳米氧化锆颗粒和磷酸钙粉体为原料，加入适量含SiO2和Na2O的复合添加剂制成复合粉体，加入去离子水后混磨4小时，分别选用孔隙率75%、85%和92%，孔径为300um的聚氨酯支架为模板，制成纳米氧化锆/磷酸钙骨支架。

The results of numerical simulation suggest that the demisting efficiency increases as droplet diameter and gas velocity increasing and decreases as the mist eliminator plate spacing reducing, and the efficiency of arc-shaped plate with barb mist eliminator is higher than that of polyline-shaped plate mist eliminator. Droplet with a diameter under 20 mm is of low demisting efficiency.

数值分析表明：除雾效率随液滴直径的增大而增大，随进气速度的增大而增大，随除雾器叶片间距的增大而降低；带倒钩的弧形板除雾器比折形板除雾器的除雾效率高；粒径小于20 mm的小液滴脱除效率较低。

The results show that single structure parameters (width and depth of flow path/passage, and height, and angle of dentations) are local and difficult to represent the anti-clogging ability of emitters. Characteristic structure parameters(minimum size of cross section, hydraulic radius and dentitions spacing) can represent the anti-clogging ability of emitters in a sense. There are anti-clogging critical values under the test. Rated flow Qr and the ratio of diameter of labyrinth passage to diameter of particle η are well cor related to the anti-clogging ability and have anti-clogging critical values too.

结果表明：用单一结构参数(流道宽度 W 、流道深度 D 、齿高度 h 和齿角度θ)表征其抗堵塞性能存在局限性；结构特征参数断面最小尺寸 min(D，W、水力半径 R 和齿间距 l 能较好反映滴头流道横、纵断面的结构特征，在不同程度上表征了流道的抗堵塞性能，且在试验条件下各自均存在抗堵塞临界值；滴头额定流量 Qr 和迷宫滴头径粒比η与抗堵塞性能相关性较好，且存在抗堵塞临界值。

The pupil diameter of different diopters changes greatly under different rays, and it is a very important parameter to measure the pupil diameter in different diopter under different rays before the refractive surgery.

不同屈光度在不同光线下瞳孔直径有很大的变化；不同屈光度在不同光线下的瞳孔直径是屈光手术前评估的一个重要参数。

The system can be widely used in belt weighing and batching process control,etc.

介绍了基于智能模糊控制的嵌入式配料系统的设计方法，对模糊PID控制过程和系统调零作了重点的讨论，同时给出了PID控制的程序流程图和系统定长调零子程序。

"I dunno," she answered,"but if you show me aroun', I'll recognize it from the lighthouse just outside the porthole."

"我不知道，"她回答说，"如果你能带我转转，我能认出来的，因为灯塔就在舷窗外。"