查询词典 critical path method

This theory can be used to find the bifurcation point on the equilibrium path and obtain the critical load and critical mode.

采用了塑性增量理论来决定结构的塑性应力状态，避免了结构反应对加载路径强烈的依赖性。

CPA stands for Critical Path Analysis - its the critical dates that must be acheived in order to make the delivery date.

CPA 代表紧要关头的路径分析-它的紧要关头的日期必须为了要约订递送日期，是 acheived 。

One must be aware of the following in order to understand the NPD process: Analysis of Critical path, proceeding by combine with QMS. Thus one could clearly realize the major check point and stage gate of whole project of QMS process. In the same time, resource allocation and conscientious audition fora critical activity could be processed with such analysis.QMS function helps us to do the job right and well contribute in limited time with limited resources.

了解在新产品发展过程上，运用阶段关卡流程法管理工具，必须注意到：关键流程的分析，并结合品质管理系统来实行，可以清楚整个专案的新产品发展过程中的重要检核点或关卡在哪里，同时可经由此分析，对相关的关键活动进行资源的分配及严密的审核。

By using the basic theory of PERT/CPM, a programming model of the critical quality chain evaluation in manufacture process network is proposed; the path in which quality loss is maximal is the critical quality chain.

进一步应用PERT/CPM的基本思想，建立了生产制造过程网络关键质量链的规划模型，将质量损失最大的路径视为关键质量链。

The results show that single structure parameters (width and depth of flow path/passage, and height, and angle of dentations) are local and difficult to represent the anti-clogging ability of emitters. Characteristic structure parameters(minimum size of cross section, hydraulic radius and dentitions spacing) can represent the anti-clogging ability of emitters in a sense. There are anti-clogging critical values under the test. Rated flow Qr and the ratio of diameter of labyrinth passage to diameter of particle η are well cor related to the anti-clogging ability and have anti-clogging critical values too.

结果表明：用单一结构参数(流道宽度 W 、流道深度 D 、齿高度 h 和齿角度θ)表征其抗堵塞性能存在局限性；结构特征参数断面最小尺寸 min(D，W、水力半径 R 和齿间距 l 能较好反映滴头流道横、纵断面的结构特征，在不同程度上表征了流道的抗堵塞性能，且在试验条件下各自均存在抗堵塞临界值；滴头额定流量 Qr 和迷宫滴头径粒比η与抗堵塞性能相关性较好，且存在抗堵塞临界值。

The calculation and analysis show that the sub-critical fast reactor is feasible for transmutation of minor actinides and can remain sub-critical when it adds some MA, it is feasible to choose the CDFR for the sub-critical fast reactor research.

计算结果表明：次临界快堆中加入MA后能够保持一定的次临界度且具有较好的嬗变效果，因此，选取示范快堆堆芯作为ADS次临界快堆的参考堆芯研究是可行的。

Critical angle of refraction - semi-circular cylindrical mobile light source, the incident angle change the size of refraction angle to change at this time, when the refraction angle = 90 degrees, which is critical at this time angle of incidence angle, the critical angle of water at 40 degrees large about anything mobile source of water in the water screen that is a reflection of light, a phenomenon that total reflection.

光折射的临界角定义：光折射角=90度时，入射角即为临界角，按二方法，将半导体激光光源去掉铁夹，吸附在右下角的铁板上入射光对准中心，即产生折射光线，沿半圆形柱面移动光源，改变入射角的大小，这时折射角也改变，当折射角=90度时，这时入射角即为临界角，水的临界角大的在40度左右，再做移动光源在水中的水屏即出现反射光线，这种现象称全反射。

The unsaturated and compacted soil triaxial test result under constant suction describes the unsaturated soil critical state surface in p-q-s three dimensional space: in p - q plane, the slope M of critical state line is independent of suction; the cross line of LC yield surface and critical state surface is a curve with extremum in three dimensional stress space, and its projection in p-s plane is located in quadrant 1 in triaxial compression state; its projection in q-s plane has asymptote, and there should also be asymptote in respect of the curve that stands for the function relationship between cohesive and suction.

基于局部变形测量的常吸力非饱和压实土三轴剪切试验结果，全面描述了非饱和土p—g—s三维应力空间中临界状态面的合理形态：在p—q平面，临界状态线斜率M是与吸力无关的物理量；临界状态面与LC屈服面交线在三维应力空间中是一条存在极值的曲线；该交线在p—s平面的投影曲线在三轴压缩应力状态下应位于第一象限；该交线在q—s平面的投影曲线应存在渐近线；反映凝聚力与吸力关系的函数曲线也应存在渐近线。

The coexistence curves and light scattering data for a critical solution of benzonitrile + octane have been reported. The critical exponents relating to the difference in the density variables between two coexisting phasesβ, the osmotic compressibilityγ, and the correlation length v have been deduced and the values were consistent with the 3D-Ising value in the range close to the critical point. The experimental results of the coexistence curves have also been analyzed to examine the Wegner correction terms and the behavior of the diameter of the coexistence curves.

用折射率法和不同角度的光散射法测量了苯甲腈+正辛烷二元体系在临界温度附近的液-液共存曲线和一相区不同温度下的渗透压缩系数及关联长度，得到与共存曲线相关的临界指数β，与渗透压缩系数相关的的临界指数γ和与关联长度相关的的临界指数γ，发现在近临界点体系符合3D-Ising模型，讨论了共存曲线直径和Wagner校正项。

In common glass fiber reinforced polyolefine pipe, when the volume faraction is less than the critical value, the glass fiber can not act as reinforcement, on the contray, it would reduce the whole intensity of the compound material. However, when extruded in combined stress field, the extend intensity of the compound system increases when the volume fraction of glass fibers is less than the critical value. When the glass fiber volume fraction is higher than the critical value, the required glass fiber volume fraction of compound fibers extruded in the combined stress field is less than theory value.

一般玻璃纤维增强管材在常规挤出时当添加的玻璃纤维体积含量小于临界体积分数(当添加的玻纤的复合体系拉伸强度等于基体聚合物材料的拉伸强度时的玻纤体积分数)时，玻纤起不到增强的作用，反而会使复合材料的整体强度降低；但在复合应力场下挤出时，当添加的玻纤含量小于临界体积分数时，复合体系的拉伸强度不但没有降低反而升高了；当添加的玻纤含量大于临界体积分数时，复合体系要达到同样强度，经过复合应力场的玻纤增强管材需要的体积分数小于理论值。

There are different types of personal loans available.

有许多不同类型的个人贷款优惠。

The above mentioned teaching model of spiral rising can be used to avoid rigidness in teaching.

上述螺旋式上升的教学模式，可以避免教学形成模式後的僵化现象。