查询词典 controller of ballot

In which, the calling terminal initiates calling to the calling party calling controller; the calling party calling controller initiates calling to the called party calling controller, and sends the WAC group internal short number of the calling terminal to the called party calling controller; the called party calling controller initiates calling to the called terminal, and sends the WAC group internal short number of the calling terminal to the called terminal.

其中，主叫终端向主叫方呼叫控制器发起呼叫，主叫方呼叫控制器向被叫方呼叫控制器发起呼叫，并在呼叫过程中将主叫终端WAC群内短号发送给被叫方呼叫控制器；被叫方呼叫控制器向被叫终端发起呼叫，并在呼叫过程中将主叫终端的WAC群内短号发送给被叫终端。

Considering the inconvenience of regulation and difficulty of parameter tunning as AC servo system in practical situation, three ways of intelligent control approach to realize auto-tuning and autorecognization of AC servo system, are proposed, which is a robust controller based on two-degrees-offreedom with no tuning to controller, a auto-tuning controller based on fuzzy reasoning with no inertia recognization but tuning parameter of controller, a strategy recognizing inertia of servo system and tuning parameter or structure of controller automatically. In the same time, these control strategies are analyzed from the theory and reliability. The comparative analysis of three measures on strong and weak points is made by simulation and experiment results.

针对交流伺服系统在实际应用中存在的系统调试不便、参数调整困难等问题，提出了实现交流伺服系统自调整和自识别等智能化控制策略的三条途径：一是具有控制器无调整特点的二自由度鲁棒性控制器；二是惯量无识别但需自动调整控制器参数的模糊推理自调整控制器，三是自动识别伺服系统转动惯量并自动调整控制器参数和结构的方案，从理论分析和可实现性两方面对这些控制方案进行了论述，并通过仿真和实验研究，对比分析了各种方案的优缺点，得到了一些有益的结果。

Lightened on the turbine valve controller designed with feedback linearization theory and introduced nonlinear tracking-differentiator, a novel nonlinear PID valve controller was proposed. This controller can fit not only to plant with some model error and random disturbance in variable, but also to the variety of the structure and operating conditions of power system. The transient and dynamic characters of the controller are both satisfactory when big and small disturbances added. The good performance, wide stable margin and heavy robustness of the valve controller proved that it is a great practical application to enhance the stability of power system.

结合反馈线性化法汽轮发电机组的汽门控制研究成果，引入非线性跟踪微分器和非线性度变换控制，进行了发电机组的非线性PID汽门控制器设计，该控制器不仅能适应一定的系统模型误差与变量的不确定性干扰，而且对于电网结构和运行工况的变化有着较强的适应能力，在受大、小扰动的情况下，呈现了较好的暂态特性和动态品质，具有较好的控制品质、较高的稳定裕度和较强的鲁棒性能，有利于进一步改善电力系统的稳定性，显示了其较强的实用性。

The Fuzzy-PID controller of fin stabilizer was designed based on fuzzy control and PID control theory. The controller of Fin Stabilizer is designed which uses roll angle and angular velocity of roll angel as input and fin angel as output. The model of ship is built based on Conolly theory. The controller is simulated using MATLAB. Results shows that compared with conventional PID controller, the FUZZY-PID controller has better effect.

设计了基于模糊控制和PID控制理论的FUZZY-PID复合控制减摇鳍控制系统，以横摇角和横摇角速度为输入量，鳍角为输出量，基于Conolly理论建立了船舶模型，利用MATLAB针对不同海情对控制器进行了仿真，结果表明减摇鳍模糊控制器动态响应性能和稳态控制精度均十分理想，能够满足减摇鳍控制系统的控制要求。

A nerve net controller have been designed on the basis of the hardware design of the AC servo system and system model. The controller include two forward nerve net with three layers . One is designed to identify the AC servo system model and another is to control. The controller use special learning algorithm which to control system at the same time and improve its constringency pace through introducing new MFBP algorithm. The intelligent control algorithmic is programmed using C++ language after the controller have been designed .

在该交流伺服系统硬件设计和系统数学建模的基础上，设计了神经网络自适应控制器，这个控制器包括两个三层的前馈神经网络，一个神经网络用于非线性系统的辨识，另一个神经网络作为控制器，此控制器采取边学习边控制的工作方式，并采用一种新型的MFBP算法实现了控制算法的快速性，在控制器设计完成的基础上，利用C++语言具体实现智能控制算法的编写。

The versatile controller also includes a plurality of field device input/output ports communicatively connected to the processor, a configuration communication port connected to the processor and to the memory to enable the controller to be configured with the programming routines and a second communication port which enables a user interface to be intermittently connected to the controller to view information stored within the controller memory.

这个多功能的控制器也包含许多的通信地连接到这个处理器上的场装置输入/输入端口，还包含一个连接到处理器和存储器配置通信端口，使得控制器被编程程序和第二通信端口配置，这样使得用户接口能够被间歇地连接到控制器上来观察存储在控制器存储器中的信息。

Since the motherboard with the soft, hard disk, such as the use of DMA operations between the peripheral, DMA operation of the response process is as follows (AST386 in the floppy disk to DMA as an example): floppy disk drive made by DREQ2 signal to the DMA controller (82C206), and DMA controller to the CPU (80386) issued HRQ signal, CPU end the current bus cycle after HLDA response signal to the DMA controller, DMA controller issued a final response signal DMA to the floppy disk drive DACK2 allow its data into the system bus.

由于主板与软、硬盘等外设之间采用DMA操作，DMA操作的应答过程如下(以AST386中软盘DMA为例)：先由软盘驱动器发DREQ2信号给DMA控制器(82C206)，然后DMA控制器向CPU(80386)发HRQ信号，CPU结束当前总线周期后发响应信号HLDA给DMA控制器，最后DMA控制器发DMA响应信号DACK2给软盘驱动器允许其数据进入系统总线。

The dominant merit of the proposed decoupling PID controller was that the controller was developed in an absolutely transparent manner and the controller can realize significant decoupling among the nominal responses of system outputs. Moreover, every output can be tuned on line by the single adjustable parameter in the corresponding diagonal element of the controller.

该解耦PID控制器的突出优点是控制器设计过程简单直观；控制器可以实现标称系统输出间的显著解耦；系统输出分别使用相应控制器对角元素中的调节参数进行单参数整定。

The development direction changed direction according to the four-wheeler, the domestic and international company changes direction organization to control to the four-wheeler currently main adoption of is a numeral control, this is owing to a lot of advantages of numerical control:the procedure turn a control, the controller carries on the processing of operation and numerical information according to the control regulation designed, mainly passing procedure to carry out, if change control regulation need to change software, but need not change the hardware structure of system: control the accuracy is high, in the emulation the control the system, the accuracy of the controller from the accuracy of the component but settle, numerical controller accuracy from word long decision;Stability good;The software replies to use, needing a hardware environment of using the homology realization in the emulation the system, the numerical controller is a procedure control, the sub- procedure mold piece which need to be designed and write to carry out its model, can immediately carry out several links of functions expediently.

目前各个厂家大多采用的是PLC、单片机应用于四轮转向控制器中，功能基本能够实现，相比较之下，信号处理能力较强的数字信号处理器各方面均性能优于以上三种处理器。DSP是新世纪数字化革命的核心。它是一种独特的微处理器，具有可编程性，且实时运行速度远远超过通用微处理器。强大的数据处理能力和高速的运行速度，是DSP最值得称道的两大特色。DSP芯片是一种特别适合进行数字信号处理的微处理器。它强调运算处理的实时性，因此除了具备普通微处理器所强调的高速运算和控制功能外，主要针对实时数字信号处理，在处理器结构、指令系统和数据流程上做了很大的改动。它具有灵活、精确、可靠性好、体积小、功耗低和易于大规模集成等优点。

Servo controller is key part of antenna control system.In some servo controller,classic PID control algorithm is adopted. In order to improve precision of control system,the integral parameter has been turned too big to use because it will cause integral saturation which depress system performance.On the other hand,ISA bus is used to communicate between servo controller and main computer.ISA is low speed interface protocol,it cannot provide more data for complicated real time position control in servo controller.

伺服控制器是天线伺服控制系统的核心环节，经典的PID控制算法在整定时整定出的积分环节参数较大，很容易出现积分饱和，造成控制精度的降低；另一方面伺服系统中伺服控制器与主控计算机通过低速的ISA总线进行通信，无法满足控制器进行复杂的位置控制运算所要求的实时大信息量的数据传输。

The second is to cut a mere 100 calories from your diet , which is the equivalent of a tablespoon of butter.

第二个就是从你的饮食中减少一百卡路里，只是相当于一大汤匙的黄油。

This is where the Rorschach test comes in.

现在，罗氏测试就出现了。