查询词典 controlled release

The process of the nonexchangeable potassium release from the soil tested in 912 hours can be well described with linear equation.④ The constant B rate of the nonexchangeable potassium release from the soil tested is controlled by the content of clay and slowly available K.

关于非交换钾的释放动力学，Martin等已用几种微酸性砂质土和砂壤质土进行了初步研究［7～10］，国内在此领域研究不多，对中国北方广泛分布的黄土性土壤非交换钾释放动力学研究更少。

Studies on the release kinetics of microencapsulated garlic granulates in vitro in simulated intestinal fluid indicated that release of garlic powder can be controlled in intestine by the human stomach condition, which it passes through scanning electron microscope revealed that wall materisals are of good integrity, and core materials are well embedded in the microcapsules.

结果发现其可以通过胃的酸性环境而在肠道内释放，扫描电子显微镜观察发现微胶囊化蒜粉颗粒表面壁材结构具有很好的完整性和致密性，芯材很好地包埋于微胶囊中。

The Automatic Control Valves ABS is ABS for short, which is based on the conventional brake system security technologies to enhance improved by controlling the brake hydraulic flaps to achieve control of the wheel locking, the braking process , only when the wheels tend to be controlled when locking, ABS will tend to locking of the wheels anti-lock brake pressure regulation; in the control wheel was not tended to locking, the braking Butterfly Valves process and the conventional system exactly the same dynamic system, the braking process, its work process is actually locking - release - Locking - release cycle of the working process, the vehicle is always in the critical state of locking of the roll gap.

而ABS是制动防抱死系统的简称，它是在常规制动装置基础上的加强改进的安全技术，通过控制刹车油压的收放，来达到对车轮抱死的控制，在制动过程中，只有当被控制车轮趋于抱死时，ABS才会对趋于抱死车轮的制动压力进行防抱死调节；在被控制车轮还没有趋于抱死时，制动过程与常规制动系统的制动过程完全相同，其工作过程实际上是抱死—松开—抱死—松开的循环工作过程，使车辆始终处于临界抱死的间隙滚动状态。

By methods of simulated trial, barrel trial and field trial, this paper studied the dynamic release of nitrogen in the soil and the effects on wheat growth of two kinds of controlled release nitrogen fertilizer under different irrigations in Chao soil derived from alluvial deposit of Yellow River.

采用室内模拟实验、网室筒栽试验以及大田小区试验的方法，本文针对新研制的两种麦田控释氮肥的养分释放、肥效及其与灌水条件的关系进行了研究。

The application of controlled-release fertilizers /slow-release fertilizers was an important way to resolve the problem.

研制与生产控/缓释肥料是解决这一问题的重要途径。国外控释材料的研究主要集中在聚合物，并向环境友好的方向发展。

Trichogramma showed high control efficacy on cotton bollworm eggs after three times of release both in the second and in the third generation bollworm periods. The parasitism on the second and third generation bollworm eggs were 66.0%-70.7% and 76.0%-81.2%, respectively, which were significantly higher than that in the control (second generation: 7.0%-12.3%, third generation: 5.2%-7.4%). And the injury rate of cotton buds and bolls in the second and third generation bollworm were 2.2% and 3.1%, respectively, which were significantly lower than that in the control (second generation:8.5%, third generation: 20.9%). In the second generation bollworm period, number of bollworm eggs or larvae in the Trichogramma released cotton field did not differ to that in the chemically controlled field. But in the third generation, there were significantly less bollworm eggs and larvae in the Trichogramma released cotton field. There were more predators in the Trichogramma released cotton field. These results indicated that cotton boll worm in the transgenic insect-resistant cotton field can he effectively controlled by mass-releasing of T.

结果发现：棉铃虫卵在棉株不同部位的分布差异较大，2代棉铃虫卵主要分布在叶正面、叶背面和茎尖，3代棉铃虫卵主要分布于蕾铃；在放蜂田，赤眼蜂对棉株不同部位棉铃虫卵的寄生率差异较大，2，3代棉铃虫时期对叶正面、叫背面、茎尖、蕾铃的棉铃虫卵寄生率均较高，对叶柄和茎杆处卵的寄生率较低；并以3代棉铃虫时期的寄生率较高；在2，3代棉铃虫时期分别连续释放3次赤眼蜂，对棉铃虫具有很强控制作用，2，3代棉铃虫卵的被寄生率分别为66.0%~70.7%和76.0%~81.2%，均显著高于化防田的自然寄生率（2代：7.0%~12.3%，3代：5.2%~7.4%）；蕾铃被害率分别为2.2%和3.1%，均显著低于化防田（2代：8.5%，3代：20.9%；2代棉铃虫时期，放蜂田和化防田的棉铃虫卵量和幼虫数量差异均不显著，但3代棉铃虫以后，放蜂田棉铃虫卵量和幼虫数量均显著低于化防田，且放蜂田的捕食性天敌数量显著高于化防田。

The "regulable osteoinduction microcirculation/microenvironment system in vivo" has characteristics as follows: the culture conditions are controlled. For example, the release of a variety of growth factors can be controlled stably and quantitatively at bone defect site. Early nutrition and revascularization in the center of tissue-engineered bone can be effectively solved; some shortcomings resulted from construction of tissue-engineered bone in vivo, including secondary injury, high level technical requirements, and complex operation, can be avoided; vascularization and osteogenesis can be constructed simultaneously; simple safe and efficient operation.

可调控的体内灌注诱导成骨微循环系统具有以下特点：可以控制诱导培养条件，如调控各种生长因子微量稳定的缓控释放；能有效解决大块组织工程骨中心部位的早期营养和血运重建难题；避免了组织工程骨体内构建存在的二次损伤，需要较高的技术条件、操作较为复杂等缺陷；实现血管化与成骨的同步构建；操作简便，安全高效。

Methods eighty patients with ish were randomized into therapeutic group and controlled group. controlled group received amlodipine 5 mg/d,indapamide 2.5 mg/d; therapeutic group received amlodipine 5 mg/d,indapamid 2.5 mg/d,combined with sustained release isosorbide 5 mononitrate 40 mg/d for 4 weeks.

80例ish患者随机分为对照组39例和治疗组41例，对照组给予氨氯地平5 mg，吲达帕安2.5 mg每日1次口服，治疗组在上述治疗的基础上给予5-单硝异山梨酯缓释剂40 mg每日1次口服，疗程4周。

For the aim of saving energy and optimizing control of chilled systems, the performance of VWV systems and characteristics of control systems were analyzed based on the simulation. According to the characteristic of the monitored parameters and controlled variables in VWV systems, three online optimal control strategies were proposed and validated:(1) Optimal strategy for on/off control of chillers according to the ratio of secondary flow rate to primary flow rate.(2) Optimal strategy for the control of secondary pump according to value positions of auto-controlled AHU vales. And (3) Optimal strategy for supply chilled water temperature control of chillers according to valve positions of auto-controlled AHU valves and working status of secondary pump.

为达到节能和优化系统控制的目的，在楼宇空调水系统及其局部控制仿真分析的基础上，针对变流量系统监测点和可调参数较多的特点，提出并验证了3个实时优化控制方案：根据初级和二级冷谋水流量的比率，实时优化多台冷水机组的启／停控制；利用AHU自动控制水阀的阀位信息，实时优化二级水泵的控制；利用AHU自动控制水阀的阀位信息以及二级泵的工作状况，实时优化冷水机组出水温度的控制。

Products and Service: DN series data-controlled alternating current projectiong welder ZDN data-controlled commutate spot welder UN data-controlled commutate spot welder DKR\DR capacitance energy storing spot welder FN alternationg and ZFNcommutate sewing welder DM direct current pulse spot welder seam welding machine of protectiong by gas for recti or cirol seam varity of special seam welding machine for poine stich AND DKR-350 capacitance energy storing spot welder has been certified whit national patent and DTN-100/DTN-150 has been honored with technology innovation award.

现主要产品有： DN系列数控交流式点凸焊机。 ZD数控次级整流式点焊机。 UN数控交流对焊机。 DKR、DR电容贮能式点焊机。 FN交流式和ZFN次级整流式缝焊机。 DM直流脉冲式电焊机。直、环缝气体保护焊接专机。各类焊接生产线。其中： DKR-350电容贮能式点焊机获国家专利。

If you were not , and OS X just booted normally, have no fear.

如果你没有，和OS X刚刚启动通常，没有恐惧。

I only want to preserve our all .

我只想保存好我们的一切