查询词典 constant angular velocity

The lift-off angle of saltating sand grain follows LogNorm4 function distribution; lift-off horizontal velocity, vertical velocity and resultant velocity of saltating sand grain and falling angle and vertical velocity of saltating sand grain follow Gamma function distribution; falling horizontal velocity and resultant velocity of saltating sand grain follow Pearson IV function distribution.

跃移沙粒起跳、降落速度分布函数利用风洞实验获得的沙粒跃移运动的片断轨迹，反推出沙粒起跳角度服从LogNorm4函数分布，跃移沙粒起跳水平、垂直及合成速度均服从Gamma函数分布。

And the concept of angular dispersion of diffractive polar angle(the first kind angular dispersion) and angular dispersion of diffractive azimuthal angle (the second kind angular dispersion) are established.

确立了二维平面光栅衍射极角角色散和衍射方位角角色散的概念。

The effect of tribology factors on bearing vibration is studied experimentally. AR model and WPT are used to processing the normal arid abnormal signals. The results are as follows:1. The vibration of ball bearings is caused by the tribology action of contact pairs of ball and ring races and has the essential of tribo-dynamics. Any factors affecting the tribology characteristics of contact pairs will affect vibration and noise of bearings consequently.2. Vibration characteristics of bearing keep almostly unchanged with the increasing of axial load expecting the increasing of nature frequencies. When radial load increasing with axial load unchanged, nature frequencies keep unchanged but some new vibration peaks appears in the spectrum.3. Vibration amplitudes are damped and nature frequency are enhanced with sufficient lubrication. Vibration and noise of bearings increase obviously and roar can happen and the contact surfaces scratch slightly under insufficient and unclean lubrication state. Bearing will be disabled in a few minutes without any lubrication.4. Bearing vibration is unstable under low speed. With the speed increasing, the vibration become stable and natural frequencies increase slightly but the amplitudes increase apparently.5. Bearing vibration can be excited only by some harmonics ofwaviness without lubrication and by all harmonics with lubrication based on the theoretical analysis.6. The nature frequencies of ball bearings decrease with the increasing sizes. When international clearance increasing, nature frequencies decrease in radial and increase in axial and angular and the amplitudes increase in radial and decrease in axial and angular. When the number of balls increasing, nature frequencies increase and amplitudes decrease. When the pitch diameter increasing, axial nature frequency increase and others nearly keep no change. When outer race groove curvature radius increasing, nature frequencies increase in radial and decrease in axial and angular and amplitudes keep no change in radial and increase in axial and angular. When inner race groove curvature radius increasing, nature frequencies decrease and amplitudes increase.7. The distortion in amplitude and frequency components of bearing vibration signals picked up by the present probe measurement method is founded and right conclusions cannot be achieved by the signals. When accelerometer is rigidly screwed with steel stud onto a flat outer surface of a ball bearing, vibration signal can be got without distortion and the reliability of research on bearing vibration is assured.8. AR model is suitable for large samples of bearing vibration signals, square root of length of samples can be used as the upper limitation of order determination and the FPE order selection criterion is effective. Many advantages of AR spectrum are founded over the classical based on FFT.9. Time-Frequency analysis is necessary for abnormal noise of ball bearings. WPT overcomes the principle shortcomings of STFT and proved to be a best tool to process the abnormal signals.

理论分析和试验研究表明： 1球轴承振动是钢球—滚道接触副中的各种摩擦学作用引起的，具有摩擦动力学的本质，任何对接触副的摩擦学特性有影响的因素都将对球轴承的振动和噪声特性产生影响； 2中心轴向载荷作用下，载荷增大使球轴承的固有振动频率升高，载荷越大同样的载荷增幅引起的频率升幅减小，足够大的中心轴向载荷作用下载荷的变化对球轴承振动的频率特性不会产生明显的影响； 3轴向和径向联合载荷作用下，径向载荷不大时球轴承振动的固有频率基本不变，但是可能引起变刚度激励的非线性振动，出现新的频峰，过大的径向载荷将使部分钢球脱离接触，使球轴承的振动和噪声呈现不稳定状态； 4润滑对球轴承的振动和噪声特性有重要的影响，良好的润滑对振动有明显的抑制作用，润滑不充分时，振动和噪声的水平会有明显增高，一定条件下还会激发接触副中的谐振，发出啸声，造成接触表面的伤害，无润滑干接触时，短时的运转就会损伤接触副表面，使振动和噪声迅速增大，并随时可能引发严重的磨损和卡滞失效；接触副润滑良好时，油膜的"刚化效应"使球轴承振动的固有频率有所提高，润滑剂中含有弥散性污浊时，振动的幅度总体升高，但弥散性污浊不会改变球轴承振动的频率特性；浙江大学博士学位论文：球轴承振动的研究 5低速时，球轴承振动的基本特征呈现不稳定状态，随着转速的提高，球轴承振动的频率特性趋于稳定，固有频率频峰升高； 6理论分析表明，干接触时钢球和滚道表面波纹度的某些谐波分量能激励球轴承的振动，振动的幅值与谐波幅值成正比，实际球轴承中钢球的分布不可能完全均匀，波纹度的激励作用会随时发生；润滑接触的分析表明，波纹度的任意谐波分量均能激励球轴承的振动； 7球轴承的几何和结构参数分析表明，球轴承尺寸越大，径向、轴向和角振动的固有频率越低；钢球中心圆直径增大，球轴承的径向和轴向振动的固有频率基本不变，角振动的固有频率有所上升，振动的幅频特性基本不变；径向游隙加大使球轴承的径向振动固有频率降低，轴向和角振动的固有频率有所升高，径向振动幅频特性的幅值升高，而轴向和角向降低；钢球的数量增多使球轴承振动的固有频率上升，幅频特性的幅值下降，径向振动的幅值下降最为明显；外圈沟曲率半径系数增大使球轴承径向振动的固有频率升高，轴向和角振动的固有频率降低，径向幅频特性基本不变，轴向和角向幅频特性幅值升高；内圈沟曲率半径系数增大使径向、轴向和角振动固有频率均下降，振动幅频特性的幅值均有升高； 8试验对比表明，传感器采用探针式安装时，由于探针接触副接触特性的影响，钡(量得到的球轴承振动信号有失真，采用专门设计和制作的试验球轴承，以固定式安装加速度计，首次测量得到了球轴承振动的真实信号，通过对振动信号的分析，验证了球轴承振动的理论模型； 9)基于时间序列分析的AR模型适用于大样本球轴承振动信号的分析，以样本长度的均方根值作定阶上界，FPE做判阶准则，给出的AR谱光滑，频率分辨率高，是球轴承振动分析的简便而可靠的手段； 10以时频域分析的小波包变换分析球轴承异音信号能够比较好地定位和聚焦异音发生的时间，时间间隔，频率范围，同样是球轴承振动分析的可靠的手段，可用作球轴承故障诊断技术。

The experimental results show that:(1) for ideal spheres, the attenuation coefficient of velocity is constant, the air drag coefficient is slightly affected by the initial velocity and is a linear function of initial velocity, and (2) for real fragments formed by a warhead, the flight performances are different from ideal spheres, the air drag coefficient is affected by the flight velocity and is a linear function of flight velocity.

实验结果表明：(1)对于理想球形钨合金破片，在同一初始速度条件下，衰减系数为常数，空气阻力系数与初始速度有关，两者成线性关系；(2)对于经历爆轰驱动的球形钨合金破片，由于有轻微的质量损失和变形，速度衰减规律与理想球形钨合金破片有明显的区别，空气阻力系数与飞行速度有关，两者成线性关系。

When gas superficial velocity was about equal to liquid superficial velocity, the probability density function of liquid holdup had a twin-peaked, when liquid superficial velocity was constant, one of the peaks would fade out and disappear with the in crease of gas superficial velocity. Through using the characteristics, the relative size of gas and liquid superficial velocity can be set initially.

在段塞流动中，当气相折算速度和液相折算速度相差不大时，持液率概率密度函数呈双峰分布；当液相折算速度不变时，随着气相折算速度的增大，持液率概率密度函数第2峰值逐渐减小，直至消失而变为单峰分布；利用这一特征可初步确定段塞流动中气、液相流量相对大小。

The results indicate that in the synchronizing condition the MRF is unyielded, every point of MRF in the flow field has the same angular velocity. Under the slipping condition, with the increase of magnetic field or the decrease of slip speed, MRF may transfer from whole yield to partial yield. When the MRF wholly yields, the angular velocity of MRF increases nonlinearly with its radius, the non-linear distribution becomes more obvious as the magnetic intensity in the working gap increases. When the MRF partially yields, the yield region expands with the decrease of magnetic intensity or the increase of slip speed and the unyield region always reaches the driven rotor. The transfer torque of MRTD increases with the increase of the external magnetic field, but the transfer torque maintains a constant value approximately with the variation of slip speed at the same magnetic intensity.

研究结果表明，在同步工况下，传动装置流场中磁流变液未屈服，各点角速度相同；在滑差工况下，随外加磁场的增大和滑差转速的减小，磁流变液逐渐从完全屈服向部分屈服转变；磁流变液完全屈服时，磁流变液角速度随半径呈非线性增加，工作间隙中磁场越强，流场的非线性分布越明显；磁流变液部分屈服时屈服区域随外加磁场的增大而减小，随滑差转速的增大而增大，未屈服区与主动转子相连；稳态下磁流变传动装置传递的转矩随外加磁场的增加而近似呈线性增大，但在相同外加磁场下，传递转矩基本不随滑差转速改变而改变，表现出良好的恒转矩特性。

B Angular momentum is a vector quantity as are also angular velocity, angular acceleration and torque.

角动量是个矢量，角速度和角加速和转矩也都是矢量。

Angular momentum is a vector quantity as are also angular velocity, angular acceleration and torque.

角动量是个矢量，角速度和角加速和转矩也都是矢量。

The positions of cam and dial were analyzed accompanied with their angular position, angular velocity and angular acceleration.

分析了凸轮和转盘的位置、角速度、角加速度的变化规律，给出了直角式精密分度凸轮的设计算法，同时计算了数控加工的刀位轨迹，并给出了四坐标联动数控加工和编程方法。

First, a program which can be used to obtain the encoder values of each joint D. C. servomotor and then change them into angular position is developed. By means of cubic spline, the angular velocity and angular acceleration are calculated.

本文开发了实时采集和转换机器人各关节的码盘值为角位移的程序，并提出了以三次样条函数求各关节角速度和角加速度的方法，提高了计算精度。

Objective:To compare the response control and attention of Schizophrenic patients with that of the healthy controls by Integrated Visual and Auditorycontinuous performance test. To quantitate the impairment of cognitive function in patients, and to explore the relationship between cognitive function and the severity of the disorder.

目的：探讨精神分裂症病人在IVA持续操作测试中的反应控制能力、注意力等，并与健康人进行比较，从而量化精神分裂症病人的认知功能损害，并进一步探讨其认知功能与疾病严重程度的关系。

Main effective factors including subcooling degree, mechanical vibration, gas hydrate reformation, environment temperature, noncondensing gas and surfactant are analyzed.

指出过冷度、机械振动、重复生成水合物、环境温度、不凝性气体、添加剂是影响气体水合物生成的主要因素，还对R152a水合物的放冷进行了实验研究。